Flymo MULTITRIM 250DX, MULTITRIM 300DX, MULTITRIM 250D Manual

INFORMATION

IMPORTANT

reference

use

Read

before

future

for

&

retain

For all customer enquiries or for replacement parts, contact:-

01325 300303 www.flymo.com

[e-mail]

1

Carton Contents

Height Adjust		Non-	Bolt
Nut (if		Height
applicable)		Adjust
Handle Knob	Bolt		Steady Handle
		Nut (if	Handle
Steady Handle		applicable)	Knob
			Scraper Tool
			(Multi-Trim 200
	Guard		only)
			Guard
Instruction			Instruction
Manual			Manual
	Electric Cable with	Electric Cable with
		moulded on plug
	moulded on plug
IMPORTANT ! Please check the contents of the carton are correct		BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:-

Electrolux Outdoor Products Customer Service Department direct

Telephone : [phone], Fax : [phone]

Safety

Please note: This manual covers various products. Please read the user instructions carefully to fully identify, assemble and use the features that apply to your trimmer.

If not used properly this trimmer can be dangerous! This trimmer can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this trimmer. The operator is responsible for following the warning and safety instructions in this manual and on the trimmer.

Explanation of Symbols on the Multi Trim
	The use of eye protection is recommend-
	ed to protect against objects thrown by
Warning	the cutting line.

Read the user instructions carefully to make sure you understand all the controls and what they do.

		Keep others, including children, pets and
10m	360º	bystanders outside the 10 metre hazard
		zone. Stop the trimmer immediately if you
		are approached.

General

1.Never allow children or people unfamiliar with these instructions to use the trimmer. Local regulations may restrict the age of the operator.

2.Only use the trimmer in the manner and for the functions described in these instructions.

3.Never operate the trimmer when you are tired, ill or under the influence of alcohol, drugs or medicine.

4.The operator or user is responsible for accidents or

hazards occurring to other people or their property.

To avoid the possibility of electric shock, do not use in damp or wet conditions.

Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged.

Warning: The cutting line continues to rotate after the machine has been switched off.

Electrical

1.The British Standards Institute recommend the use

of a Residual Current Device (R.C.D.) with a tripping

current of not more than 30mA.		Even with a R.C.D.
installed 100% safety cannot be guaranteed and
safe working practice must be	followed at all times.
Check your R.C.D. every time	you use it.

2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.

3.Do not use the trimmer if the electric cables are damaged or worn.

2 size cable up to 30 metres length

2

4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.

5.Your extension cable must be uncoiled, coiled cables

can overheat and reduce the efficiency of your trimmer.

6.Keep the cable clear of the cutting area and obstacles at all times.

7.Do not pull cable around sharp objects.

8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.

9.Never pull on the cable to disconnect any of the plugs.

10.Switch off, remove plug from mains and examine electric

supply cable	for damage or ageing	before winding cable
for storage.	Do not repair a damaged cable, replace it
with a new one. Use only Flymo replacement cable.

11.Always wind cable carefully, avoiding kinking.

12.Use only on AC mains supply voltage shown on the product rating label.

13.Flymo trimmers are double insulated to EN60335. Under no circumstance should an earth be connect-

ed to any part of the trimmer.

Preparation

1.While using your product always wear substantial footwear and long trousers.

2.Before using the machine and after any impact, check for signs of wear or damage and repair as necessary.

3.Inspect the area to be cut before each use. Remove all objects such as stones, broken glass, nails, wire, string etc, which can be thrown or become entan-

gled in the trimmer head.

4.Check that the cutting head, spool and cap are fit-

ted correctly.

Use

AVOID ACCIDENTAL STARTING. REMOVE PLUG FROM MAINS AND KEEP FEET AWAY FROM THE SWITCH LEVER WHEN:- CLEANING AROUND THE INSIDE OF THE SAFETY GUARD, REMOVING OR REFITTING SPOOL CAP, MANUALLY FEEDING OR REPLACING NYLON LINE.

1.Use the trimmer only in daylight or good artificial light.

2.Avoid operating your trimmer in wet grass, where feasible.

3.Take care in wet grass, you may lose your footing.

4.On slopes, be extra careful of your footing and wear

non-slip footwear.

5.Do not walk backwards when trimming , you could trip. Walk never run.

6.Keep cutting head below waist level.

7.Switch off before pushing the trimmer over surfaces other than grass.

8.Never operate the trimmer with damaged guards or without guards in place.

9.Never fit metal cutting elements.

10.Keep hands and feet away from the cutting means at all times and especially when switching on the motor.

11.Never pick up or carry a trimmer by the cable.

12.Do not lean over the trimmer guard - objects may be thrown by the cutting line.

13.Remove the plug from the mains :

-before leaving the trimmer unattended for any period;

-before clearing a blockage;

-before checking, cleaning or working on the appliance;

-if you hit an object. Do not use your trimmer until you are sure that the entire trimmer is in a safe operating condition.;

-if the trimmer starts to vibrate abnormally. Check

immediately. Excessive vibration can cause injury.

Maintenance and storage

1.Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition.

2.Replace worn or damaged parts for safety.

3.Only use the replacement cutting line specified for this product.

4.Only use replacement parts and accessories recommended by Electrolux Outdoor Products.

5.To avoid the risk of injury keep fingers and hands clear of the line cutter on the leading edge of the guard.

6.Inspect and maintain the trimmer regularly. Any repairs must be carried out by an authorised repairer.

Cables

IMPORTANT

Use only 1.00mm maximum.

Maximum rating:

1.00mm 2 size cable, 10 amps 250 volts AC.

THE MULTI TRIM IS SUPPLIED WITH AN ELECTRIC MAINS CABLE WIRED DIRECTLY INTO THE PRODUCT.

1.Flymo Mains Cables and Extension Cables are available from your local Electrolux Outdoor Products Approved Service Centre.

2.Do not wire an extension cable directly to your product yourself. Please contact your local Electrolux Outdoor Products Approved Service Centre for further information on the connectors and kits available.

3.Only use extension cables specifically designed for

outdoor use.

CONNECTORS

Flymo connectors are suitable for use with 2 core cable only. Under no circumstances should these connectors be used for earthed products.

All Flymo connectors and cables are of splashproof construction. They are not waterproof and must not be left outside permanently nor should they be submerged or immersed in water. Do not let cable lay or trail through pools of water or splashed with water from hose pipes.

MAINS PLUG REPLACEMENT

•If the plug supplied is cut off it should be destroyed. There is an electric shock hazard if a cut off plug is inserted into a 13 amp socket.

1.No earth required. Flymo products are double insulated to EN60335 and under no circumstances should an earth be connected to any part of the

product.

2.Ensure the mains voltage suits your product.

3.IMPORTANT!

The wires in the mains lead are coloured in accordance

with the following code:
BLUE	-	NEUTRAL
BROWN	-	LIVE

The wire which is coloured BLUE must be connected to the Terminal which is marked with the letter ‘N’ or coloured BLACK. The wire which is coloured BROWN must be connected to the Terminal which is marked with the letter ‘L’ or coloured RED.

4.It is important that the outer sheath is clamped correctly into the 3-pin plug.

5.If in doubt consult your local Service Repairer or qualified electrician before the machine is used.

6.A 5 Amp fuse must be fitted to the Mains Plug.

7.The normal plug fuse and household fuse only protect the electrical equipment and are not a safeguard against electrocution.

If your product is hard wired i.e. non-detachable mains electric cable, a conversion kit and extension cable is available from all Electrolux Outdoor Products Approved Service Centres which can be found in your local Yellow Pages.