Hardware Installation
1.Connect the receiver’s green mouse connector to the computer’s 6-pin PS/2 mouse port. Connect the receiver’s purple keyboard connector to the computer’s 6-pin PS/2 keyboard port.
2.Install two AA batteries in the mouse
and two AA batteries in the key- 
board. 
3.Turn on your computer.
4.After you open Windows, please press the button under the receiver first (RB) and then press the button under the mouse (MB) and keyboard (KB) for ID channel setting. You only have six seconds to press the receiver, the channel button on the keyboard (KB), then the receiver button again and the channel button on the mouse (MB). So you press RB, KB, RB, MB to set the channel setting.
Warning:
1.When you use Wireless TwinTouch+ Optical on a desk that is made of metal, try using a pad or reduce the receiving distance.
2.Before the first installation is completed (channel setting ready), the keyboard will not work in DOS.
3.The Wireless TwinTouch+ Optical channel provides 256 ID-codes, and it automatically selects the ID # for your keyboard and mouse. You can only set up one TwinTouch+ Optical at a time. But if you have additional TwinTouch+ Optical sets in an area of 10 square meters, more interference may occur between the receiver and your keyboard and mouse.
4.If you feel the mouse does not move smooth as usual or the keyboard does not work when typing, then the batteries have lost their charge, so please replace them. Also, the wireless icon will be blinking “red” when there is a batterylow situation. You should set up the channel every time you replace the batterires.
1
ENGLISH
5.The TwinTouch+Optical with radio frequency gives you free movement and an enjoyable experience. For optimal performance, place the receiver at least 8 inches (about 20 cm) away from the mouse and other electrical devices, such as the computer, monitor, and etc.
6.Please do not use this optical mouse on a desk which is made of glass, mirror, iron, or black velvet. Also, a flat surface is necessary or the optical sensor will not work properly.
Software Installation
1.Make sure the mouse and keyboard is connected to the computer.
2.Put the Setup disk (or CD) into the disk drive.
3.Follow the instructions on the screen to finish the software installation.
Factory Setting
1. Mouse:
Button Assignments
The Button Assignment feature lets you work in a more efficient way because you can assign the most frequently used commands in Windows to the mouse buttons.
Magic-Roller Press the “Magic-Roller” to surf the Internet and Windows documents
Left Button Provides traditional mouse functions such as click, double click and drag.
Right Button You can assign this button frequently used keyboard and mouse functions in addition to features like EasyJump, Auto-Panning, Zoom, etc.
2
Loading...