TP-Link TL-SC2020 User Manual

TL-SC2020

Wired Network Camera

REV1.0.1

1910010670

Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2014 TP-LINK TECHNOLOGIES CO., LTD. All rights reserved.

http://www.tp-link.com

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

 Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України.

Safety Information

 When product has power button, the power button is one of the way to shut off the product;

when there is no power button, the only way to completely shut off power is to disconnect the product or the power adapter from the power source.

 Don’t disassemble the product, or make repairs yourself. You run the risk of electric shock and

voiding the limited warranty. If you need service, please contact us.

 Avoid water and wet locations.

This product can be used in the following countries:

AT BG BY CA CZ DE DK EE ES FI FR GB GR HU IE IT LT LV MT NL NO PL PT RO RU SE SK TR UA

TP-LINK TECHNOLOGIES CO., LTD

DECLARATION OF CONFORMITY

For the following equipment: Product Description: Wired Network Camera Model No.: TL-SC2020 Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all the technical

regulations applicable to the product within the scope of Council Directives: Directives 2004 / 108 / EC, Directives 2006 / 95 / EC, Directives 2011/65/EU

The above product is in conformity with the following standards or other normative documents：

EN 55022:2010

EN 55024:2010

EN 61000-3-2:2006+A1:2009+A2:2009

EN 61000-3-3:2008

EN60950-1:2006+A11：2009+A1:2010+A12:2011

The product carries the CE Mark

Person is responsible for making this declaration:

Yang Hongliang Product Manager of International Business

Date of issue: 2014

TP-LINK TECHNOLOGIES CO., LTD.

Building 24 (floors 1, 3, 4, 5), and 28 (floors 1-4) Central Science and Technology Park,

Shennan Rd, Nanshan, Shenzhen, China

CONTENTS

Package Contents..............................................................................................................1

Chapter 1 Safety Instructions........................................................................................2

Chapter 2 Minimum System Requirement & Product Feature....................................3

2.1 System Requirement........................................................................................................ 3

2.2 Product Features.............................................................................................................. 3

2.3 Physical Overview ............................................................................................................ 4

2.3.1 Front View ............................................................................................................... 4

2.3.2 Rear View ................................................................................................................ 5

2.4 Mount the Camera............................................................................................................ 5

2.4.1 The Screw Size ....................................................................................................... 5

2.4.2 Wall and Ceiling Mount............................................................................................ 6

2.5 Hardware Connection....................................................................................................... 6

Chapter 3 Using Camera via Web Browser ..................................................................7

3.1 Obtain the IP Address....................................................................................................... 7

3.2 Windows Web Browser..................................................................................................... 9

Chapter 4 Operating Camera via Mobile Phone......................................................... 11

4.1 Mobile Phone Viewing .....................................................................................................11

4.1.1 3G Mobile Phone Streaming Viewing.....................................................................11

4.2 Using Camera via iPhone................................................................................................11

Chapter 5 Configuration of Main Menu ......................................................................13

5.1 Home.............................................................................................................................. 13

5.1.1 Video play buttons ................................................................................................. 13

5.1.2 Snapshot ............................................................................................................... 14

5.1.3 Digital zoom in/out the image via the monitor window........................................... 14

5.1.4 Audio buttons ........................................................................................................ 14

5.2 Information...................................................................................................................... 15

5.3 Basic setup..................................................................................................................... 15

5.3.1 Account.................................................................................................................. 15

5.3.2 Network ................................................................................................................. 17

5.3.2.1 TCP/IP ..................................................................................................... 17

5.3.2.2 PPPoE ..................................................................................................... 18

5.3.2.3 DDNS (Dynamic DNS) ............................................................................ 20

5.3.2.4 UPnP (Universal Plug and Play).............................................................. 23

5.3.3 Image Setting ........................................................................................................ 24

5.3.4 Video ..................................................................................................................... 25

5.3.5 Audio ..................................................................................................................... 25

5.3.6 Camera setting ...................................................................................................... 25

5.3.7 Events.................................................................................................................... 26

5.3.7.1 Motion detection ...................................................................................... 26

5.3.7.2 e-Mail (SMTP) ......................................................................................... 27

5.3.7.3 FTP.......................................................................................................... 29

5.4 System............................................................................................................................ 31

5.4.1 Initialize.................................................................................................................. 32

5.4.2 Date Time .............................................................................................................. 33

5.5 Language........................................................................................................................ 34

Appendix ………………………………………………………………………………………35

A. Frame-rate and Bitrate Table – Help to set Camera with your network environment to

access Internet. ..................................................................................................................... 35

B. Storage Requirement Table - Help to set Recording Storage System............................... 35

C. System Requirement – Help to setup System .................................................................. 36

Europe – EU Declaration of Conformity ........................................................................37

Federal Communication Commission Interference Statement.................................... 40

Package Contents

The following items should be found in your package:

 TL-SC2020 Wired Network Camera  Power Adapter  Mounting Bracket with three screws, a Lock Ring, a Brace and a Base Plate  RJ45 Cable  Quick Installation Guide  Resource CD, including:

 This User Guide  Application Guide  Other helpful information

 Note:

Make sure that the package contains the above items. If any of the listed items is damaged or missing, please contact your distributor.

Chapter 1 Safety Instructions

 Before you use this product This product has been designed with safety in mind. However, the electrical products can cause fires

which may lead to serious body injury if not used properly. To avoid such accidents, be sure to heed the following.

 Legal Caution Video and audio surveillance can be forbidden by laws that vary from country to country. Check the laws

in your local region before using this product for surveillance purposes.

 Don't open the housing of the product Don't try to open the housing or remove the covers, for it may expose you to dangerous voltage or other

hazards.

 Don't use the accessories not recommend by the manufacturer

 Heed the safety precautions

Be sure to follow the general safety precautions and the “Operation Notice.”

 Operation Notice - Operating or storage location Avoid operating or storing the Camera in the following locations:

 Extremely hot or cold places

(Operating temperature: 0 °C to + 40 °C [32 °F to 104°F])

 Exposed to direct sunlight for a long time, or close to heating equipment (e.g., near heaters)  Close to water (e.g., near a bathtub, kitchen sink, laundry tub)  Close to sources of strong magnetism  Close to sources of powerful electromagnetic radiation, such as radios or TV transmitters  Locations subject to strong vibration or shock

 In case of a breakdown In case of system breakdown, discontinue use and contact your authorized dealer.

 In case of abnormal operation

 If the unit emits smoke or an unusual smell,  If water or other foreign objects enter the cabinet, or  If you drop the unit or damage the cabinet: 1. Disconnect the cable and the connecting cables.

2. Contact your authorized dealer or the store where you purchased the product.

 Transportation When transporting the camera, repack it as originally packed at the factory or in materials of equal

quality.

 Ventilation To prevent heat buildup, do not block air circulation around the device.

 Cleaning

 Use a soft, dry cloth to clean the external surfaces of the device. Stubborn stains can be

removed using a soft cloth dampened with a small quantity of detergent solution, then wipe dry.

 Do not use volatile solvents such as alcohol, benzene or thinners as they may damage the

surface.

Chapter 2 Minimum System Requirement & Product Feature

2.1 System Requirement

For normal operation and viewing of the network camera, it’s recommended that your system meets these minimum requirements for proper operation:

Item Requirements

CPU Pentium 4 2.8GHz (or equivalent AMD)

Graphic Card 256 MB RAM graphic cards (or equivalent on-board graphic cards)

RAM 2 GB RAM

Operating System

Web Browser Internet Explore 8 or higher

Note:



Please keep updating the latest Windows software and service package. (E.g.: Net Framework, Windows Media Player, Enhance ActiveX Security)

Windows 2000 / Windows 2003 / Windows XP / Windows Vista / Windows 7

2.2 Product Features

These easy-to-follow instructions make it quick and simple for setup and operation, so you’ll also soon be enjoying the benefits of these product features:

SYSTEM

Resolutions Up to 640 x 480

Compressing format Motion JPEG

Frame Rate Up to 30 fps at 640 x 480

Image settings

Image snapshot Yes

Video Recording Yes

Full Screen Viewing Yes

Digital Zoom 10x digital

Audio

Security Password Protection / HTTPS encryption

Alarm Buffer Recording image and audio file pre-and-post disconnection up to 5 sec.

Brightness / Contrast / Saturation / Sharpness/ Exposure

Overlay capabilities: time, date, text

One-way with built-in microphone

Audio compression: G.711 μ law

Supported protocols

Simultaneous Connection

Operating conditions

Lens F 2.4 fixed lens

Audio Output 1

Power 5V DC, 1A

TCP/IP, DHCP, PPPoE, ARP, ICMP, FTP, SMTP, DNS, NTP, UPnP, RTSP, RTP, RTCP, HTTP, TCP, UDP

Up to 3 users

0°C ~ 40 ℃ (32℉ ~ 104 ℉)

2.3 Physical Overview

2.3.1 Front View

HARDWARE

Built-in Microphone

Power LED Indicator

Network LED Indicator: It lights up when the Camera is well connected to the network. It flashes when

there are data being transmitted.

Power LED Indicator

 Solid Red: The Camera boots up.  Flash Red: The Camera has finished booting up, but it isn’t connected to any network.  Solid Blue: The Camera has been connected to a network.

Built-in Microphone: The location where the voice from your partner comes out.

2.3.2 Rear View

Power Jack

LAN Port

RESET Button

Base Plate

 Power Jack: The power connector is where you connect the power adapter.  RESET: Press the button for more than 15 seconds, and the Camera will be restored to factory

defaults.

 LAN Port: Through this port, you can connect the Camera to your computer or the other Ethernet

network devices.

 Lock Ring: It is used to adjust the angle of the Camera.  Base Plate: It is used to support the Camera and can be fixed to a flat surface with the supplied

screws.

2.4 Mount the Camera

2.4.1 The Screw Size

There are three supplied screws for mounting the Camera. The length of the screws is 25±1 mm and the

diameter is 4±0.2 mm.

2.4.2 Wall and Ceiling Mount

There are two ways to mount the Camera. See the following two pictures.

Ceiling Mount Wall Mount

To mount the Camera, please follow the steps below:

1. Use the three supplied screws to fix the base plate to a flat surface.

2. Loosen the lock ring to adjust the desired angle of the Camera.

3. Tighten the lock ring.

2.5 Hardware Connection

Before proceeding, confirm that your PC is connected to your router and can access the Internet. Make sure that your router’s DHCP feature is enabled. If not, please refer to your router’s instruction to enable it.

Please connect the Camera according to the following steps.

1. Connect the Camera to the LAN network (Router or Switch) via Ethernet cable.

2. Connect the power adapter cord to the Power Jack.

3. Plug the power adapter into the power outlet.

Chapter 3 Using Camera via Web Browser

3.1 Obtain the IP Address

1. Insert the provided CD into your CD-ROM driver. The Setup Wizard will automatically pop up on your computer’s screen as shown in the figure below.

Figure 3-1

2. Choose the Intelligent IP Installer, and then the next screen appears. Click on Intelligent IP Installer to begin the installation.

Figure 3-2

3. After the installation is finished, click Start > All Programs > TP-LINK >Intelligent IP Installer to

start using the program.

Figure

3-3

4. The following screen will then display. Click the Search button to search Network Cameras in the network; it displays Network Cameras information including IP Address.

Figure 3-4

+ 32 hidden pages