Medion MD 41049 user Manual
GB 20
Contents
Installation..........................................................................................21
Take out screw before installation........................................................21
DIN Front-Mount (Method A) ...............................................................21
Installing the unit.........................................................................21
Removing the unit.......................................................................22
DIN Rear-Mount (Method B)................................................................23
Using the detachable front panel .........................................................24
Wiring Connection ...............................................................................25
Operation............................................................................................26
Switching on/off the unit and illuminating ............................................26
Faceplate release ................................................................................26
Sound adjustment................................................................................26
Loudness .............................................................................................27
Display .................................................................................................27
Equalization .........................................................................................28
Liquid crystal display (For LCD version only) ......................................28
Flashing LED .......................................................................................28
Reset function......................................................................................28
Radio operation .................................................................................28
Searching to radio mode.............................................................28
Selecting the frequency band .....................................................28
Selecting station .........................................................................28
Automatically memory storing & program scanning
.......................29
Station storing.............................................................................29
Frequency scan (for without seven color LCD version only)..................
29
RDS (Radio Data System) operation..........................................29
EON TA LOCAL Mode ........................................................................30
EON TA DISTANCE Mode ..................................................................30
CD operation ......................................................................................31
Switching to CD mode ................................................................31
Selecting tracks ..........................................................................31
Pausing playing ..........................................................................31
Previewing all tracks...................................................................31
Repeating the same track...........................................................31
Playing all tracks in random........................................................31
Ejecting a disc.............................................................................31
MP3 operation (For with MP3 operation version only)...................32
Switching to CD (MP3) mode .....................................................32
Ejecting a disc.............................................................................32
Selecting tracks in single step ....................................................32
Selecting directory up/down........................................................32
Pausing playing ..........................................................................32
Previewing all tracks...................................................................32
Repeating the same track...........................................................32
Playing all tracks in random........................................................32
Selecting tracks by AMS/MP3 button..........................................32
Display information .....................................................................33
Mixed-CD operation (for with mixed-CD operation version only)
.............
33
Disc notes ............................................................................................34
Specification ........................................................................................35
Trouble shooting................................................................................36
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 20
GB 21
Installation
GB
53 mm
182 mm
30°
Take out screw
before installation
Notes:
• Choose the mounting location
where the unit will not interfere
with the normal driving function of
the driver.
• Before finally installing the unit,
connect the wiring temporarily
and make sure it is all connected
up properly and the unit and the
system work properly.
• Use only the parts included with
the unit to ensure proper installation.
The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer
if installation requires the drilling
of holes or other modifications of
the vehicle.
• Install the unit where it does not
get in the driver's way and cannot
injure the passenger if there is a
sudden stop, like an emergency
stop.
• If installation angel exceeds 30°
from horizontal, the unit might not
give its optimum performance.
• Avoid installing the unit where it
would be subject to high temperature, such as from direct
sunlight, or from hot air, from the
heater, or where it would be subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit be can properly installed
either from "Front" (conventional DIN
Front-mount) or "Rear" (DIN Rearmount installation, utilizing theraded
screw holes at the sides of the unit
chassis). For details, refer to the
following illustrated installation
methods.
Take out screw before intallation
Before install the unit, please remove
the two screws.
DIN FRONT-MOUNT (METHOD A)
Installing Opening
This unit can be installed in any dashboard having an opening as show
below:
Installing the unit
Be sure you test all connections first,
and then follow the steps to install the
unit.
1. Make sure the ignition is turned
off, and then disconnect the cable
from
the vehicle battery's negativ
(-) terminal.
2. Disconnect the wire harness and
the antenna.
3. Press the release button on the
front panel and remove the
control panel (see the steps of
¨using the detachable front
panel¨).
4. Lift the top of the outer trim ring
then pull it out to remove.
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 21
GB 22
Installation
Mounting Bolt
Hex Nut
Plain Washer
Trapping Screw
Spring Washer
Metal Strap
Screwdriver
Sleeve
Dashboard
Tabs
L Key
Sleeve
R Key
5. The two supplied keys release
tabs inside the unit's sleeve so
you can remove it. Insert the keys
as far as they will go (with the
notches facing up) info the
appropriate slots at the left and
right sides of the unit. Then slide
the sleeve off the back of the unit.
6.
Mount the sleeve by inserting the
sleeve
into the opening of the
dashboard and bend open the
tabs located around the sleeve
with a screwdriver. Not all tabs
will be able to make contact, so
examine which ones will be most
effective. Bending open the
appropriate tabs behind the
dashboard to secure the sleeve in
place.
7. Reconnect the wire harness and
the antenna and be careful not to
pinch any wires or cables.
8. Slide the unit into the sleeve until
it locks into place.
9. To further secure the unit, use the
supplied metal strap to secure the
back of the unit in place. Use the
supplied hardware (Hex Nut (5
mm) and Spring Washer) to
attach one end of the strap to the
mounting bolt on the back of the
unit. If necessary, bend the metal
strap to fit your vehicle's mounting area. Then use the supplied
hardware (Tapping Screw (5 x 25
mm) and Plain Washer) to attach
the other end of metal strap to a
solit metal part of the vhicle under
the dashboard. This strap also
helps ensure proper electrical
grounding of the unit. Note to
in
stall the short threading terminal
of the mounting bolt to the back of
the unit and the other long threading to the dashboard.
10. Reconnect the cable to the
vehicle battery's negative (-)
terminal. Then replace the outer
trim ring and install the unit’s front
panel (see the steps of ¨using the
detachable front panel¨).
Removing the unit
1. Make sure the ignition is turned
off, then disconnect the cable
f
rom the vehicle battery’s negative (-)
terminal.
2. Remove the metal strap attached
the back of the unit (if attached).
3. Press the OPEN button to slide
down the front panel.
4. Lift the top of the outer trim ring
then pull it out to remove it.
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 22
GB 23
Installation
GB
Side View showing
Scew Holes marked
T, N or S
Factory Radio
Mounting Bracket
Screw
Screw
Dashboard or Console
5. Insert both of the supplied keys
into the slots at the middle left
and right sides of the unit, then
pull the unit out of the dashboard.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota or
S
uzuki, follow these mouning instructions.
Use the screw holes marked
T (Toyota), N (Nissan) or S (Suzuki)
located on both sides of the unit to
fasten the unit to the factory radio
mounting brackets supplied with your
vehicle.
To fasten the unit to the factory radio
mounting brackets:
1. Use a screwdriver to loose the
hook’s screws on the front left
and right sides of the unit and
remove the hooks.
2. Align the screw holes on the
bracket with the screw holes on
the unit, and then tighten the
screws (5 x 5 mm) on each side.
Note:
The outer trim ring, sleeve and the
metal strap are not used for method B
installation.
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 23
GB 24
Using the detachable front panel
Front Panel
Protective Case
Open
The right side
The left side
Front Panel
The right side
The left side
Front Panel
To detach the front panel
1. Press the OPEN button, then the
front panel will be folded down.
2. To remove the front panel, lift it up
at a little angle from horizontal
position, then first pull out the
right side and then pull out the left
side.
3. For safekeeping, store the front
panel in the supplied protective
case immediately after being
removed.
To install the Front Panel
1. To install the front panel, first
insert the left side into proper
position. Then insert the right side
into place.
2. When the two sides are fixed into
place, push the front panel into
main unit.
3. Note that if the front panel fails to
lock in position properly, pressing
control button may not function
and the display may be missing
some segments. Press the OPEN
button and then reinstall the front
panel again.
Precautions when handling
1. Do not drop the front panel.
2. Do not put pressure on the
display or control buttons when
detaching or re-installing the front
panel.
3. Do not touch the contacts on the
front panel or on the main unit
body.
It may result in poor electrical
contact.
4. If any dirt or foreign substances
adhered on the contacts, the can
be removed with a clean and dry
cloth.
5. Do not expose the front panel to
h
igh temperatures or direct sunlight
in anywhere.
6. Keep away any volatile agents (e.
g
. benzene, thinner, or insecticides
)
from touching the surface of the
front panel
7. Do not attempt to disassemble
the front panel.
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 24
GB 25
Wiring connection
GB
Note: 1. For 2-speakers system, green, violet, White/black and grey/black
wire leads are unconnected and isolated.
2. For 2-speakers system keep the fader indicator at center position
to maintain the existing volume level.
Antenna connector
Ignition switch
(ACC+)
red
pink
black
yellow
blue/black
blue
green/black
green
Memory
Back-up (B+)
Ground (B-)
Power
Antenna
front left
speaker
white/black
white
grey/black
grey
rear right
speaker
left white
right red
Main Unit
rear RCA cable
front right
speaker
rear left
speaker
Fuse
Fuse
4-Speakers System2-Speakers System
left
speaker
blue
green
2-Speakers System4-Speakers System
right
speaker
white
grey
(For RCA line out version only)
Manual_41049_GB 29.04.2004 0:25 Uhr Seite 25
Loading...