Pelco FTV10D1S1ST, FTV10D1S1FC, FRV10D1M1ST, FTV10D1M1ST, FTV10D1A2S1ST Specsheet

PRODUCT SPECIFICATION	transmission & power

FTV10D1/FRV10D1 Fiber Transmitter and Receiver

SINGLE-CHANNEL DIGITALLY ENCODED VIDEO WITH BIDIRECTIONAL DATA

Product Features

•10-Bit Digitally Encoded Video for High-Quality Video Transmission over a Single Fiber

•Bidirectional Data Channel that Supports RS-232, RS-422, RS-485 (2-wire/4-wire), Manchester, Bi-Phase, and Coaxitron® Communication

•Supports Pelco Coaxitron “Up-the-Coax” Control Signals for a Distance up to 48 km (30 mi)

•Multimode Fiber Support for Distances up to 3 km (2 mi)

•Single-Mode Fiber Support for Distances up to 69 km (43 mi)

•Exceeds All Requirements for RS-250C Short-Haul Transmission

•Laser Diode for Transmission of Optical Signals

•Compatible with NTSC, PAL, and SECAM Video Standards

•Designed to Meet NEMA TS-1/TS-2 and Caltrans Traffic Signal Control Equipment Environmental Standards

• Stand-Alone and Rack-Mountable Modular Design

FRV10D1S1ST

•LED Status Indicators for Monitoring All Critical Operating Parameters

Available in multimode and single-mode versions, the F T V 10 D 1 / F R V1 0 D 1 fiber transmitter and receiver allow transmission of one unidirectional composite video channel and one bidirectional data channel over one optical fiber. In addition, the “up-the-coax” technology allows Coaxitron® pan/tilt/zoom (PTZ) control data to be transmitted the full distance of the fiber (up to 48 km for single-mode fiber). When using single-mode fiber, the FTV10D1 transmitter and the FRV10D1 receiver offer an optical power budget of 23 dB.

The FTV10D1 transmitter and the FRV10D1 receiver are compatible with each other and other fiber models. The FRV10D1 receiver is also backward compatible with the FSV10D1 transmitter.

The FTV10D1/FRV10D1 plug-and-play design ensures ease of installation by requiring no electrical or optical adjustments. Modular in design, FTV10D1 and FRV10D1 units can be rack-mounted using the EURACK/USRACK chassis, or stand-alone modules can be placed on a desktop or mounted to a wall (wall mount kit not required).

For stand-alone and wall mount installations, external power is required for the FTV10D1/FRV10D1 units. The units can be powered with the recommended FEXTPS fiber external power supply.

International Standards

Organization Registered Firm;

ISO 9001 Quality System

C3922 / NEW 10-5-12