Xerox DOCUPRINT 92C, DOCUPRINT 4850 User Manual
Product range/positioning
The Xerox DocuPrint 4850/4890/92C NPS/IPS isa highlight color
printing system, fully compatible with the IBM AFP Group 3 page
printer with the Advanced Function Imageand Graphics (AFIG)option.
The targeted impressionsper month are asfollows:
• DocuPrint 4850 NPS/IPS: 100-750K
• DocuPrint 4890/92C NPS/IPS: 250K-1.3 million
Usage outsidethis range may vary the service frequency.
Speed
Data can be printed at rates up to 92 pages per minute. Throughput
rate can vary depending upon job complexity and system configuration.
Resolution
DocuPrint 4850/4890 NPS/IPS: 300 by 300 spots per inch (spi)
DocuPrint 92C NPS/IPS: 600 by 600 spots per inch (spi)
Paper handling
• 20 lb. (80 gsm) bond to 110 lb. (200 gsm) index cut-sheet weights
• Paper sizes: 8 by 10 in. (203 by 254 mm) to
8.5 by 14 in. (216 by 356 mm), including A4
Input:
• Main Tray (Tray 1): 1000 sheet capacity of 20 lb. (80 gsm) bond
paper
• Auxiliary Tray (Tray 2): 500 sheet capacity of 20 lb. (80 gsm) bond
paper
• High Capacity Feeder (Optional): Two additional 1000 sheet
20 lb. (80 gsm) bond input feeders
Output:
• Dual Stacker: Each tray holds 750 sheets of 20 lb. (80 gsm) bond
with offset capability
• Sample Tray: 100 sheets of 20 lb. (80 gsm) bond
• Stitcher/Stacker: 2000 sheets of 20 lb. (80 gsm) bond, up to 50
sheets stitched, offset capability.Capacity may vary depending
on the number of sheets stitched per set.
System control module
(High performance Sun workstation)
The NPS/IPS printing system comes with the Sun Blade 1000 or the
Sun Ultra 60 workstation.
Note: This configuration may change due to Xerox policy of staying
abreast of current technology.
• Processor (system unit) containing:
• Two UltraSPARC III 750 Mhz central processing unit (CPU)
modules (Sun Blade 1000) or 450 MHz CPU module (Sun
Ultra 60)
• 4 GB memory(four 1 GB DIMMs)
• 36 GB hard disk drive
• DVD-ROM drive
• 3.5inchdiskettedrive
• Keyboard and mouse
• 18-inch monitor (Sun Blade 1000) or 21-inch moitor (Sun Ultra
60)
• Optional Token Ring baord (Sun Blade 1000)
• Two Printer Controller Interface (PCI) boards installed in the
processor to interface with the print engine. (Sun Blade 1000)
Printer module
• No throughput degradation for highlight color printing
• Simultaneous exposure of both black and color images for
excellent registration
• Black dry ink (permanent) plus one color Customer Changeable
Unit (CCU) which will be either Red, Blue, Green, Cyan,
Magenta, Cardinal, Royal, Ruby, Violet, or Brown
• Operator attention light
PSF environment
The system operates in the following PSF environments:
• MVS
• VM (channel-attached only)
• VSE (channel-attached only)
• OS/2
• AS/400 (with TCP/IP only)
• AIX
PDL compatibility
The system interprets the following text formats:
• PostScript level 1
• PostScript level 2
• PCL5c
• PCL5e
• ASCII
Space requirements
Controller:
Note: The following is presented as an example of typical space
requirements for Sun workstations.
Space requirements for the printer controller are 36 by 36 inches/
91 by 91 cm.
• Processor (Sun Blade 1000)
– 25 in. deep by 10 in. wide by 17.75 in. high
(63.5 cm by 25.4 cm by 45.1 cm)
• Processor (Sun Ultra 60)
– 17.5 in. deep by 17.5 in. wide by 5 in. high
(44.5 cm by 44.5 cm by 12.7 cm)
• Monitor(Sun Blade 1000)
– 10 in. deep by 17.5 in. wide by 18.5 in. high
(25.4 cm by 44.5 cm by 47 cm)
• Monitor(Sun Ultra 60)
– 21 in. deep by 19 in. wide by 21 in. high
(53.3 cm by 48.3 cm by 53.3 cm)
• 4 mm DAT SCSI tape drive (optional)
– 12.25 in.deep by 7.5 in. wide by 2.75 in. high
(31cmby19cmby7cm)
• Keyboard
– 7.5 in. deep by 20 in. wide
(19.1 cm by 50.8 cm)
• HCU (for a channel-attached system)
– 15 in. deep by 16 in. wide by 5 in. high
(40.8 cm by 41.6 cm by 12.6 cm)
• Channel interface board and channel cable connector box (for
channel-attached systems)
– 9.7 in. deep by 27.1 in. wide
(24.6 cm by 68.8 cm)
Printer:
Space requirements (physical hardware and required service area)
for each of the printer configurations are:
• DocuPrint 4850/4890/92C printer with dual stacker
– 164 in. by 106.5 in. (417 cm by 271 cm)
• DocuPrint 4850/4890/92C printer with stitcher/stacker
– 162 in. by 106.5 in. (411cm by 271 cm)
• DocuPrint 4850/4890/92C printer with high-capacity feeder and
dual stacker
– 186 in. by 106.5 in. (473 cm by 271 cm)
• DocuPrint 4850/4890/92C printer with high-capacity feeder and
stitcher/stacker
– 184 in. by 106.5 in. (467 cm by 271 cm)
Note: Additional space (6 in. by 64 in. / 15 cm by 163 cm) is required
in front of the printer for CCU cart operability.
Foradditionalspace/configurationoptions,refertothe Xerox DocuPrint
4850/4890/92C NPS/IPS Installation Planning Guide (Pub
#721P90090).
System connections
Oneof thefollowingnetwork communications systems may be used to
transport documents from the client workstation to the printer:
• Ethernet LAN running TCP/IP, AppleTalk, or Novell NetWare
network protocol software.
• Token Ring running TCP/IP or AppleTalk network protocol
software
• Bus and tag channel connection, using the Host Channel Unit
(HCU) or the PCI board and control unit
• FibreDistributed Data Interface(FDDI) running TCP/IP, Novell
3.x, or AppleTalk network protocols (available only with the
Solaris 2.x environment). The FDDI supports a Single Connection
configuration only.
Note: DocuPrint does not support multiple network interfaces
simultaneously.
Special considerations
• Color ton er detection by Optical Character Recognition (OCR)
scanners is wavelength dependent.
• Appearance of a very small, white transition region between solid
color and solid black images is common to tri-level xerographic
printing.
• Transference of the black toner to poly-vinyl surfaces is a
common occurrence; color toner does not transfer.
• Print quality is guaranteed to a range of three to four millimeters
for edge marking and six millimeters for text printing to the edge
of the page.
• Xerox carbonless paper is approved forDocuPrint 4890/92C only.
Refer to the Xerox Supplies Catalog for the reorder numbers.
• Appearance of very small spots is a common occurrence on all
xerographic printers. Consult your Xerox service representative
for details on acceptable spot occurrence specifications.
Environmental requirements
• Operating temperature:
– Recommended: 72
– Min./Max.: 60
o
+/- 4oF(22o+/- 2oC)
o
to 80oF (15.5oto 26.7oC)
• Humidity:
– Recommended: 45% +/- 10% RH
– Min./Max.: 30% to 65% RH
• Heat Dissipation (System Control Module): Max. 1,100 BTU/hour
• Heat Dissipation (Printer Module):
– Standby mode (50/60 Hz): Max 9,100 BTU/hour
– Operating mode (50/60 Hz): Max 14,980 BTU/hour
Electrical requirements
• System Control Module/HCU or PCI board (60 Hz):
– 115 or 220 VAC
– 15 amp service (for 115 VAC, NEMA 5-15R or
ANSI C73, 11R)
–0.8KVArating
• System Control Module/HCU or PCI board (50 Hz):
– 100-240 VAC+/- 10%
– 15 amp service
(power connection per local codes/regulations)
–0.8KVArating
• Printer Module (60 Hz):
– 120/208 or 120/240 VAC
– 30 amp service (NEMA 14-30R)
– 5.5 KVA rating (Operating mode)
• Printer Module (50 Hz):
– 220, 230, 240 VAC
– 30 amp service
(power connection per local codes/regulations)
– 5.5 KVA rating (Operating mode)
Supplies
Expected
Xerox Color Reorder
Dry Ink, Black 6R296 6R90193 6 180,000
Dry Ink, Red 6R297 6R90194 3 270,000
Dry Ink, Blue 6R754 6R90225 3 270,000
Dry Ink, Green 6R299 6R90196 3 270,000
Dry Ink, Cyan 6R755 6R90226 3 270,000
Dry Ink, Magenta 6R816 6R90227 3 270,000
Dry Ink, Royal 6R826 6R90232 3 270,000
Dry Ink, Cardinal 6R825 6R90231 3 270,000
Dry Ink, Violet 6R828 6R90243 3 270,000
Dry Ink, Ruby 6R827 6R90242 3 270,000
Dry Ink, Brown 6R842 6R90245 3 270,000
Fuser Lubricant 8R983 8R983 2 Tubes 240,000
Stitcher Wire 8R1174 8R1174 1 Reel 32,000
Notes:
• Expected dry ink yield is based on a 5% black and 1.5% color
area coverage. This yieldwill vary depending on area coverage of
the application and darkness settings of the printer.
• Use only dry ink that is specified for use in the DocuPrint 4850/
4890/92C printer even when printing non-colored jobs.
• Purchase of colored dry ink is required to operate your DocuPrint
4850/4890/92C NPS/IPS highlight color system.
A small amount of colored dry ink is consumed even when
printing non-colored jobs, except in the Black Executive mode.
For further information on this topic, consult your local Xerox
service representative.
#(US)
Reorder
#(XE)
Cartridges
per Carton
Yield
(Prints/
Carton)
Staples
Referencematerial
• Refer to the Helpful Facts About Paper to help in selection of
preprinted forms, perforated stock and labels.
• Refer to the Highlight Color in Business Documents -- a Practical
Guide for information on how to leverage the business benefits of
HLC documents.
XEROX
Xerox DocuPrint
4850/4890/92C NPS/IPS
Customer Information
Quick Reference Card
The Xerox DocuPrint 4850/4890/92C NP S/ IPS is a highlight
color printing system.
2002 by Xerox Corporation. A ll rights reserved.
October 2002
721P90000
Loading...