McIntosh MAC7200 Panel Connections

1A

MAC7200 Rear Panel Connections

Right OUTPUT
connections for a
2, 4 or 8 ohm
Loudspeaker

DIGITAL AUDIO INPUTS
for components with Digital
Optical and Coaxial Out­puts sending digital audio
signals

USB DIGITAL AUDIO
INPUT for connection
to a computer

MCT DIGITAL AUDIO
INPUT for streaming
high bandwidth digital
signals from SACD/CD
Transport Components

DATA PORTS send signals
to Source Components
to allow control with the
MA7200 Remote Control

SERVICE PORT
for service use
only

75 OHM FM ANT
(Antenna) connects
to an external FM
Antenna or cable

RAA2 AM ANT (An­tenna) connector allows
the supplied McIntosh
AM Remote Antenna to
be connected

IR INput for
signals from a
compatible IR
Room Sensor

POWER CONTROL
OUTPUTS TRIGger 1
and 2 send turn On/Off
signals to assignable
components

POWER CONTROL MAIN OUTPUT
sends turn On/Off signals to a McIn­tosh Component when the MA7200 is
switched On/Off

Left OUTPUT
connections for a
2, 4 or 8 ohm
Loudspeaker

Connect the MAC7200 power
cord to a live AC outlet. Refer to
information on the back panel of
your MAC7200 to determine the
correct voltage for your unit

Main Fuse holder, refer
to information on the
back panel of your
MAC7200 to determine
the correct fuse size
and rating

OUTPUTS 2 send signals
to Power Amplifiers and are
switched On/Off with the Front
Panel Output 2 Push-Button or
Remote Control Push-Button

JUMPER PLUGS connect
the Preamplifier OUT­PUT 1 Jacks to the PWR
AMP INPUTS Jacks and
are required for normal
operation

PWR AMP INPUTS
accept signals from the
internal Preamplifier
or a separate external
Preamplifier

UNBALANCED INPUTS
1 thru 5 accept high level
program source signals

GND terminal
accepts a ground
wire from a
turntable

PHONO MC accepts
the low level signals
from a Moving Coil
Phono Cartridge

PHONO MM accepts
signals from a Mov­ing Magnet Phono
Cartridge

RS232 connector1
for connection to a
computer or other
control device

BALANCED INPUTS
accept high level pro­gram source signals

POWER CONTROL
PASSTHRU INPUT
receives turn On/Off
signals from an Audio/
Video Control Center

1

Refer to page 4 of the MAC7200 Owner’s

Manual for addition cable information.

McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: [phone] FAX: [phone] Part No. 04177900