TC Helicon VOICETONE HARMONY-G XT Quick Start Guide

Page 1
Quick Start Guide
(1) (3) (4) (5)(2)
(6)
(8) (9)
(7)
(12) (13)
(11)
(10)
(18)(14)
(15)
(19)
(17)(16)
VOICETONE HARMONY-G XT
(1) Input knob – Adjust the input gain so that
the adjacent LED lights green while you sing, and occasionally lights orange during the loudest peaks.
(2) Tone button – A single press activates
or deactivates AdaptiveTone to make your voice smoother and brighter, indicated by a solid LED when engaged. A double click activates or deactivates auto-chromatic pitch correction to provide subtle pitch support, indicated by a periodic ash of the LED when engaged. When both eects are engaged, the LED will light solid except for periodically ashing o.
(3) Guitar knob – Controls the guitar volume
when the THRU jack is not used. The far left ‘Auto’ position automatically balanced your guitar volume with your voice. Just above the ‘Auto’ setting is an ‘O’ setting that mutes the guitar.
(4) FX knob – Adjusts the mix level of the eect
selected with the FX button.
(5) Harmony knob – Adjusts the mix level of
the harmony and double eects.
(6) Preset button – Press to cycle through
the 5 presets shown in the display. Hold the Preset button to save changes made to the current preset.
(7) 48V LED – Hold the Manual and Double
buttons for 2 seconds to engage phantom power for use with condenser microphones.
(8) Manual button – Press to allow the guitar
signal to dictate the harmonies. Details of this function are discussed in the full manual.
(9) Double button – Press to simulate the
sound of two of you singing in unison.
(10) Voice 1/2 buttons – Press either of the
Voice buttons to select a harmony interval. Details of this function are discussed in the full manual. Hold both buttons to select stereo or mono operation.
(11) FX button – Press to cycle through the
available eect styles for the current preset. When no LEDs are lit, the eects are bypassed.
Page 2
(12) Preset A/B footswitch – Tapping the
footswitch will toggle between the presets assigned to slot A and B. Hold the footswitch to enter Preset Select mode for the current slot (A or B), which allows the footswitch to cycle through all 5 saved presets.
(13) On/Bypass footswitch – Tapping the
footswitch engages or disengages the doubling and harmony eects in the current preset, leaving the reverb/delay eects active. Holding the footswitch will enter Tuner/Bypass mode, which mutes the guitar signal and bypasses all vocal eects except for Tone.
(14) USB port – Connect to a computer for
rmware updates and suppor t.
(15) Power input – Connect the included power
adapter. (12 V DC, 300 mA, tip negative)
(16) OUTPUTS – Connect to a mixer
via XLR cables.
(17) INST IN/THRU – Connect your guitar to the
IN jack, then connect the THRU to other guitar pedals or an amplier.
(18) MIC INPUT – Connect your microphone via
XLR cable.
(19) GND – If you hear a buzz when you plug
in a cable from the THRU to your amp or PA, press this button in. If the THRU jack is not used and your guitar sound is routed internally, the Ground Lift switch should be left out.
Visit tc-helicon.com to download the full manual
LEGAL DISCLAIMER
Music Tribe accepts n o liability for any loss whic h may be suered by any perso n who relies either wholly o r in part upon any description, photograph, or statement cont ained herein. Technical specications, appear ances and other information are subjec t to change without notice. All t rademarks are the pro perty of their re spective owners. M idas, Klark Teknik, Lab Grupp en, Lake, Tannoy, Turbosound, TC Elec tronic, TC Helicon, Behringe r, Bugera and Coolaud io are trademarks or registere d trademarks of Music Tribe G lobal Brands Ltd. © Music Tribe Globa l Brands Ltd. 2019 All rights reserve d.
LIMITED WARRANTY
For the applic able warranty terms a nd conditions and additio nal information regar ding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South Ch ina Modern Chinese Medi cine Park, Nanlang Town, 528451, Zhongshan City, Guangdong Province, China
Loading...