Before using the dishwasher, read the installation and maintenance instructions carefully!
GB ADG 7780
1. OVERVIEW
On button
Off button
Delayed start button
Press the button repeatedly to delay the start of the programme by 3, 6 or 9 hours. Then press the START button. The dishwasher will start at the set time.
Programme selection button
Press the button repeatedly until the desired programme indicator lights up.
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in chapter 5 “What to do, in the event of...”.
Table 1.1.
|
|
|
|
|
|
Programme chart |
|
Detergent |
Consumption 1) |
|
|||||
|
|
|
|
|
|
|
dispenser |
|
|||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
P |
|
|
|
|
|
Programmes |
|
Available |
Loading instructions |
large |
small |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
options |
|||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
|
|
|
|
|
Auto Sensor |
50-65°C |
|
Recommended programme for |
|
|
|
|
|
|
|
|
|
|
|
|
routine washes, with dried-on |
X |
X |
11-16 |
1.10-1.50 |
100-130 |
||||
|
|
|
|
|
|
|
|
|
food (e.g. EN 50242). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 |
|
|
|
|
|
Rapid |
40°C |
|
Lightly soiled crockery, with no |
X |
— |
10.0 |
0.65 |
30+/- |
1) |
|
|
|
|
|
|
||||||||||
|
|
|
|
|
|
|
|
|
dried-on food. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3 |
|
|
|
|
|
Eco 2) |
50°C |
|
Normally soiled crockery. |
X |
X |
14.0 |
1.05 |
195+/- |
1) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4 |
|
|
|
|
|
Intensive |
70°C |
|
Recommended programme for |
|
|
|
|
|
1) |
|
|
|
|
|
|
heavily soiled crockery, especially |
X |
X |
14.0 |
1.55 |
155+/- |
||||
|
|
|
|
|
|
|
|
|
suitable for pans and saucepans. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Recommended programme for |
|
|
|
|
|
|
5 |
|
|
|
|
|
Power Clean |
70°C |
|
heavily soiled crockery, especially |
X |
X |
16.0 |
1.80 |
220+/- |
1) |
|
|
|
|
|
|
suitable for pans and saucepans. |
|||||||||
|
|
|
|
|
|
|
|
|
Intensive wash with additional |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
water jets. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g. different loads, options, different sensor settings (only with sensor programmes), different water supply temperatures, as well as water hardness and power supply voltage.
2)Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Whirlpool is a registered trademark of Whirlpool USA |
5019 396 01078 |
1
2. QUICK REFERENCE GUIDE
Detailed instructions are given in the following pages, see also chapter “5. What to do if...”
1.Switch on the appliance
2.Select a programme
3.Select the type of detergent
4.Fill in the detergent
Open the dishwasher door.
Press the ON button.
Press the button |
or to bring up the desired programme on the display. |
Select options, if available.
The detergent selection procedure varies depending on the dishwasher model. Chapter “1. Overview” provides instructions for selecting detergent type.
4a. Powder/gel/tabs |
|
|
|
Fill the detergent dispenser compartments in |
A B C |
||
accordance with the wash programme selected. |
|||
Large compartment A for every wash cycle, additional |
|
|
|
|
|
|
|
small compartment B for programmes with pre-wash |
|
|
|
(see table 1.1.). |
|
|
|
4b. Combined action detergents (2 in 1/3 in 1/... etc.) |
|
|
|
Place the detergent in compartment A or in the cutlery |
|
|
|
basket, as per the manufacturer's recommendations. |
|
|
|
5.Check the rinse aid level
6.Check the salt level
7. Load the racks
Visual indicator in dispenser C
dark |
|
sufficient rinse aid present, |
clear |
|
add rinse aid (approx. 100 ml). |
The indicator lamp on the control panel lights up when rinse aid needs to be added. Not all models are equipped with such an indicator.
Depending on the model:
window in salt reservoir cap on bottom of appliance inside
orange |
|
when sufficient salt is present, |
clear |
|
when salt needs to be added. |
The indicator lamp on the control panel lights up when salt needs to be added. Even once salt has been added, the indicator lamp only switches off after several wash cycles!
Make sure that the spray arms can turn freely and are not impeded by crockery or cutlery in the racks.
Detailed instructions on loading the racks are given in chapter “3. How to use the appliance”, under “How to load the racks”.
8.Start the appliance
9.Turn on the water tap and close the dishwasher door
Wash cycle
Press the START button.
When the door is closed the dishwasher starts automatically.
If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Care must be taken when opening the door, as steam will escape!
Change the programme in progress:
-Press the START button for about 2 sec., until the START indicator lamp switches off.
-Close the door.
-(Water drains for up to 60 seconds).
-Open the door.
-Select a new programme.
-Press the START button.
10.End of programme
11.Open the door, switch off the appliance
12. Turn off the water tap, unload the racks
At the end of the programme an acoustic signal will sound. The START indicator lamp switches off.
Press the OFF button. All the indicator lamps switch off.
Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
2
3. HOW TO USE THE APPLIANCE
PROGRAMME SELECTION
Press the button |
or to bring up the desired programme on the display. The appliance must be switched |
on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate programmes and relative available options are detailed in table 1.1 on page 1.
Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance's automatic calibration system.
HOW TO FILL THE DETERGENT DISPENSER
Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer's recommended dosage. Observe the manufacturer's safety warnings!
Open the detergent dispenser compartments by pushing the left lever (lever 1) of the dispenser. a. Powder/gel/tabs
Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).
Programmes without pre-wash:
pour the entire recommended dosage into compartment A. Programmes with pre-wash:
pour 2/3 of the recommended dosage into the large compartment A and 1/3 into the small compartment B.
Dishwasher tabs should be placed, according to the manufacturer's recommendations, in compartment A or in the cutlery basket.
If the “Half load” option is selected, detergent dosage should be reduced by approximately 1/3.
b. Combined action detergents (2 in 1/3 in 1/... etc.)
Combined action detergents should be placed, according to the manufacturer's recommendations, in compartment A or in the cutlery basket.
Firmly press the detergent compartment lid shut after filling.
Lever 1 
Large Small
compartment A compartment B
Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend to form excess suds.
The guarantee is not applicable if faults are caused by the use of these products.
HOW TO CHECK/FILL/ADJUST RINSE AID
Not necessary when using a combined action detergent.
a. How to check the rinse aid level
Check the visual indicator C on the rinse aid dispenser: dark = sufficient rinse aid, clear = add rinse aid.
In the case of appliances with an electric indicator on the |
Lever 2 |
Indicator C |
||||
control panel, the rinse aid indicator lamp |
lights up red |
|||||
|
|
|
|
|||
when rinse aid needs to be added. |
|
|
|
|
|
|
|
|
|
|
|
||
b. How to fill the rinse aid dispenser
Open the rinse aid dispenser by pressing the right lever (lever 2) of the dispenser.
Fill the dispenser with rinse aid up to the “max” line |
max |
|
(approx. 100 ml). |
||
|
||
Shut the lid again. |
|
Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.
3
Loading...