Sharp CDDP2500 User Manual
CD-DP2500H
SETTING THE CLOCK
In this example, the clock is set for the 24-hour (0:00) system.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.4Press the TUNING/TIME (
or
) button to select the time
display mode.
“0:00” →The 24-hour display will appear.
(0:00 - 23:59)
“AM 0:00” →The 12-hour display will appear.
(AM 0:00 - PM 11:59)
“AM 12:00” →The 12-hour display will appear.
(AM 12:00 - PM 11:59)
● Note that this can only be set when the unit is first in-
stalled or it has been reset.
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (
or ) button to adjust the hour.
● Press the TUNING/TIME (
or
) button once to ad-
vance the time by 1 hour. Hold it down to advance con-
tinuously.
● When the 12-hour display is selected, “AM” will change
automatically to “PM”.
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (
or ) button to adjust the min-
utes.
● Press the TUNING/TIME (
or ) button once to ad-
vance the time by 1 minute. Hold it down to change the
time in 5 minute intervals.
● The hour setting will not advance even if minutes advance
from “59” to “00”.
9
Press the MEMORY/SET button.
● The clock starts operating from “0” second.
(Seconds are not displayed.)
And then the clock display will disappear after a few sec-
onds.
To see the time display:
Press the CLOCK button.
● The time display will appear for about 5 seconds.
Note:
● The clock display will flash on and off at the push of the
CLOCK button when the AC power supply is restored after
a power failure occurs or after the AC power lead is discon-
nected.
If this happens, follow the procedure below to change the
clock time.
To change the clock time:
1 Press the CLOCK button.
2
Within 5 seconds, press the MEMORY/SET button.
3 Perform steps 6 - 9 above.
To change the time display mode:
1 Perform steps 1 - 2 in the section “RESETTING THE MI-
CROCOMPUTER”.
2
Perform steps 1 - 9 above.
(Main unit operation)
RESETTING THE MICROCOMPUTER
Reset the microcomputer under the following con-
ditions:
● T o erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
● If the display is not correct.
● If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Whilst pressing down the
/ button and the X-BASS
button, hold down the ON/STAND-BY button for at least 1
second.
● “CLEAR AL” will appear.
Caution:
● The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and
CD presets.
OPERATION MANUAL
– 8 –
CD-DP2500H
●
– 9 –
Loading...