replacement batteries, see your Garmin dealer or the Garmin
website.
• Only replace batteries with correct replacement batteries. Using
other batteries presents a risk of fire or explosion.
• Do not leave the device where the battery cell is punctured,
or electrolyte can be released.
That can be harmful and risk fire or explosion.
Failure to heed the following notice could result in personal or
property damage, or negatively impact the device functionality.
Battery Notices
• Do not immerse the device or batteries in water or other liquids.
• Do not leave the device exposed to a heat source or in a hightemperature location, such as in the sun in an unattended
vehicle. To prevent the possibility of damage, remove the device
from the vehicle or store it out of direct sunlight, such as in the
glove box.
• Do not operate the device outside of the temperature ranges
specified in the printed manual in the product packaging.
• When storing the device for an extended time period, store within
the temperature ranges specified in the printed manual in the
product packaging.
•
Do not use a power and/or data cable that is not approved or
supplied by Garmin.
• Replaceable coin cell batteries may contain perchlorate material.
Special handling may apply. See www.dtsc.ca.gov
/hazardouswaste/perchlorate.
• Contact your local waste disposal department to dispose of the
device/batteries in accordance with applicable local laws and
regulations.
Product Environmental Programs
Information about the Garmin product recycling program and
WEEE, RoHS, REACH, and other compliance programs can be
found at www.garmin.com/aboutGarmin/environment.
Declaration of Conformity
Hereby, Garmin declares that this product is in compliance with the
Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.garmin.com/compliance.
Innovation, Science and Economic Development Canada
Compliance
This device complies with Innovation, Science and Economic
Development Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any
2
NOTICE
interference, including interference that may cause undesired
operation of the device.
Radio Frequency Radiation Exposure
This device is a mobile transmitter and receiver that uses an
internal antenna to send and receive low levels of radio frequency
(RF) energy for data communications. The device emits RF energy
below the published limits when operating in its maximum output
power mode and when used with
To comply with RF exposure compliance requirements, the device
should be installed and operated with a minimum of 20 cm (7.87 in.)
between the device and your body. The device should not be used
in other configurations. This device must not be co-located or
operated in conjunction with any other transmitter or antenna.
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and may
cause harmful interference to radio communications if not installed
and used in accordance with the instructions. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet that is on a different circuit
from the GPS device.
• Consult the dealer or an experienced radio/TV technician for
help.
This product does not contain any user-serviceable parts. Repairs
should only be made by an authorized Garmin service center.
Unauthorized repairs or modifications could result in permanent
damage to the equipment, and void your warranty and your
authority to operate this device under Part 15 regulations.
Software License Agreement
BY USING THE DEVICE, YOU AGREE TO BE BOUND BY THE
TERMS AND CONDITIONS OF THE FOLLOWING SOFTWARE
Garmin authorized accessories.