ER-180U /UDL
Electronic Cash Register
1Get Ready
Unpack the Cash Register
Remove the cash register from the packaging. Locate the following items:
•1 power adaptor
•1 roll of paper
•1 set of keys (ER-180U - 5 keys in total; ER-180UDL - 6 keys)
•1 user manual
•(Optional) Take up spool set.
Loading Paper
The ER-180U has a built-in thermal printer and a 57mm thermal paper roll. The printer can be used as a receipt printer or a journal printer.
•Remove the printer cover
•Open the housing clam cover (Fig (c))
•Insert the paper roll as shown on Fig (D)
•Pressing the housing clam cover (Fig (E))
•Press FEED to advance paper
•Replace the printer cover
Quick Setup Guide
2RAM All Clear
RAM (Memory) All Clear - Reset
RAM All Clear an ER-180U /UDL and the register will reset to factory default program. This is recommended for all new products. To do so:
• Hold down CHARGE button
•Plug in Power Lead then release CHARGE button after the beep! Sound
•Press FEED, TAX, CALC then CASH/TEND button in sequence. “RAM ALL CLEAR OK!” will print on the receipt, the display will show ”= = = = =
= = = = =”. The EPROM info will print at the end of this procedure.
•Turn key to REG-Mode
•The display should show “0.00” and be ready for use
At this point, all 16 Departments and 100 PLUs are preset to 10% on Tax1 (GST) and OPEN PRICE (a price must be entered for an item); at the start, all PLUs link to Department 1.
3Programming
Descriptor Programming Methods
The ER-180U has two different descriptor program methods - The Alpha Overlay and the Three Digit Code. To program a description with Alpha Overlay Entry Method:
• Enter 6 
MODE , to go to PGM-Mode
Descriptor of |
Address |
Number |
Character |
|
Length |
||||
|
|
|
||
Department (16) |
1 |
0001 ~ 0016 |
12 |
|
PLU (500) |
2 |
0001 ~ 0500 |
12 |
|
Receipt Header |
3 |
0001 ~ 0006 |
24 |
|
(6 Lines) |
||||
|
|
|
||
Receipt Footer |
4 |
0001 ~ 0006 |
24 |
|
(6 Lines) |
||||
|
|
|
•Enter Address + Number for the logo descriptor line you want to program (for example, the 2nd line of Receipt Header, enter 3 
0 
0 
0 
2 ) then press
SUBTOTAL button.
|
|
|
|
A |
F |
K |
P |
U |
X |
DOUBLE |
7 |
8 |
9 |
B |
G |
L |
Q |
V |
Y |
CAPS |
4 |
5 |
6 |
C |
H |
M |
R |
W |
Z |
BACK |
1 |
2 |
3 |
D |
I |
N |
S |
SUB TOTAL |
|
|
0 |
00 |
• |
E |
J |
O |
T |
CASH |
|
SPACE |
|
|
|||||||
•Enter up to 24 characters; for more detail, please see Overlay Descriptor Programming Methods on User Manual. Then press SUBTOTAL button.
•Press CASH/TEND to finalise programming.
Loading...