Kenwood TK-860G, TK-862G SPECIFICATIONS
TK-860G/(N)/862G/(N
)
TK-860G/(N)/862G/(N
BLOCK DIAGRAM
)
TK-860G/(N)/862G/(N
)
77
Receiver Section
TK -860G/(N)/862G/(N
)
TK-860G /(N)/862G/(N
)
LEVEL DIAGRAM
Center Frequency 49.95MHz 450kHz Audio Frequency
To make measurements in the RF section, connect the RF
level meter.
In the RF section, use a 0.01µF coupling capacitor.
(The display shows the SSG input value required to obtain
12dB SINAD.)
W/N 540mVrms
SW 432mVrms
To make measurements in the AF section, connect the AC level meter.
(ANT input : –53dBm, 1kHz FM, 3kHz DEV (Wide) / 2.4kHz DEV (Semi wide) / 1.5kHz DEV (Narrow))
The AF output level is adjusted for 0.45V/4Ω by the front panel AF VOL control.
W/N 520mVrms
SW 416mVrms
W/N 630mVrms
SW 504mVrms
Transmitter Section
W/N 5.0mVrms
SW 4.0mVrms
To make measurements in the AF section, connect the AC level meter.
AG is set so that MIC input becomes 3kHz/2.4kHz/1.5kHz (Wide/Semi wide/Narrow) DEV at 1kHz MOD.
Control Unit TX-RX Unit VCO Unit TX-RX Unit Power Module TX-RX Unit
W/N 11.2mVrms
SW 8.96mVrms
W/N 450mVrms
SW 360mVrms
W 110mVrms
SW 96mVrms
N 54mVrms
W 110mVrms
SW 96mVrms
N 54mVrms
To make measurements in
the RF section, connect the
RF wattmeter (50Ω).
7978
Loading...