KENWOOD TKR-851 User Manual

VHF FM REPEATER/ UHF FM REPEATER
TKR-751/ TKR-851
INSTRUCTION MANUAL
© B62-1775-00 (K) 09 08 07 06 05 04 03 02 01 00
THANK YOU!
We are grateful you purchased this KENWOOD repeater. We believe this easy-to-program repeater will be highly effective in your communications system, and will keep personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced technology into all of our products. As a result, we feel strongly that you will be pleased with the quality and features of this product.
FEATURES
Easily program channel data using the KPG-91D software on a PC.
Recall 1 of 16 preset channels using either a PF key or the external control line.
•Write the firmware to the Flash memory through an external source.
Program QT/DQT signalling on each channel to simultaneously decode up to 16 different QT tones/DQT codes.
Operate the repeater with the air remote control function.
Use the interface port with external equipment, such as a repeater controller.
Multi-mode capable:
TKR-751: Wide: 30 kHz/ 25 kHz/ Narrow: 15 kHz/ 12.5 kHz TKR-851: Wide: 25 kHz/ Narrow: 12.5 kHz
Adjust the following functions using a PC:
Battery operating tone deviation
Battery warning tone deviation
Courtesy tone deviation
CW ID deviation
DTMF deviation
DQT balance
DQT deviation
Maximum deviation
QT deviation
Repeat gain
RF output power
RF power down detect
RX audio signal output (RA)
RX detector signal output (RD)
RX frequency
Squelch
•Test tone deviation
TX audio signal input (TA)
TX frequency
TX signalling deviation (TD)
PRECAUTIONS
Do not expose the unit to rain or moisture; to prevent fire or electric shock.
Do not open the unit under any circumstances; to avoid risk of electric shock.
Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances.
Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces.
If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately. Contact your KENWOOD service center or dealer.
NOTICES TO THE USER
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
Government law prohibits the operation of unlicensed radio transmitters within the territories under government control.
Illegal operation is punishable by fine and/or imprisonment.
Refer service to qualified technicians only.
This repeater is intended for use as a fixed base station with the antenna located outdoors on the rooftop or on an antenna tower.
UNPACKING AND CHECKING EQUIPMENT
Note: The following unpacking information is for use by your KENWOOD dealer, an authorized KENWOOD service center, or the factory.
Carefully unpack the repeater. We recommend that you identify the items listed in the following table before discarding the packing material. If any items are missing or have been damaged during shipment, file a claim with the carrier immediately.
metI rebmuNtraP ytitnauQ
erutxiferawdraHXX-2048-12J1
ssalgtnorFXX-5362-01B1
retliFXX-9521-11B1
noihsuCXX-1081-31G4
noihsuCXX-2081-31G4
tooFXX-5740-20J2
tooFXX-2940-20J2
temmorGXX-2030-95J2
eldnaHXX-8140-10K1
swercSXX-6003-53N5
swercSXX-6004-03N2
drocCDXX-7243-03E1
elbacrotcennoCXX-8223-13E1
esuFXX-2301-60F1
)ylnoepytK(dracytnarraW—1
launamnoitcurtsnIXX-5771-26B1
INSTALLATION
To install the handles onto the front panel of the repeater, align the handles with the holes on the front panel, then secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and antenna.
MICROPHONE
Connect an optional KMC-27A, KMC-27B, or KMC-9C KENWOOD microphone to the MIC jack on the front panel.
CONTROLS AND FUNCTIONS
Front Panel
VHF FM REPEATER TKR-751
qq
q
qq
oo
o
oo
ww
w
ww
ii
i
ii
uu
u
uu
ee
e
ee
rr
r
rr
yy
y
yy
tt
t
tt
* The TKR-751
is shown in this diagram.
qq
q Speaker
qq ww
w CH/STATUS Display
ww
Two 7-segment digits display the channel number, name, or status.
ee
e VOLUME control
ee
Rotate to adjust the volume.
rr
r DC SOURCE switch
rr tt
t Power indicator
tt
Lights green when power is applied from the DC 13.6V jack. Lights red when power is applied from the BACK UP battery terminal.
Rear Panel
qq
ww
q
w
qq
ww
uu
u
uu
qq
q TX OUT jack
qq
Connect a TX antenna or a duplexer to this receptacle.
ww
w CONTROL I/O jack
ww
Connect an external programming device or repeater controller to this DB-25interface.
ee
e FUSE
ee
Insert 10 A blade fuses into these fuse holders.
yy
y MIC jack
yy
Connect a microphone to this 8-pin modular jack.
uu
u Programmable Function keys
uu
Press these keys to activate their programmable functions.
ii
i BUSY indicator
ii
Lights green while a signal is being received.
oo
o TX indicator
oo
Lights red while transmitting.
rr
ee
r
e
rr
ee
tt
yy
t
y
tt
yy
rr
r RX IN jack
rr
Connect a RX antenna or a duplexer to this BNC receptacle.
tt
t DC 13.6V jack
tt
Connect a 13.6 V DC power supply to this jack.
yy
y BACKUP battery terminal
yy uu
u TEST/SPKR jack
uu
Test input/output jack. Connect an external speaker to this jack.
REPEATER OPERATION
Note: Please consult your dealer for programming the repeater.
When power is applied to the unit, the Power indicator lights:
Green when using the main DC jack.
Red when using the Backup terminal. Rotate the VOLUME control to adjust the volume. The BUSY indicator lights green while receiving a signal and
the TX indicator lights red while transmitting.
TRANSCEIVER OPERATION
Receive
Adjust the volume to your desired level. You may need to readjust the volume when you receive a message from your dispatcher or another member in your fleet.
The BUSY indicator lights green while a signal is being
received.
Transmit
1 Listen to the channel before transmitting, to make sure it
is not being used.
2 Press the microphone PTT switch, then speak in your
normal speaking voice.
The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.
Loading...
+ 1 hidden pages