DYMO Label Buddy Instruction Manual

Label Blaster/Label Buddy Guide

Extend the embossing tape about one
inch. This will allow for easier loading
into the Label Blaster/Label Buddy.

Insert the embossing tape into the slot
located in the tape compartment.
Feed the tape in as far as you can.
Squeeze the handle two times to help
feed the tape through the unit. Place
the embossing tape in the tape
compartment and close the
compartment door.

Push in and upward on the tab located on

the back of the Label Blaster/Label Buddy.

This will allow you to open the door to the

tape compartment.

Squeeze the handle two more times

to continue feeding the tape through

the unit.

Turn the wheel to select different
characters. Once you have selected
the character you’d like to emboss,
firmly squeeze the handle on the
Label Blaster/Label Buddy.

Firmly squeeze the handle to cut the
tape.

Select the following symbol:

Remove the backing and apply the

tape to the desired surface.