Make sure you’ve placed the bag in the proper |
between paper towel and end of bag so that bag seals |
|
place. When making a bag from a roll, make sure end |
properly with paper towel inside. |
|
of cut piece is on Sealing Strip, not over rubber gasket |
Make sure the Vacuum Mode Switch (on V375 only) |
|
or in Vacuum Channel. |
||
is set to Vacuum and Seal. |
||
|
||
Prevent moisture or liquid from being pulled into |
Make sure you give appliance time to cool down. |
|
the Vacuum Channel or trapped in the seal. Either |
||
Wait at least 20 seconds between seals. Under very |
||
pre-freeze moist foods such as raw meat for 1-2 |
||
heavy usage, appliance will shut off automatically to |
||
hours before vacuum packaging, or place a folded |
||
prevent overheating. If it does, wait 20 minutes to |
||
paper towel between food and end of bag to absorb |
||
allow appliance to cool off. |
||
excess liquids. Just be sure to leave at least 3 inches |
||
|
Tips on Removing Air from a Bag
Copyright © 2004 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc. FoodSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int’l, Inc. in the United States and other countries. All other trademarks are property of their respective owners. Tilia, Inc. and Tilia Int’l, Inc. are Jarden companies.This product is protected by one or more of the following Patents:
Make sure you’ve placed the bag in the proper |
If motor runs for more than 30 seconds without |
||
place. When vacuuming and sealing a bag, make sure |
stopping, you may need to adjust bag and try again.MoreIf |
||
open end of bag is inside Vacuum Channel. |
you are making initial seal on a piece of bag material with |
||
Check for wrinkles in the bag along the Sealing |
two open ends, make sure bag is placed on Sealing Strip, |
||
not on black rubber gasket. If you are vacuum packaging |
|||
Strip. Wrinkles in seal may cause leakage and allow |
|||
with a bag, make sure open end is placed down inside |
|||
air to come back into bag. Check for wrinkles in bag |
|||
Vacuum Channel and make sure Accessory Hose is not |
|||
along Sealing Strip before closing lid and vacuum |
|||
attached. If you are vacuum packaging with an accessory, |
|||
packaging. If you find wrinkles after sealing bag, sim- |
|||
check Accessory Hose in appliance lid and in accessory |
|||
ply cut bag open and vacuum package again. |
|||
to ensure a tight fit. (On V375, also make sure Vacuum |
|||
|
|||
|
Mode Switch (C) is set to Vacuum and Seal.) |
And |
|
|
|
U.S. RE 34,929; 4,660,355; 4,941,310; 5,655,357; 6,058,998; 6,256,968; Canada 1,315,746; and their equivalent international patents. Other patents pending.
First Printing: 3/2004 Item # TI8-0104 (03/04)
QuickStart
V365/V375
Shown V375; V365 operates in the same manner.
Features of Your FoodSaver Appliance
A Accessory Port |
C |
Mode Switch |
D Vacuum Channel |
|
F Sealing Strip |
|
Removable Drip Tray
For important safety information and helpful tips, please refer to the FoodSaver Reference Guide included in your kit. Questions? Visit us at www.foodsaver.com or call 1-800-777-5452 (U.S.) or 1-877-804-5383 (Canada),
Mon-Fri 8am-8pm, Sat 9am-6pm EST. Get tips on vacuum packaging and order FoodSaver accessories.
Features