Kargo Master 30060 User Manual
®
2 BAR ECONO CAMPER SHELL RACK
For TECHNICAL SUPPORT Call:
Monday- Friday 8:00 A.M. to 4:30 P.M. (PACIFIC )
1-800-343-7486
BOLT KIT
A
(8 ea.)
3/8" x 1 3/4"
Hex Bolt
(5 ea.)
1/2" Lock Washer
(8 ea.)
P
1/2" x 1"
Hex Bolt
B
(8 ea.)
3/8" Flat Washer
C
(8 ea.)
3/8" Lock Nut
O
Assembly Instructions
D
(8 ea.)
3/8" x 1/2"
Allen Head
Set Screw
H
(15 ea.)
1/2" SAE Flat Washer
#30060
Leg
Mount Plate
H
CHECK TWICE - DRILL ONCE!
A
INSIDE
BED WALL
B
O
P
Be sure FRONT MOUNTING PLATES are as far
STEP 1-
forward towards the cab as possible. Find the pre-drilled hole
in the footplate that is furthest from the leg and drill
through truck’s bed rail. You must drill a second bolt hole through
both the footplate and the truck’s bed rail. Locate this second hole
as close as possible to the front leg, but making sure you can
access the end of the bolt underneath the truck’s bed rail as
necessary to put on the washer and nut. Attach the footplate to
the truck using bolts
NOTE: If it is not possible to locate a second hole close to the front
leg because of the stake pocket, use our stake pocket T bolt mount
kit (#31560) purchased separately.
A, washers B and nuts C .
C
3/8” hole
DO NOT OVER TIGHTEN ON DOUBLE WALL BED CONSTRUCTION, AS THIS MAY DEFORM THE SHEET METAL OF THE PICKUP BED!
STEP 2- Replace camper shell with appropriate weather stripping . Attach legs
loosely to mounting plates with bolts
( HIGH POSITION )
D
STEP 3- Your rack can be set high or low by flipping the CROSSBAR SUPPORT, (as shown) Determine
which is best for your vehicle and your cargo. For bowed canoes, we recommend the high position.
STEP 4- Plug the TOP of the CROSSBAR SUPPORT UPRIGHT with caps provided.
Crossbar Support Upright
P, lock washers O, and flat washers H.
H
O
P
Outside of
Truck Bed
CAMPER SHELL
STEP 5- Insert the CROSSBAR into the CROSSBAR SUPPORTS and set the entire
( LOW POSITION )
assembly on top of the legs. Cut CROSSBAR to shorten length, IF NEEDED, for the width
of a mini-truck bed. CENTER THE CROSSBAR LEFT TO RIGHT, and secure with set
screws. Secure the CROSSBAR SUPPORT UPRIGHT to each leg with set screws.
• To install the rear ECONO TRUCK RACK on your truck bed, repeat the above. Before drilling the mounting plate, make sure that the plate
dose not overhang or interfere with the tail gate. Before inserting the Caps, make sure that the height setting in the rear matches the height
setting in the front.
Tighten all bolts and....
THAT'S IT!
You're ready to load and go!
Loading...