ILLUSTRATED PARTS LIST ENDURO–175 8 VALVE
Publication Number: 620917901IPL
Revision Date: October 10, 2011
Revision: G
Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.
The products, technical information, and instructions contained in this manual are subject to change without notice. These instructions are not intended to cover all details or variations of the equipment, nor to provide for every possible contingency in the installation, operation or maintenance of this equipment. This manual assumes that the person(s) working on the equipment have been trained and are skilled in working with electrical, plumbing, pneumatic, and mechanical equipment. It is assumed that appropriate safety precautions are taken and that all local safety and construction requirements are being met, in addition to the information contained in this manual.
This Product is warranted only as provided in Cornelius’ Commercial Warrant applicable to this Product and is subject to all of the restrictions and limitations contained in the Commercial Warranty.
Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal service conditions with respect to the Product, (2) improper voltage, (3) inadequate wiring, (4) abuse, (5) accident, (6) alteration, (7) misuse, (8) neglect, (9) unauthorized repair or the failure to utilize suitably qualified and trained persons to perform service and/or repair of the Product, (10) improper cleaning, (11) failure to follow installation, operating, cleaning or maintenance instructions, (12) use of “non-authorized” parts (i.e., parts that are not 100% compatible with the Product) which use voids the entire warranty, (13) Product parts in contact with water or the product dispensed which are adversely impacted by changes in liquid scale or chemical composition.
Contact Information:
To inquire about current revisions of this and other documentation or for assistance with any Cornelius product contact:
www.cornelius.com 800-238-3600
Trademarks and Copyrights:
This document contains proprietary information and it may not be reproduced in any way without permission from Cornelius.
Printed in U.S.A.
Enduro 175 8 Valve Illustrated Parts List
CABINET SECTION ASSEMBLY
Figure 1.
© 2004-2011, IMI Cornelius Inc. |
- 1 - |
Publication Number: 620917901IPL |
Enduro 175 8 Valve Illustrated Parts List
|
|
Table 1. |
|
|
|
|
|
Item |
Part No. |
Name |
|
No |
|||
|
|
||
|
|
|
|
1 |
21491 |
Gate Slide |
|
|
|
|
|
2 |
22081R |
Gate Restrictor |
|
3 |
Not used |
|
|
|
|
|
|
4 |
**29303R |
Plate, Motor Mounting |
|
|
|
|
|
5 |
15346 |
Agitator Assy |
|
6 |
620021201 |
Cover, Rear Wrapper |
|
|
|
|
|
|
629080213 |
Lower Panel Assy (For Drip |
|
7 |
Tray) |
||
|
|||
|
629080215 |
Lower Panel Assy (Z Model) |
|
8 |
620020101 |
Sink Extension Assy, Drip Tray |
|
|
|
|
|
9 |
Not Used |
|
|
|
|
|
|
10 |
620035401 |
Wrapper |
|
11 |
Not Used |
|
|
|
|
|
|
12 |
Contact |
Panel Cold Plate/Faucet Assy |
|
Sales |
|||
|
|
||
13 |
27107 |
Retainer Lever, Ice Dispenser |
|
14 |
10145 |
Pin Sink Ext. |
|
|
|
|
|
15 |
31007 |
Switch Boot |
|
|
|
|
|
16 |
50335 |
Insulation, Cold Plate Drain |
|
17 |
50767 |
Heyco Snap Bushing |
|
|
|
|
|
18 |
Not Used |
|
|
|
|
|
|
19 |
15087 |
Retainer, Agitator |
|
20 |
Not Used |
|
|
|
|
|
|
21 |
30794 |
Motor Heater, 115 Volt |
|
|
|
||
32826 |
Motor Heater, 220-240 Volt |
||
|
|||
22 |
30895 |
Dispense Switc |
|
|
|
|
|
23 |
53011 |
Elbow Cold Plate Drain |
|
|
|
|
|
24 |
31622 |
Bulb-Daylight 18” |
|
25 |
**620307901 |
Agitator Motor, 120 Vol |
|
|
|
|
|
|
**620307902 |
Agitator Motor, 220-240 Vol |
|
26 |
|
|
|
33409 |
Solenoid Assembly, 220-240 |
||
|
Volt |
||
|
|
||
27 |
Not Used |
|
|
|
|
|
|
28 |
Not Used |
|
|
|
|
|
|
29 |
Not Used |
|
|
|
620302001 |
Electrical Box Ass’y, 120 Volts |
|
|
(ED 150 B and BC Models) |
||
|
|
||
|
620303301 |
Electrical Box Ass’y, 120 Volts |
|
|
(ED 150 Ice Only) |
||
|
|
||
30 |
620302301 |
Electrical Box Ass’y, 220-240 |
|
|
Volts (ED 150 B and BC Models) |
||
|
|
||
|
620303302 |
Electrical Box Ass’y, 220-240 |
|
|
Volts (ED 150 Ice Only) |
||
|
|
||
31 |
Not Used |
|
|
|
|
|
|
32 |
620045912 |
Brkt MTG Motor ED150 8V |
|
HICARB |
|||
|
|
||
33 |
Not Used |
|
|
|
|
|
|
34 |
71010 |
Washer, Captivating No. 8 |
|
|
|
|
|
35 |
Not Used |
|
|
|
|
|
|
36 |
Not Used |
|
|
|
|
|
|
|
Table 1. |
|
|
|
|
|
Item |
Part No. |
Name |
|
No |
|||
|
|
||
|
|
|
|
37 |
Not Used |
|
|
|
|
|
|
38 |
Not Used |
|
|
|
|
|
|
39 |
620019701 |
Hinge, Gusset |
|
40 |
Not Used |
|
|
|
|
|
|
41 |
Not Used |
|
|
|
|
|
|
42 |
Not Used |
|
|
43 |
Not Used |
|
|
|
|
|
|
44 |
**51859 |
Seal, Agitator Motor Shaft |
|
|
|
|
|
45 |
Not Used |
|
|
46 |
51891 |
Gasket, Gate |
|
|
|
|
|
47 |
***51908 |
Plug (120 Volt Models Only) |
|
|
|
|
|
48 |
**52876 |
Gasket, Motor Shaft |
|
49 |
620500901 |
Ice Chute |
|
|
|
|
|
50 |
53168 |
Ice Chute Cover |
|
|
|
|
|
51 |
53241 |
Access Cover (Cold Plate Mod- |
|
els Only) |
|||
|
|
||
52 |
53227 |
Agitator Disk |
|
|
|
|
|
|
Contact |
Merchandiser, Black |
|
|
Sales |
||
|
|
||
|
Contact |
Merchandiser, Gray |
|
|
Sales |
||
|
|
||
53 |
620024118 |
Merchandiser, S.S. |
|
|
|
||
620024117 |
Merchandiser, S.S. (For Lid and |
||
|
|||
|
Straw Holder) |
||
|
|
||
|
|
|
|
|
620024116 |
Merchandiser, S.S. (For Medal- |
|
|
lion) |
||
|
|
||
|
620024115 |
Merchandiser, S.S. (For Low Ice |
|
|
Light) |
||
|
|
||
54 |
620502801 |
Lens, Merchandiser |
|
|
|
|
|
55 |
620502701 |
Foamed Sink Assy, Black |
|
620502702 |
Foamed Sink Assy, Gray |
||
|
|||
|
|
|
|
56 |
620513503 |
Lid, Dispenser, Black |
|
|
|
||
620513504 |
Lid, Dispenser, Gray |
||
|
|||
57 |
620513502 |
Hopper Assy |
|
|
|
|
|
58 |
620021901 |
Baffle |
|
|
|
|
|
59 |
52967 |
Plug, Plastic |
|
60 |
52972 |
Tab Retaining |
|
|
|
|
|
61 |
53236 |
Cover (Cold Plate Models Only) |
|
|
|
|
|
62 |
70016 |
Hex Nut, No. 10-32 S.S. |
|
63 |
70017 |
Hex Nut, No. 10-32 Nylon Insert |
|
Locknut |
|||
|
|
||
64 |
**70018 |
Hex Nut, 1/4-20 Keps |
|
|
|
|
|
65 |
Not Used |
|
|
|
|
|
|
66 |
**70048 |
Washer, .255 I.D. |
|
|
|
|
|
67 |
70056 |
Washer, No. 10, .219 I.D. |
|
|
|
|
|
68 |
70067 |
Washer, .218 I.D. |
|
|
|
|
|
69 |
70076 |
Hex Nut, No. 8-32 |
|
|
|
|
|
70 |
70104 |
Nutsert No. 8-32 |
|
|
|
|
|
71 |
Contact |
|
|
Sales |
|
||
|
|
||
72 |
70171 |
Machine Screw, Phil Truss Hd, |
|
No. 8-32 By 3/8-In. Long |
|||
|
|
Publication Number: 620917901IPL |
- 2 - |
© 2004-2011, IMI Cornelius Inc. |