DR-10X
Nov, 2014
Product Spec Sheet
Compact Linear PCM Recorder
DR-10X
■ Specifications
Ratings
・Recording media
・Recording/playback formats
microSD card (64 MB−2 GB)
microSDHC card (4 GB−32 GB)
48kHz/24-bit MONO WAV (BWF format)
Input/output ratings
・Analog input
Mic jack
Connector
XLR JACK (female) (1: GND, 2: HOT, 3: COLD)
When MIC GAIN external input (EXT) selected (HOT pin unbalanced input)
Maximum input level: −8 dBu
Nominal input level: −24 dBu
0015a -1- TEAC CORPORATION
DR-10X
When MIC GAIN mic input (LO/MID/HI) selected (balanced input)
Maximum input level: −31 dBu
Minimum input level: −63 dBu
Mic input gain
LO: +29 dB
MID: +35 dB
HI: +45 dB
Input impedance: 10 kΩ or more
・Analog output
Headphones jack
Connector: 1/8” (3.5mm) stereo phone (dual mono audio output)
Audio performance
・IN → PHONES (input monitoring output, 10kΩ load)
When MIC GAIN external input (EXT) selected (HOT pin unbalanced input)
Frequency response: 20 Hz – 22 kHz +1/−2 dB
Distortion: 0.05% (1kHz sine wave, at maximum input level)
S/N ratio: 92 dB or higher (PHONES volume max)
When MIC GAIN mic input (LO/MID/HI) selected (balanced input)
Frequency response: 20 Hz – 22 kHz +1/−2 dB
Distortion: 0.05% (1kHz sine wave, at maximum input level)
S/N ratio: 80 dB or higher (PHONES volume max, LO selected)
Requirements for connected computers
Check the TEAC Global Site (http://teac-global.com/) for the latest information about supported
operating systems.
・Supported operating systems
Windows
Windows 8 (including 8.1), Windows 7
Mac
OS X Mavericks (10.9), OS X Mountain Lion (10.8)
General
・Power
1 AAA battery (alkaline, NiMH or lithium)
USB bus power from a computer
・Power consumption
0.65 W (maximum)
・Current consumption (USB bus power)
0.25A (maximum)
・Battery operation time (continuous operation)
Using an alkaline battery (EVOLTA)
Format Operation time Note
Headphones not connected
Recording 48kHz/24-bit WAV About 10.0 hours
Recording: JEITA recording time
Limiter: off
Dual recording: off
0015a -2- TEAC CORPORATION