B. DISASSEMBLY AND ASSEMBLY PROCEDURE
C-150/D-390
B. DISASSEMBLY AND ASSEMBLY
PROCEDURE
[1] B-2
[2] B-3
[3] B-4
[4] BOARD LOCATION ................................................................................................ B-5
B-1
Ver. 1
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-150/D-390
[1] REMOVAL OF FRONT COVER ASS’Y, INSIDE ASS’Y, AND BACKCOVER ASS’Y
Disassembly perform as follows (1, 2...14) and assembly perform by reversing the disassembly steps (14, 13...1). Be sure to
discharge the main capacitor in procedure 14, then continue to disassembling.
! Beware of electric shock
Danger of electric shock.
Use a discharging tool to remove
the electrical charge before working.
8
4
12
5
7,9
1
2
3
1.Open the Card Cover
2.Screw 1.7X21
3.Screw 1.7X13
4.Screw1.6X13
5.Three Screws 1.7X5.5
6.Two Screws 1.7X4
7.Open the Battery Cover
8.Back Cover
9.Battery Cover
10.Screw 1.7X13
11.Front Cover
12.Spider Seat
13.Connecter
14.Discharge
11
13
10
5
6
CN5
CN6
14
B-2 Ver.1
B. DISASSEMBLY AND ASSEMBLY PROCEDUREC-150/D-390
Red
Black
Blue
Red
Black
to buzzer
[2] REMOVAL OF MAIN BOARD ,POWER BOARD ,AND LCD ASS’Y
GND BLUE WHITE
Battery Terminal(-)
11
13
7
RED BLACK
9
12
Battery Terminal(+)
8
4.fig.1-2
6
3
2
3
5
1
10
15
The lead wire is covered with adhesives.(Adhesives: SU-
PER -X)
14
1.Screw 1.7X4
2.Two Wires
3.Unsolder
4.LCD-FPC
5.LCD Holder
6.LCD
7.Unsolder (TERMNAL,GND,RED,BLUE,BLACK,WHITE)
8.Three Screws 1.7X4
9.Connector
10.Main Board
11.Unsolder
12.Remove Reflector
13.Four Screws 1.7X4
14.Power Board
15.Frame
fig.1
fig.2
B-3Ver.1
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-150/D-390
[3] REMOVAL OF OVF AND LENS ASSEMBLY
8
9
7
6
2
3
4
1
1.FPC
2.Two Screws 1.7X4.5
3.Screw 1.7X2.5
4.Main Board
5.Lens
6.LP
7.Spacer Rubber
8.Two Screws 1.4X4
9.View Finder
5
Lens
The direction which inserts LP.
The mark is the lower left.
B-4 Ver.1
[4] BOARD LOCATION
B. DISASSEMBLY AND ASSEMBLY PROCEDUREC-150/D-390
Power Board Main Board
B-5Ver.1
Loading...