Topcon FC200NJT499 User Manual

TOPCON

FC200-NJT-499

User’s Manual

Ver1.1

November 16, 2006

1

FCC Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.

CAUTION: Change or modification not expressly approved by the party responsible

for compliance could void the user’s authority to operate this equipment.

CAUTION: In order to comply with FCC radio-frequency radiation exposure

guidelines for an uncontrolled exposure, this device and its antenna must not be
co-located or operating in conjunction with any other antenna or transmitter.

NOTE: This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules.

FCC ID: H5P-FC200NJT499

These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required
to correct the interference at his or her own expense.

NOTE: The device to which FC200-NJT-499 is installed must display "Contains TX FCC ID:

H5P-FC200NJT499".

IC Notices

CAUSION: Operation is subject to the following two conditions:

(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause

undesired operation of the device.

IC : 6050A-FC200NJT

CAUTION:

or pointed such that it does not emit RF field in excess of Health Canada limits for the
general population; consult Safety Code 6, obtainable from Health Canada’s website
www.hc-sc.gc.ca/rpb

2

The installer of this radio equipment must ensure that the antenna is located

(1) Product Overview

The FC200-NJT-499 is designed to provide wireless communication ability for the TOPCON’s
“FC” Field Controller families to communicate with other wireless LAN device s usin g the
IEEE802.11b/11g MAC/Baseband Processing. It can be easily attached to “FC” Field
Controller and easy to operate through the User Interface of “FC”

(2) Features

Wireless Features

The FC200-NJT-499 is a compact wireless LAN communication module designed for
TOPCON’s “FC” Field Controller families

Tx and Rx Operation Frequency: 2412-2462 MHz
Modulation Method: Direct Sequence Spectrum Spread (DSSS) and OFDM
Number of Channels: 11
Channel Intervals: 5 MHz

Bit rate: 1 Mbps (DBPSK/DSSS), 2 Mbps (DQPSK/DSSS),

5.5 Mbps (CCK/DSSS), 11 Mbps (CCK),
54Mbps (64-QAM/OFDM)

Physical Attributes

Size: 18mm (L) x 476mm (W) x 12mm (D)

Weight: 0.08 Kg
Operating Temperature: -20 deg. C to +50 deg. C
Power Requirements: 0.8 W @ +5.0 VDC from “FC” Field Controller

3