TP-Link OC300 User Manual

Regulatory Compliance

Router / Omada Hardware Controller

For Class A product with power adapter:

FCC Compliance Information Statement

Product Name: Router

Model Number: TL-R600VPN / TL-R470T+

Component Name Model

Power Adapter T090060-2B1 (For TL-R600VPN / TL-R470T+)

Responsible party:

TP-Link USA Corporation, d/b/a TP-Link North America, Inc.

Address: 145 South State College Blvd. Suite 400, Brea, CA 92821

Website: https://www.tp-link.com/us/

Tel: [phone]

Fax: [phone]

E-mail: [e-mail]

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause
undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

Product Name: Power Adapter

Model Number: T090060-2B1

Responsible party:

TP-Link USA Corporation, d/b/a TP-Link North America, Inc.

Address: 145 South State College Blvd. Suite 400, Brea, CA 92821

Website: https://www.tp-link.com/us/

Tel: [phone]

Fax: [phone]

E-mail: [e-mail]

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

■ Reorient or relocate the receiving antenna.

■ Increase the separation between the equipment and receiver.

■ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

■ Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause
undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

We, TP‑Link USA Corporation, has determined that the equipment shown as above has been
shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized
change is made in the equipment and the equipment is properly maintained and operated.

Issue Date: 2020/06/04

CE Mark Warning

This is a class A product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.

TP-Link hereby declares that the device is in compliance with the essential requirements and
other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC, 2011/65/EU and
(EU)2015/863.

The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce

Canadian Compliance Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired
operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1) L’appareil ne doit pas produire de brouillage;

2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

Industry Canada Statement

CAN ICES-3 (A)/NMB-3(A)

この装置は、クラス A 情報技術装置です. この装置を家庭環境で使用すると電波妨害を引き起こすことが
あります . この場合には使用者が適切な対 策を講ずるよう要求されることがあります .

VCCI‑A

BSMI Notice

安全諮詢及注意事項

■■請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。

■■清潔本產品之前請先拔掉電源線 . 請勿使用液體、噴霧清潔劑或濕布進行清潔。

■■注意防潮，請勿將水或其他液體潑灑到本產品上。

■■插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。

■■請勿將本產品置放於靠近熱源的地方 . 除非有正常的通風，否則不可放在密閉位置中。

■■不要私自拆開機殼或自行維修，如產品有故障請與原廠或代理商聯繫。

此為甲類資訊技術設備，于居住環境中使用時，可能會造成射頻擾動，在此種情況下，使用者會被要求採
取某些適當的對策。

限用物質含有情況標示聲明書

限用物質及其化學符號

產品元件名稱

PCB
外殼 ○ ○ ○ ○ ○ ○
電源供應器
備考1. "超出0.1 wt %" 及 "超出0.01 wt %" 系指限用物質之百分比含量超出百分比含量基準值.

備考2."○"系指該項限用物質之百分比含量未超出百分比含量基準值.
備考3."—" 系指該項限用物質為排除項目.

鉛

Pb

○ ○ ○ ○ ○ ○

— ○ ○ ○ ○ ○

鎘

Cd

汞

Hg

六價鉻

CrVI

多溴聯苯

PBB

多溴二苯醚

PBDE

Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам
нормативних документів та вимогам, що передбачені чинними законодавчими актами
України.

Safety Information

■ Keep the device away from water, fire, humidity or hot environments.

■ Do not attempt to disassemble, repair, or modify the device. If you need service, please
contact us.

■ Do not use damaged charger or USB cable to charge the device.

■ Do not use any other chargers than those recommended.

■ Adapter shall be installed near the equipment and shall be easily accessible.

■ Place the device with its bottom surface downward.

■ Use only power supplies which are provided by manufacturer and in the original packing of
this product. If you have any questions, please don't hesitate to contact us.

Please read and follow the above safety information when operating the device. We cannot
guarantee that no accidents or damage will occur due to improper use of the device. Please use
this product with care and operate at your own risk.

Explanation of the symbols on the product label

Note: The product label can be found at the bottom of the product and its I.T.E. power supply.

Symbol Explanation

Class II equipment

AC voltage

DC voltage

Indoor use only.

Polarity of output terminals

Energy efficiency marking (Level VI)

RECYCLING

This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment.

User has the choice to give his product to a competent recycling organization
or to the retailer when he buys a new electrical or electronic equipment.