Garmin FISHFINDER 320C, GPSMAP 188C, GPSMAP 188, GPSMAP 198C FLUSH MOUNT TEMPLATE

FLUSH MOUNT TEMPLATE

GPSMAP 188C/198C & FISHFINDER 320C

3.0

TRIM TEMPLATE ALONG THIS LINE TO AID FITTING

GPSMAP 188C/198C & FISHFINDER 320C

UNIT OUTLINE

(1/8")

mm

CUT MOUNTING SURFACE
ALONG INSIDE OF THIS LINE

DRILL A 3/8" HOLE.
BEGIN CUTTING HERE.

Be very careful when cutting this hole,
there is only a small amount of clearance
between the unit and the Mounting Holes.

Drill four 3mm (1/8") mounting holes at the indicated locations.
Install the four Mounting Studs into unit by screwing the shorter section in to
the back of the unit.
Use a 1/16” (2mm) Allen Wrench to tighten the Mounting Studs until the stop
contacts the case. Be careful not to overtighten as this may damage the
Mounting Stud! The studs have a reusable thread-locking patch pre-applied from
the factory.
Place the unit in position in the cut out in the mounting surface.
Place washers over the Mounting Studs, then thread on one Hex Nut per
Mounting Stud.
Tighten all four until the unit is snug against the mounting surface.
Install and tighten the second Hex Nut on all four Mounting Studs to lock
the first one in place.

141.6 mm
(5.58")

mm

110.0
(4.33")

© Copyright 2005 Garmin Ltd. or its subsidiaries

Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U.S.A.

www.garmin.com

Part Number 190-00264-00 Rev. D February 2005 Printed in Taiwan