Jaguar XK 2003 User Manual

V8 XJ Series/XK

DA TE

02/03

Amended 04/03

303-60

SERVICE

Coolant Pumps –

Identifying Impeller Material –

Pump Replacement Guidelines

Remove and destroy Bulletin 303-60, dated 02/03.
Replace with this Bulletin.
Revisions are marked with a bar and in bold text.

Issue:

A large number of V8 coolant pumps are replaced unnecessarily for the following reasons:

• routinely following an engine overheat condition,

• incorrect diagnosis of leakage, or

• incorrect identification of impeller material.
As a result, a significant proportion of warranty returns have been identified with no fault found.

TECHNICAL BULLETIN

MODEL

1997 MY-ON XK8 Range

1998-2003 MY V8 XJ Series

VIN

812256-F59525

001001-ON

Action:

Note the following guidelines before replacing a V8 coolant pump:

OVERHEATING

Before replacing the coolant pump following an overheating condition, observe the following
guidelines:

VIN 001036-028000 (XK series) and VIN 812256-843500 (V8 XJ series)

Check the part number on the body of the coolant pump, following the procedure below. Replace
the coolant pump if the part number is:

96JV-8501-CA,
96JV-8501-CB,
96JV-8501-CC or
96JV-8501-CD

Checking coolant pump part number

Note: The following procedure is for checking the coolant pump part number

only; any other repairs are to be carried out as a separate Warranty Claim.

Date of issue 02/03 Amended 04/03 Bulletin Number 303-60 Page 1 of 3

LOCATION OF COOLANT PUMP P A RT NUMBER

ILLUSTRATION 1

1. Remove coolant pump pulley. (See Workshop Manual, JTIS CD ROM, 1998 MY, section:
303-03, SRO 26.50.05)

Note: For all affected model years refer to JTIS procedure for 1998 MY V8
XJ and XK series vehicles. The procedure is not listed under any other
model year.

2. Check coolant pump part number . If any of the part numbers are as follows, 96JV-8501-CA,
CB, CC or CD, replace the coolant pump. (Illustration 1).

3. Install the coolant pump pulley . (See Workshop Manual, JTIS CD ROM, section: 303-03,
SRO 26.50.05).

Note: For all affected model years refer to JTIS procedure for 1998 MY V8
XJ and XK series vehicles. The procedure is not listed under any other model
year.

VIN 028001-on (XK series) and VIN 843501-on (V8 XJ series)

It is not necessary to remove the coolant pump pulley for inspection unless unless there is a
genuine coolant pump concern.

Do not replace these coolant pumps as a matter of Policy.

LEAKAGE

Note: Do not assume that staining around the exterior of the coolant pump
body is due to a coolant pump leak. Check the cooling system joints, for
leaks, in the area above the coolant pump. For any cooling system issues
follow the workshop procedure as detailed in JTIS for checking/diagnosing
the cooling system.

On replacement engines, it is not necessary to replace the coolant pump, unless the coolant pump
being transferred has one of the part numbers listed above.

Page 2 of 3 Bulletin Number 303-60 Date of issue 02/03 Amended 04/03