Motorola Moto Insta-Share Projector Getting Started Guide

INSTA-SHARE PROJECTOR

Attach your Moto Mod™

Moto Mod

Connectors

Align the camera lens on the back of your phone
with the projector, and then align the sides and
bottom of the phone with the projector until they
snap together.

Note:

Make sure the connectors are clean and dry.

Also, remove your phone case if you use one.

Caution:

Before using your device, please read
the safety, regulatory, and legal information at
the back of this guide.

1Attach your Moto Mod™

Quick setup

Power button

Press & hold to
start/stop projecting.

Focus wheel

Air vent

Air vent

(on back)

When you attach the projector, your phone
automatically guides you through setup. Follow
the on-screen instructions to get started.

Start projecting

Aim the projector away from your eyes at a
light-colored wall or ceiling in a darkened room.
Press and hold the projector’s Power button until
the projector turns on to begin projecting.

Tip:

While projecting, press the Power button to

adjust settings, like brightness. See more settings

page 3

on

.

War ni ng:

Avoid looking directly at the projector

lamp. The bright light may damage your eyes.

2Quick setup

Adjust settings

To

focus

the image, use the focus wheel next to

the projector’s lamp.
Or, with the projector on, press the Power button

to adjust these settings on your phone screen:

• Keystone image correction

of the projection to make the image
rectangular.

•Brightness

(not your phone’s brightness).

: Adjust the projection brightness

: Change the angle

Remove it

To detach the projector
from your phone, place
your finger in the notch
at the bottom of the
projector and pull it
away from your phone.

Note:

Be careful not to
put your finger in the
phone’s USB charging
port.

3Adjust settings