Navigation System (if so equipped) ...................................
®
Hands-free Phone System (if so equipped) .................14
17
This easy-to-use Quick Reference Guide is intended to help you more fully
appreciate some of the unique features and functions of your new vehicle.
However, it is not intended to replace your Owner’s Manual. The Owner’s
Manual contains more detailed information to help you better understand
the important safety warnings, features, operation and maintenance of your
vehicle. All information, specifications, photographs and illustrations in this
publication are those in effect at the time of printing. NISSAN reserves the
right to change specifications or design without notice and without obligation.
REMOTE KEYLESS ENTRY SYSTEM (if so equipped)
LOCK DOORS
Press the
button to lock all doors.
UNLOCK DOORS
Press the
only. Press the button again within 5 seconds to unlock
all doors.
button once to unlock the driver’s door
USING THE PANIC ALARM
Press and hold the
the headlights will stay on for 25 seconds. The panic alarm stops when it has run for
25 seconds or when any button is pressed on the keyfob.
button for longer than 0.5 seconds. The panic alarm will sound and
NISSAN INTELLIGENT KEYTM (if so equipped)
The NISSAN Intelligent Key™ allows you to lock or unlock your vehicle, open
your trunk or rear hatch and start the engine.
NOTE: It is important to make sure the Intelligent Key is with you (that is, in your
pocket or purse).
The operating range of the door and rear hatch/trunk lock/unlock function
is approximately 31 in (0.8 m).
Locking the vehicle - Push any door handle Request Switch
01 once.
Unlocking the vehicle - Push any door handle Request Switch
01 once. The corresponding door will unlock. Push the door
handle Request Switch 01 again within 1 minute; all other
doors will unlock.
01
OPENING THE REAR HATCH (if so equipped)
Push the Rear Hatch Request Switch 02 .
Push the Release Switch 03 under the rear hatch handle.
Pull up and out on the handle to open the rear hatch.
OPENING THE TRUNK (if so equipped)
Push the Trunk Request Switch 02 .
Push the Release Switch 03 under the trunk handle.
Pull up and out on the handle to open the trunk.
SILENCING THE HORN BEEP FEATURE
To deactivate: Press and hold the
To activate: Press and hold the
2
and
and
buttons for at least 2 seconds.
buttons for at least 2 seconds.
02
03
02
03
AUTOMATIC DOOR LOCKS (if so equipped)
All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
All doors unlock automatically when the ignition is placed in the OFF position (NISSAN
Intelligent KeyTM equipped vehicles) or when the key is removed from the ignition switch
(mechanical key equipped vehicles).
The automatic lock and unlock functions can be deactivated or activated independently
of each other. To deactivate or activate the automatic door lock or unlock system, perform the
following procedure:
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Do one of the following within 20 seconds of performing Step #2:
• To change AUTO UNLOCK settings: Push and hold the Power Door Lock switch to the
(UNLOCK) position for more than 5 seconds.
• To change AUTO LOCK settings: Push and hold the Power Door Lock switch to the
(LOCK) position for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator
will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting
change.
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the ON position to
activate the windshield wipers.
Move the lever to the following positions to operate
the windshield wipers:
1A
intermittently and can be further adjusted by
twisting the time control ring
operation of front wipers.
operation of front wipers.
or second (ON) speed settings for the rear wipers.
For Front Washer, pull the lever toward you.
For Rear Washer, push the lever away from you.
Intermittent (INT) – Front wipers operate
1B
.
02
Low Speed (LO) – Continuous low-speed
03
High Speed (HI) – Continuous high-speed
04
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
05
Rear Wiper (REAR) (if so equipped) – Twist the end section to operate the first (INT)
1B
04
05
1A
02
03
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
Turn the headlight control switch
to turn on the front parking, tail, license plate and instrument
panel lights.
Turn the headlight control switch
to turn on the headlights. All other lights remain on.
FOG LIGHT OPERATION (if so equipped)
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
Turn the switch (inside collar)
Turn the switch (inside collar)
HIGH BEAM
Push the headlight control switch forward
high beam function. The blue
Pull the headlight switch back to the original position to
select the low beam function. The blue indicator light
goes off.
Pull and release the headlight control switch
the headlight high beams on and off.
to the position
01
to the
01
to the
02
to the OFF position to turn off the fog lights.
02
indicator light illuminates.
position
position to turn on the fog lights.
to select the
A
B
to flash
A
01
02
B
STEERING WHEEL SWITCHES FOR AUDIO CONTROL/
BLUETOOTH® (if so equipped)
Press the SOURCE button to turn the audio system on.
To choose Preset A, B, C, CD or AUX press SOURCE
repeatedly.
The tuning up or down
the following:
• Pushthe
to a preset station.
• Pushandholdthe
to seek the next or previous broadcasting radio station.
• Pushthe
Push the + or – control switch to increase or decrease the volume.
4
switch for less than 1.5 seconds to change
switch while playing a CD for less than 1.5 seconds to change tracks on the CD.
switch can be used to perform
switch for more than 1.5 seconds
CRUISE CONTROL (if so equipped)
To activate cruise control, push the ON/OFF switch. The
indicator light in the instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired
speed, push the COAST/SET switch and release. The
SET indicator light in the instrument panel will illuminate.
To reset at a faster cruising speed, push and hold the
ACCEL/RES switch. When the vehicle attains the speed
you desire, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET switch. Release the
switch when the vehicle slows to the desired speed.
To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET indicator
light in the instrument panel will go out.
To resume a preset speed, push and release the ACCEL/RES switch. The vehicle returns to
the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h).
To turn off cruise control, push the ON/OFF switch. Both the CRUISE indicator light and the
SET indicator light in the instrument panel will go out.
07
03
04
0506
01
02
MANUAL CLIMATE CONTROL
01
FAN SPEED CONTROL DIAL
Turn the fan speed control dial to the left (slow) or right (fast) to control fan speed.
02
TEMPERATURE CONTROL DIAL
Turn the temperature control dial to select the desired temperature. Turn the control dial to the
left for cold air or right for hot air.
03
AIR FLOW CONTROL DIAL
Turn the dial to select from the following air flow outlets:
Air flows from the center and side vents.
Air flows from the center, side and foot vents.
Air flows mainly from the foot vents.
Air flows from the defroster and foot vents.
Air flows mainly from the defroster vents.
5
04
DEFROSTING/DEMISTING FRONT AND S IDE WINDOWS
Move the air intake lever
Turn the air flow control dial
Turn the temperature control dial
To set the defroster on high, turn both the fan speed control dial
control dial
, all the way to the right.
02
to the
07
to the front window defroster mode .
03
02
left position for fresh air.
left or right to set the desired temperature.
and the temperature
01
The A/C will automatically turn on for enhanced defrosting/demisting performance. The
A/C indicator light will not illuminate.
05
REAR WINDOW DEFROSTER
Push the rear window defroster switch
on. Push the switch again to manually turn the
defroster off. This function automatically turns off after approximately 15 minutes.
06
A/C ON/OFF BUTTON (if so equipped)
Press the A/C button to manually turn the A/C on or off.
07
AIR INTAKE LEVE R
Move the air intake lever to the
Move the air intake lever to the
Move the air intake lever to the
air conditioner (if so equipped).
position to draw in fresh outside air.
position to recirculate air inside the vehicle.
position for maximum cooling when using the
01
07
08
02
09
12
14
030504
11
13
10
06
15
FM/AM/XM®* RADIO WITH CD PLAYER (if so equipped)
01
MUTE BUTTON
Press the MUTE button to mute the audio sound. Press again to resume the audio sound.
02
FM/AM BUTTON
Pressing the FM/AM button will change the band to either AM, FM1 or FM2 radio stations.
6
03
CD BUTTON
Press the CD button to play a CD.
05
AUX BUTTON
Press the AUX button to play a compatible device such as an MP3 player when it is
plugged into the AUX (auxiliary) jack.
Pressing the AUX button will also change the satellite band (AUX, SAT1 and SAT2)
(if so equipped).
NOTE: You may need to adjust the volume on any compatible device plugged into the auxiliary
jack to find the most desired sound level of the audio system.
06
EJECT BUTTON
EJECT A DISC - Press the button for less than 1.5 seconds. The CD will then eject.
07
DISP/TEXT BUTTON
Press the DISP/TEXT button to change the text displayed while playing an FM radio station,
CD or iPod®.
08
SEEK/TRACK BUTTON
To scan quickly through each broadcasting station, press the SEE K/TRACK button.
To skip from one track to another on a CD, press the SEEK/TRACK button.
10
STATION SELECT BUTTONS
Your radio is equipped with three separate banks, each with six station presets. Choose a
radio band AM, FM1 or FM2 using the FM/AM button. Tune to the desired station using
SEEK/TRACK or SCAN tuning. Press and hold any of the desired station select buttons
(1 - 6) until a beep is heard. Now the station is set in memory.
11
SCAN/RPT BUTTON
Press the SCAN/RPT button to stop at each broadcasting station for 5 seconds.
Pressing the button again during this 5-second period will stop scan tuning and the radio
will remain tuned to that station.
Press the SCAN/RPT button to change the play pattern while listening to a CD, MP3
CD or iPod®.
13
AUDIO BUTTON
To adjust the bass, treble, fade, balance, Speed Sensitive Volume (SSV) (if so equipped)
and beep settings, press the AUDIO button until the desired mode appears in the display.
Press the TUNE or SEEK buttons to adjust the selected mode to the desired level.
Once you’ve adjusted the sound quality to the desired level, press the AUDIO button
repeatedly until the radio or CD mode appears on the display.
15
TUNE/FF-REW/FOLDE R BUTTON
To manually tune the radio, press the TUNE/FF-REW/FOLDER button.
While listening to a CD, press the TUNE/FF-REW/FOLDE R button for more than
1.5 seconds to fast forward or rewind. When the button is released, the CD returns
to normal play.
If playing a CD that is formatted with MP3/WMA folders, press the TUNE/FF-REW/ FOLD ER button to scroll through the available folders.
7
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.