Whirlpool ED5PBAXVQ00, ED5PBAXVY00, GS6NVEXVS00, GS6NVEXVQ00, GS6NVEXVL00 Installation Guide

Instruction Sheet

for Handle Kit

Kit Contains:

2 Handles

4 Shoulder Screws

1 Instruction Sheet

1.Remove handles from doors by lifting directly upward.

NOTE: Some products may have handles mounted with set screws. You will need to loosen the set screws with a hex wrench.

2.Remove the mounting screws from the doors.

NOTE: Some products may have mounting brackets. You will need to remove them as well.

3.Secure the four (4) shoulder screws from the handle kit into the existing holes in the refrigerator and freezer doors using a Phillips screwdriver.

4.Position the handle above the shoulder screws mounted on the door. See Figure 1.

5.Apply firm pressure on the handle to slide it down onto the shoulder screws.

NOTE: Do not push the handle toward the door, this can damage the door. Only apply pressure downward.

6.Repeat steps 4 and 5 to install the freezer door handle.

figure 1

© Whirlpool Corporation 2016	— 1 —	Instruction Sheet W11036888 Rev A 10/16
(All Rights Reserved)