TP-Link TL-WA5110G Quick Installation Guide
r
r
r
r
Note
Please use only wired network connections to configure the AP.
Turn off all your network devices,
including your computer(s), powe
injector and the AP.
Connect your computer to the
LAN port on the power injecto
with an Ethernet cable.
Plug the provided power adapte
into the DC jack on the powe
injector, and the other end to a
standard electrical wall socket.
Connect your AP to the PoE port
on the power injector with an
Ethernet cable.
The power adapter can be directly connected to the AP too. In this way
Note
you can connect your computer directly to the AP with an Ethernet cable.
1
Turn on all your network devices and then check to see if the LEDs on the AP
display normally as the diagram below describes.
Solid light
Flashing
Solid light or flashing
Flashing if the Wireless Radio
function is enabled
If the LEDs display abnormally, please check to see if all the cable connectors
Note
(power adapter and Ethernet cable) are well connected to your device.
You will need to assign your computer a Static IP address within the
Note
same range as the AP’s IP address. See the Troubleshooting T3 if you
need assistance.
Login
Open your web browser and
type in http://192.168.1.254
in the address bar and press
Enter
2
A
dialog box will prompt you for the
User name and Password. Enter
the default values and click OK.
User name: admin
Password: admin
Click OK
If the dialog box does not pop up, please refer to T3 in the Troubleshooting
Note
guide. T2 will give you some help if you forget the password.
The web management page will
display after successfully logging
in.
Click Quick Setup
Operation Mode Setting
This page will then display.
Click Next
Choose the Operation Mode
Type appropriate to your needs
Click Next
3
y y
A
r
A
The AP supports three operation mode types: AP Client Router,
Note
and AP.
a) If you want to connect to your WISP, please choose
Router mode and proceed to AǗ
b) If you want to configure a point to point connection, please skip to B;
c) If you want to configure a repeater, please skip to C.
P Route
P Client
A. Configuration for WISP Client (CPE)
After choosing the AP Client Router mode on the above page, this page will then
display.
Choose your WAN Connection
Type provided by your WISP.
Here we choose PPPoE as an
example
Click Next
Enter the Username and Password
given by your WISP
2
Click Next
Enter the SSID provided
b
our WISP
Click Next
Note
The Username and Password are provided by your WISP.
Click Finish to exit the Quick Setup
wizard and wait until the AP completes
rebooting automatically. The changes
will take effect after rebooting.
Click Finish
4
p
B. Configuration for Point to Point Connection
Note
Two TL-WA5110G Access Points are needed for this application.
1) The AP Setting
Select AP
Click Next
Enter a unique name for your
wireless network; however, choose a
name that is easily remembered by
network users. Here we enter
TP-LINK_88346E as the SSID for
exam
le
Select your region from the
drop-down list
Click Next
Click Finish to exit the Quick Setup
wizard and wait until the AP completes
rebooting automatically. The changes
will take effect after rebooting.
Click Finish
After successfully logging in, configure the other TL-WA5110G by following the steps
below.
2) The Client Setting
You should change the default LAN IP address of the Client from
Note
192.168.1.254 to 192.168.1.X (X can be any number from 1 to 253) to avoid
an IP conflict with the former AP. Here we choose 192.168.1.2 as an example.
5
Loading...