Honda CBR600RR '03 Service Manual Chapter 20 - Lights, Meters And Switches
Specifications and Main Features
- Lighting Elements or Bulbs
- For Headlight:
- Hi: 12 Volt – 55 Watts
- Lo: 12 Volt – 55 Watts
- Position light: 12 Volt – 5 Watts
- Brake And Tail Light: LED
- Turn Signal Light: 12 Volt – 21 Watts 4
- Instrument Light: LED
- Turn Signal Indicator: LED
- High Beam Indicator: LED
- Neutral Indicator: LED
- PGM-FI Warning Indicator: LED
- Spacers And Fuses
- Fuses
- Main Fuse: 30 Amps
- PGM-FI Fuse: 20A
- Other Fuses: 10AX4, 20AX2
- Tachometer Peak Voltage : 10.5 and above
- ECT Sensor Resistance:
- For 80 C (176 F), ECT sensor resistance is 2.1 2.6kΩ
- For 120 C (248 F), ECT sensor resistance is 0.65 0.73kΩ
- Torque Values:
- ECT Sensor: 23N·m (2.3kgf·m, 17lb·ft)
- Side Stan Switch Bolt: 9.8N·m (1.0kgf·m, 7lb·ft)
- Ignition Switch Mounting Bolt: 25N·m(2.5kgf·m, 18 lb·ft
- Oil Pressure Switch: 12N·m (1.2kgf·m 9 lb·ft)
- INR-Wr TMS: I O N·m (0.2 kgf·m I 1.4 lb·ft)
- Neutral Switch: 12N·m (1.2kgf·m 9 lb·ft)
Frequently Asked Questions
Q: What type of headlight bulb is used in this device?
A: 12V - 55Watts is the type of high beam headlight bulb that is fitted in this model.
Q: What is the process of testing the oil pressure switch?
A: We can bypass the wire with the oil pressure switch to the ground and observe if the oil pressure warning gauge turns ON with the ignition switch set to the ON position. First , take off the terminal screw and dust cover, and then access the oil pressure switch.
Q: What is the torque specification for an ECT sensor?
A: The rated torque for ECT sensor is 23 N·m (2.3 kgf·m, 17 lb·ft).
Q: I have a faulty speedometer, what steps do I take to fix it?
A: Confirm the voltage at the VSS connector, assess the battery charge status, ensure proper functioning of the fuses, this is a checklist that is usually followed during the troubleshooting of speedometers; but not in its entirety since specific wires can be designated for continuity tests.
Q: The turn signal light is not functioning, how do I go about it?
A: Inspect the turn signal relay if all bulbs, fuses, ignition switch, and signal switch are present and functional for damage.
User Manual
Loading...