OLYMPUS C-40 Zoom TECHNICAL INFORMATION TID C40Z E003 R OE

TECHNICAL INFORMATION

NO. TID-C40Z-E003-R_OE

DATE: June 6th 2002

Page 1 of 2

SUBJECT: Special Note For Assembling And Disassembling Of

C-40ZOOM / D-40ZOOM

Product name: C-40Zoom / D-40Zoom

Problem: The CA-2 PCB could be damaged during disassembling and/or assembling of the camera.

If the CA-2 is damaged, the camera does not operate anymore. (LED blinks and the lens
does not operate).
Please find below the most critical points.

Reason: The CA-2 board is a multi layer PCB, which can easily be damaged by bending, pressing and

twisting of it.

Point 1: The CA-2 may be damaged, if it will be pressed too strongly when assembling it.
Countermeasure: Open the hook beforehand and assemble the CA-2.

Point 2: The CA-2 may be damaged, if the it will be pressed too strongly when the inlay is assembled to

cabinet front.

Countermeasure: Press only at the mentioned points when assembling it.

Press only at these points.

DO NOT PRESS CA-2 PCB !

OLYMPUS OPTICAL CO. (EUROPA) GMBH

TECHNICAL INFORMATION

NO. TID-C40Z-E003-R_OE

DATE: June 6th 2002

Page 2 of 2

Point 3: The CA-2 may be damaged by the pressure and distortion of the PCB when putting the screws

on the CA-2 or PW-1.

Countermeasure: Do not make pressure and distortion to the PCB, when putting the screws on them.

Do not press strongly on the PW-1,
if CA-2 is already assembled.

OLYMPUS OPTICAL CO. (EUROPA) GMBH