KitchenAid KSSC36FTS, KSSC36QTS, KSSC42FTS, KSSC42QVS, KSSC48FTS Dimension Guide
...
Side by Side Built-In Refrigerator
PRODUCT MODEL NUMBERS
KSSC36FT |
KSSC48QV |
KSSS36FT |
KSSC36QT |
KSSO36FT |
KSSS36QT |
KSSC42FT |
KSSO36QT |
KSSS42FT |
KSSC42QT |
KSSO42FT |
KSSS42QT |
KSSC42QV |
KSSO42QT |
KSSS48FT |
KSSC48FT |
KSSO48FT |
KSSS48QT |
KSSC48QT |
KSSO48QT |
|
Electrical: A 115 Volt, 60 Hz., AC only 15or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
A grounded 3 prong electrical outlet should be placed within 4" (10.2 cm) of the right side cabinets or end panel.
Water Supply: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber.
IMPORTANT: If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure coming out of the reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa).
The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor or the back wall.
Location: Do not install the refrigerator near an oven, radiator, or other heat source, or in a location where the temperature will fall below 55°F (13°C). Floor must support the refrigerator weight, more that 600 lbs (272 kg), door panels and contents of the refrigerator.
OPENING DIMENSIONS
To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one isnot available, then the refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to 90" (203 cm to 229 cm) above the floor. See “Install Anti-Tip Boards” for more information.
NOTE: A clearance of 1⁄2" (1.3 cm) above the top grille must be maintained in order for the top grille to be removed.
|
80" - 90" |
|
|
|
|
|
|
(203-229 cm) |
B |
|
|
|
|
|
|
|
|
|
|
|
|
|
Dimension |
|
|
|
|
|
|
|
|
Width A |
Width A for |
|
|
|
|
|
Overlay Models Dimension B |
||
|
|
|
Model |
(as shown) |
(as shown) |
(as shown) |
83¹⁄ " (212.1 cm) min. |
|
36 |
35 ¹⁄ " to 35 ³⁄ " 35³⁄ " to 36" |
4" (10.2 cm) |
||
|
|
(90.2 cm to |
(90.8 cm to |
|
||
84³⁄ " (215 cm) max. |
|
|
|
|||
to bottom of solid soffit |
|
|
90.8 cm) |
91.4 cm) |
|
|
|
|
|
42 |
41 ¹⁄ " to 41 ³⁄ " 41³⁄ " to 42" |
10" (25.4 cm) |
|
|
|
|
|
(105.4 cm to |
(106 cm to |
|
|
|
77" |
|
106 cm) |
106.7 cm) |
|
|
|
48 |
47 ¹⁄ " to 47 ³⁄ " 47³⁄ " to 48" |
16" (40.6 cm) |
||
|
|
(196 cm) |
||||
|
|
|
|
(120.7 cm to |
(121.3 cm to |
|
|
|
|
|
121.3 cm) |
121.9 cm) |
|
|
A |
|
|
|
|
|
|
Width |
|
|
|
|
|
|
(see chart following) |
|
|
|
|
|
|
|
6" |
|
|
|
|
|
|
(15.2 cm) |
|
|
|
|
|
1" |
|
|
|
|
|
6" |
(2.54 cm) |
6" |
|
|
|
|
(15.2 cm) |
(15.2 cm) |
|
|
|
||
|
24" |
|
|
|
|
|
|
(60.96 cm) min. |
|
|
|
|
|
IMPORTANT:
■Flooring under refrigerator must be at same level as the room. Face of cabinetry must be plumb.
■The width of the opening (Width A), must be as specified for your model, for at least 2" (5.08 cm) back from the face of the cabinet. If your opening does not meet this requirement, you will need to make modifications.
PRODUCT DIMENSIONS
■The power cord is 84" (213 cm) long.
■The line attached to the back of the refrigerator is 5 ft. (1.5 m) long.
■Width dimensions were measured from trim edge to trim edge.
■The depth from the front of the top grille to the back of the refrigerator cabinet is 25 3⁄8" (64.5 cm).
■Height dimensions are shown with leveling legs extended 1⁄8" (3mm) below the rollers.
SIDE VIEW
25³⁄ "
(64.5 cm)
23¹⁄ "
(59.7 cm)
*83³⁄ "
(211.8 cm)
84" (213.4 cm) Power Cord
*3¹⁄ " (8.9 cm)
*When leveling legs are fully extended to 11⁄4" (3.2 cm) below rollers, add 11⁄8" (2.9 cm) to the height dimensions.
TOP VIEW
A
25³⁄"
(64.5 cm)
|
|
|
|
|
|
|
|
|
|
|
Model |
Width A |
||
|
|
|
|
|
|
36 |
35" (88.9 cm) |
||
|
|
|
|
|
|
42 |
41" (104.1 cm) |
||
|
|
|
|
|
|
48 |
47" (119.4 cm) |
||
|
|
|
|
|
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10555563 |
Instructions packed with product. Specifications subject to change without notice. |
5/3/13 |
Loading...