John Deere Seedstar 3 Aircart User Manual
SeedStar™3
AirCart
Quick Reference Guide
Meter Control
Select to engage and
disengage tank meters.
When colored:
Yellow – Low Rates and
granular products.
Black – Regular rates.
Green – High volume rates.
Blue – Very high rates.
Orange – Large seeds.
SectionCommandTM Status
When colored:
Green – Open.
Black – Closed by
SectionControlTM.
– Closed manually by
SectionCommandTM.
Red – SectionCommand
and gate status do
not match.
TM
Select to view tank
pressurization gauges.
Indicates if the stairs are
unable to raise.
2204 lb 4409 lb 6614 lb 17637 lb
lb/
0.0
ac
lb/ac
6.0 90.0 110.0 128.0
r/min
1639
1885
3.22
mph
0.0
lb/
ac
Tank Level
lb/
0.0
ac
1103.3
ac
Tank Scale Weight
lb/
0.0
ac
ActiveCal
1
Decrease or increase rate
Section
Command
ActiveCal
Air Cart Main
Select for main run page.
Meter Setup
Select to define crops
and rates.
Warning Setup
Select to set tank warnings.
Air Cart Setup
Select to configure cart
and tool.
Totals
Select to view acres and
hour meters.
ActiveCal
Select to perform meter
calibration procedure.
TM
Blower Speed
Select to set
blower speed
for warnings.
Main Drive
Select to engage
and disengage all
meter drives.
Variable Rate Selection
Select to choose a
programmed rate.
Use plus and minus
buttons to adjust
variable rates for
each individual meter.
Configurable for the following:
• Ground Speed
• Field 1 Area Counter
• Field 2 Area Counter
• Productivity
Select to activate or
deactivate independent
cart brake. Horizontal
bar graph indicates the
brake status.
Section
Command
Diagnostics
Select to display diagnostic
information.
SectionCommand
Select for Section
Command run page.
TM
Cart and Tool SetupSectionCommandTM Run Screen
Section
Command
Enable/Disable
Sections, Individually.
Status Closed by
SectionControlTM.
Status Closed Manually
by SectionCommandTM.
Section Command
1 2 3 4 5 6 7 8
ENABLE ALL
Inner Outer ON/OFF
Meter Gate Open.
Setup
Cart Tool Sensor
SectionCommand
and gate status
do not match.
TM
Remote
Switch
Dual Blower
850
Size
Can Height Sensor
Section
Command
Independent
ActivCal
Cart Braking
Indicates Cart Size (Bushels).
Select Type of Tool Remote
Switch (Height Sensor, CAN
Height Sensor or None).
Enable and Disable
Section Command.
Enable and Disable
Independent Cart Braking.
Enable and Disable
Dual Blower.
Select Tool Model.
ActivCal
Section
Command
Setup
Cart Tool Sensor
Section
Command
Enable All
Sections.
Press to Input Section
On/Off Times.
Model
Width
Row
Spacing
Dual Blower
1870
23.2m (76ft)
30 5m m (12 in)
75.98 f t
DS
ActivCal
Section
Command
Enable and Disable
Double Shoot.
Select Nominal Tool width.
Select Row Spacing.
Press to Congure Rows
per Primary (if needed).
Loading...