VTech CS6509, CS6509-19, CS6509-17, CS6509-16, CS6509-15 User Manual
User’s manual
T
Compatible with
Hearing Aid T-Coil
CS6509/CS6509-14/
CS6509-15/CS6509-16/
CS6509-17/CS6509-19
DECT 6.0 accessory handset
for use with VTech models
CS6519/CS6529
Congratulations
on purchasing your new VTech product. Before using this telephone, please read
Important safety instructions on page 5 of this manual.
This manual has instructions on how to set up and register your new handset.
For complete instructions on using the handset, see the Abridged user’s manual
that came with your telephone base.
Please refer to the User’s manual for a full set of installation and operation
instructions at www.vtechphones.com.
Telephones identified with this logo have reduced noise and
interference when used with most T-coil equipped hearing
aids and cochlear implants. The TIA-1083 Compliant Logo is
a trademark of the Telecommunications Industry Association.
Used under license.
The ENERGY STAR® program (www.energystar.gov) recognizes
and encourages the use of products that save energy and help
protect our environment. We are proud to mark this product with
the ENERGY STAR® label indicating it meets the latest energy
efficiency guidelines.
Register online to get an additional 3-month warranty!
Visit www.vtechphones.com.
Registration
Register your product online for enhanced warranty support.
Product news
Learn about the latest VTech products.
BC
1
Parts checklist
Your telephone package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
Handset
Battery
Charger and
charger adapter
User’s manual
User’s manual
Battery installation
Install the battery as shown below.
Plug the battery connector
1.
securely into the socket.
Battery compartment
cover
Place the battery with the label
2.
THIS SIDE UP facing up and
the wires inside the battery
compartment.
Slide the battery compartment cover
3. Place the handset in the telephone
towards the center of the handset
4.
base or charger to charge.
until it clicks into place.
CHARGE
light remains
on when
charging.
If the handset will not be used for a long time, disconnect and remove the battery
•
to prevent possible leakage.
To purchase a replacement battery, visit our website at www.vtechphones.com or
•
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
2
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below).
For best performance, keep the handset in the telephone base or charger when
•
not in use.
The battery is fully charged after 11 hours of continuous charging.
•
If you place the handset in the telephone base or the charger without plugging
•
in the battery, the screen displays NO BATTERY.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.
When the battery is fully charged, you can expect the following performance:
Operation Operating time
While in handset use (talking*) Up to 7 hours
While in speakerphone mode (talking*) Up to 3.5 hours
While not in use (standby**) Up to 5 days
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.
The battery has no or very little
charge. The handset cannot
be used.
The battery has enough charge
to be used for a short time.
The battery is charged. To keep the battery charged,
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
place it in the telephone
base or charger when not
in use.
Add and register a handset
You can add new handsets (CS6509/CS6509-14/CS6509-15/CS6509-16/
CS6509-17/CS6509-19, purchased separately) to your telephone system. Each
handset must be registered with the telephone base before use. When first
purchased, each expansion handset displays To register HS and See manual
alternately. You may need to charge the handset before registering it to the
telephone base.
To register a handset:
Place the new (non-registered) handset in the telephone base.
1.
CS6519 base CS6529 base
Do not place the handset
in the charger.
2. After about 10 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you
hear a beep. The registration process takes about 90 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all the handsets and then individually
register each handset.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for about 10 seconds
1.
until the IN USE light on the telephone base turns on and starts to flash.
Immediately press FIND HANDSET again. You must press FIND HANDSET
2.
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets display To register HS and See manual alternately when the
3.
deregistration process completes. The deregistration process takes about
10 seconds to complete.
3
Loading...