Lexicon MC-1 Owners manual

MC-1 Digital Controller Quick Reference Guide

Finding your way through the Menus

On the remote control,
press SELECT.

Use ▲ or ▼ to highlight an
item. Press SELECT to
open a submenu.

Continue highlighting and
SELECTing to reach the
parameter you want to
change.

Adjust parameters with ▲
or ▼. Your changes are
saved automatically.

Press DONE to step back
and exit each display.

Lexicon Part # 070-13279

Lexicon, Inc. 3 Oak Park • Bedford MA 01730-1441 USA • Tel: [phone] • Fax: [phone] • www. lexicon.com

© 1999 Lexicon, Inc.

Lexicon Part # 070-13279

MC-1 Digital Controller Quick Reference Guide

Zone 2 controls can be accessed from either the MC-1
front panel, or the remote control by pressing and holding
down the Record/Zone 2 button in conjunction with the
buttons shown below.

Record/Zone 2 ControlAlternate Remote Control Functions

Make a note of any programs, setup or calibration
values you want to re-enter, as this procedure will
reset all MC-1 parameters to their default states.
as well as all setup and calibration values.

Restoring Factory Defaults

Using the remote, turn the
unit OFF, then ON, then
press and hold MUTE. The
on-screen display will
read:

FACTORY PRESETS MENU

EXIT

RESTORE DEFAULTS

Lexicon, Inc. 3 Oak Park • Bedford MA 01730-1441 USA • Tel: [phone] • Fax: [phone] • www. lexicon.com

To resume normal opera­tion without restoring all de-
faults, press SELECT.

To clear and reload all pre­set effects and all factory
settings, use ▼ to highlight
RESTORE DEFAULTS,
and press SELECT.

When the message:

FACTORY PRESETS MENU

FACTORY DEFAULTS

RESTORED

is displayed, press DONE to
return to normal operation.

© 1999 Lexicon, Inc