Whirlpool ADG 7470 User Manual

0 (0)

Quick reference guide

Chart

BUTTON

PROGRAMME SELECTION BUTTON

Press button “P” (repeatedly) until the indicator of the required programme lights up (see “Table of programmes” below).

OFF

BUTTON

START BUTTON

The indicator lights up during operation, flashes when a fault occurs and goes off at the end of the programme.

START BUTTON RESET FUNCTION

Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in chapter “What to do if...”.

Table of programmes

Programmes Loading instructions

Pre-Wash cold

Quickwash 40°C

Eco

Crockery to be washed later. — 5.0 0.02 10

Lightly soiled crockery, with no dried-on food.

* Use of tablets

not recommended.

Normally soiled crockery.

50°C

Energy-saving programme.

Deter-

gent

Litres kWh

Minutes

X*13.0 0.70 30

X 15.0 1.05 165

Consumption

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! THE GUARANTEE IS NOT APPLICABLE IF FAULTS ARE CAUSED BY INCORRECT USE OF THE APPLIANCE.

Recommended programme for

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in complian ce with EN 50242 regul ations. - No te for Testing Institutes: fo detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Intensive 70°C

heavily soiled crockery, especially suitable for pots and pans.

X 17.0 1.65 145

5019 396 01787ADG 7470

-1-

How to set detergent type: powder/gel/tablet (if option is available)

First time use

In order to always ensure the best cleaning results, you NEED to set: DETERGENT type and WATER HARDNESS.

1- salt reservoir 2- rinse aid dispenser 3- detergent dispenser 4- racks system 5,6,7,8- available functions on the panel 9- filters 10- spray arms

Select 3rd programme (see Table of programmes

- page 1)

Press START button for 7 seconds

3a.

Check your detergent type...

Detergent

Powder or gel

(factory setting)

Tablet 2 in 1

Tablet 3 in 1

Tablet All in 1

For models without “detergent type” option, the salt and rinse aid indicators will be lit when tablets are used.

How to set water hardness

Switch on the appliance

before the first wash

only

water hardness has been changed

Ask your water supply company what

water hardness

the

English

degrees °eH

0 - 6.3 Soft 1 1x

7 - 12.6 Medium 2 2x

13.3 - 18.9 Average 3 3x

19.6 - 25.9 Medium-hard 4 4x

26.6 - 35 Hard 5 5x

35.7 - 44.1 Very hard 6 6x

44.8 - 74.9 Extremely hard 7 7x

is...

or if the

Water

hardness

- Select the 2nd programme “P2” - consult the table of programmes.

- Press the START button for at least 5 seconds until the START indicator lamp flashes.

- The water hardness setting is shown on the display (if present) or the START button flashes.

- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.

- The appliance must be switched off to memorise the new setting.

...enter this value on your dishwasher

Dishwasher with

display: insert value

in the display

types

Dishwasher without

display: count

START button led

flashes

3b.

...and set it on your dishwasher

using the START button

(as per table below)

Dishwasher models

model without

display

3h 6h 9h

Gel or Powder

(rinse aid and salt)

(see “Daily check”)

model with display

Suggestions for detergent use

go to step 1

Remember to use salt and rinse aid when needed (as indicated below)

no symbol add salt add rinse aid

add salt

salt

Tablets

Water hardness level is factory set for medium hard water (a number “4” is shown on the display or the START indicator lamp flashes 4 times).

if extra salt is

needed go to step 1

(see “Daily check”)

Even if you use tablets which include salt, you must still add salt since such detergents are not effective enough at softening hard water.

rinse aid

Switch off and switch on again to save setting

-2-

Filling the salt reservoir -

Dissolve limescale (not necessary if water hardness level is set to “soft”!)

Daily check

The salt level indicator lamp may remain lit for the duration of several wash cycles. If the water hardness level falls within category (soft),

Adding rinse aid

(not necessary when you use tablets). How to adjust the rinse aid dosage regulator

Rinse aid indicator (depending on model)

Only use rinse aids recommended for use in domestic dishwashers. If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is not perfectly d ry : incr e a s e the dosage by turning the dial to a higher setting (5-6). Plastic dishes have more difficulty drying and a higher rinse aid

setting will not improve the situation. Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend

to form excess suds.

Adding detergent -

Visual indicator (depending on model). Unscrew cap.

Visual indicator

If required, open the cover B (press right button).

salt is required.

The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.

Immediately

Fill the salt reservoir with water before the first wash only.

Salt indicator

(depending on

the model)

Add rinse aid to the max. line ~150 ml

wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.

The indicator lamp on the control panel lights up when SALT NEEDS TO BE ADDED.

Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations

Tablet / gel / powder

Use only one tablet per one

Open the cover A (press left button).

Only fill the detergent dispenser prior to starting a wash programme.

cycle, only placed in detergent dispenser.

All types of tablets can be used, but for 2 in 1 type adding of salt is mandatory.

Add salt

(never add detergent!). min. 1.5 kg

max. 2 kg

orange: OK. clear: NEEDS TO BE ADDED

The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B. Using a coin or similar object, turn the arrow to the desired setting. After adjusting the rinse aid setting, shut the cover again.

dark: OK. clear: NEEDS TO BE ADDED

By pressing dedicated ribs shut the cover.

Visual indicator (depending on model). Screw on the cap. Salt residues around cap need to be removed.

Daily use

-3-

+ 5 hidden pages