Schneider Electric TC-5231 Series, TC-5232 Series, TC-5241 Series Data Sheet
SPECIFICATIONS
Setpoint Dial Range: Dual marked 35 to 60°F (1.7 to 15.5°C).
Sensing Element: Vapor pressure type, copper construction.
Response: To lowest temperature sensed by any one-foo
t section
of its element. Altitude
causes the control to operate approximately 1°F colder per 1000 ft. of elevation.
Differential: 5°F (3°C) fixed.
Electrical Switch: Snap action SPDT or DPST. Refer to Table-1.
Ratings, Refer to Table-1 and
Table-2.
Connections:
TC-52xx, Screw terminals.
Mounting: In any position on any surface not subject to excessive vibration.
Housing: Molded gray PVC plastic cover with a zinc-plated steel main
enclosure with a 1/2
in. conduit opening.
Ambient Temperature Limits:
Shipping and Storage, -40 to 150°F (-40 to 66°C).
Operating, Must be 5°F (3°C) above setpoint to a maximum of 150°F (66°C) at case.
Thermal Sensing Element, 300°F (149°C).
Humidity:
Enclosure, 5 to 95% RH, non-condensing.
Thermal Sensing Element, 0 to 100% RH.
closure Rating: NEMA Type 1.
En
Dimensions:
Case, 2.7 H x 3.44 W x 1.97 D in. (69 x 87 x 50 mm).
Element, 3/32 in. O.D. x 20 ft. length (2.4 mm x 6.1 m).
Agency Appro
Certified
vals: UL 873 Temperature-Indicating and -Regulating Equipment and CSA
.
Table-1 Model Chart.
Full
Model
Number
TC-5231
TC-5232
TC-5241
a
Less than 0.5 Amp is not recommended.
b
Reset cannot be accomplished until the sensed temperature is at least 5°F above setpoint.
c
Full load and locked rotor ratings are suitable for herme ic compressors only.
d
Limit two separate circuit loads with common return to < 5885 VA. Only one load may be a motor load.
e
Do not exceed pilot duty rating on one side of switch.
Device Type
Low temp
auto reset
Low temp
auto reset
Low temp
manual reset
Electrical
b
Switch
SPDT
DPST
SPDT
Vol tag e
Vac
24
120
e
240
277 — — — 7.2
24
120
d
240
277 — — — 7.2
24
120
e
240
277 — — — 7.2
Amps
a
c
a
c
c
c
a
c
Locked
Load
Roto
Amps
— — 100 16
17 102 720 24208
— — 100 16
24 144 125 24208
— — 100 16
17 102 720 24208
Pilot
r
Duty
(VA)
Non-Inductive
Amps
Table-2 DC Ratings for TC-5232 Only.
Vol ts FLA LRA NIA PD VA
120 4.6 46 3 57.5
240 2.3 23 0.5 57.5
600 — — — 57.5
2 © Copyright 2010 Schneider Electric All Rights Reserved. F-25911-9
TYPICAL APPLICATIONS (wiring diagrams)
AC Supply
Earth Ground
(2)
Indication
Circuit
Fan
Motor
(3)
(1)
1 Terminals (2) and (1) close on temperature drop.
1
Temp
Drop
Figure-1 TC-5231 and TC-5241 Typical Application.
AC Supply
L
L
Fan
Motor
T
T
Indication
Circuit
Note: Contacts are not rated for dry circuit applications.
Less than 1 Amp is not recommended.
2 Terminals L-T open on temperature drop.
2
Figure-2 TC-5232 Typical Application.
F-25911-9 © Copyright 2010 Schneider Electric All Rights Reserved. 3
Loading...