TP-Link LS105G, LS108G, LS1005G, LS1008G, TL-SF1005LP Wall Mounting Guide

Wall Mounting Guide

Wall Mountable Switches

1.1Wall Mounting Preparation

Before mounting the switch, you need to prepare the tools below: ǴǴ A screw driver.

ǴǴ Two screws which complies to the corresponding standard. For details, see Wall Mounting Specification.

1.2Wall Mounting Procedure

On the bottom of the panel, there are two mounting holes. You need to drive two screws into the wall, then mount the switch on the wall. Note that the switch should be mounted on the wall upright rather than sideways.

1)Determine the location on the wall where you want to mount the switch.

2)Mark the wall where the two mounting holes are. The distance between the two marks must be the same as that between the two mounting holes of the switch. For the wall- mounting-holes distance, see Wall Mounting Specification.

3)Drive the screws into the wall at the marks using the screw driver. For the Screw- Head-to-Wall Minimum Distance, see Wall Mounting Specification.

4)Mount the switch on the wall.

1.3Wall Mounting Specification

	Model	Screw Standard of	Minimum Length	Screw-Head-to-Wall	Wall-Mounting-Holes
		ANSI B1.1	of Screw	Minimum Distance	Distance
	LS105G	4#, (5#), 6#	7mm	1.5mm	76mm
	LS108G	4#, (5#), 6#	7mm	1.5mm	65mm
	LS1005G	4#, (5#), 6#	7mm	1.5mm	38mm
	LS1008G	4#, (5#), 6#	7mm	1.5mm	48mm
	TL-SF1005LP	4#, (5#), 6#, 8#	8.5mm	1.5mm	39mm
	TL-SF1005P	4#, (5#), 6#, 8#	8.5mm	1.5mm	39mm
	TL-SF1006P	4#, (5#), 6#, 8#	8.5mm	1.5mm	94mm
	TL-SF1008LP	4#, (5#), 6#, 8#	8.5mm	1.5mm	105mm
	TL-SF1008P	4#, (5#), 6#, 8#	8.5mm	1.5mm	105mm
	TL-SF1009P	4#, (5#), 6#, 8#	8.5mm	1.5mm	105mm
	TL-SF1016D	4#, (5#), 6#	8.5mm	1.5mm	157.2mm
	TL-SG1005LP	4#, (5#), 6#, 8#	8.5mm	1.5mm	39mm
	TL-SG1005P	4#, (5#), 6#, 8#	8.5mm	1.5mm	39mm
	TL-SG1008D	4#	8mm	2mm	100mm