Canon PIXMA iP6220D Series Easy Setup Instructions
Series
Photo Printer
Start Here
Easy Setup Instructions
1 Unpack the Printer 2 Prepare the Printer 3 Install the FINE Cartridges 4 Align the Print Head (FINE Cartridge)
Carefully remove all items from the box.
Documentation and
Software Kit
Photo FINE Cartridge
(CL-52)
Color FINE Cartridge
(CL-51)
Power Cord
PIXMA iP6220D Photo Printer
Remove the shipping tape from the front and back ofthe
printer.
Open (a) the card slot cover first and (b) the front cover next,
Pull down and remove the protective material on the right
side.
Close the front cover first and the card slot cover next.
Plug the power cord into the back of the printer and connect
the other end to a power outlet.
Press the POWER button. The printer will initialize. Wait until
the POWER lamp remains fully lit.
NOTE: Do not connect the USB cable at this stage.
When the screen appears on the LCD, confirm a language
and then press the OK button.
NOTE: If you leave the printer more than five minutes without
using any button on the operation panel, the LCD goes
into sleep mode automatically. Press the OK button to
turn on the LCD again.
Open the card slot cover first and the front cover next.
The FINE Cartridge holder automatically movesto the left .
Write down the serial number. You will need this to register
the product.
6
5
4
3
2
1
Take out the Color FINECartridge (CL-51) from its box and remove the protective
tape gently.
NOTE:
·Do not touch the electrical contacts or print head nozzles on a FINE Cartridge. The
printer may not print out properly if you touch it.
·Do not reattach the protective tape once you have removed it.
·Handle the removed protective tape carefully to avoid getting your hands dirty or
staining surrounding work area.
Insert the Color FINE Cartridge slightly slanted into the left slot(C).
Push up the Color FINE Cartridge until itclicks into place.
IMPORTANT: For correct printer operation, make sure the FINE Cartridge is secure in
slots.
Repeat the procedure for the Photo FINE Cartridge (CL-52), inserting it into the
right slot (P).
Close the front cover first and the card slot cover next.
IMPORTANT: Wait until the preparatory operation is complete; this takes about one
to two minutes.
The message requesting head alignment is displayed on the LCD.
Go to the next step.
5
4
3
2
1
Open the paper support and pull out the paper output tray.
Pinch the paper guide and slide it to the left. Load a few
sheets of blank paper into the auto sheet feeder, then slide
the paper guide toward the left edge of the paper.
NOTE: Ensure that the paper thickness lever is set to the left
position.
Ensure that the message requesting head alignment isdisplayed on the LCD, select Yes using the buttons and
then press the OK button.
The pattern is printed. And the print head is aligned
automatically.
IMPORTANT: It takes about four minutes to finish printing.
When automatic print head alignment can not be executed correctly, the message "Auto Head Align hasfailed.
Press [OK] and repeat operation. <See manual>" isdisplayed on the LCD. refer to "An Error Message is
Displayed on the LCD" in the DirectPrinting Guide.
3
2
1
Print head nozzles
Electrical contacts
Continue with Step 5
on side two.
Power cord
To the FINE Cartridge holder
Paper support
Paper output tray
FINE Cartridge
holder
Paper thickness lever
Protective material
Serial number
Protective tape
(b) Front cover
Paper guide
Print side
Auto sheet feeder
(a) Card slot cover
Windows
Macintosh
5 Windows
®
Printer Driver Installation 5 Macintosh
®
Printer Driver Installation
The screens below refer to Windows XP Service Pack2 installation. Screens may differ depending on the operating system
you are using.
TURN THE PRINTER OFF.
You hear the operation sound untilthe printer is turned off.
It may take about 20 seconds.
Turn the computer on and start Windows.
NOTE:
·Before installing the driver, disable all anti-virus programs
and automatically loading programs.
·For Windows XP or Windows 2000, log on to Windows as a
member of Administrators group before continuing.
·Do not switch users during the installation process.
IMPORTANT: If you see the Found New Hardware Wizard,
click Cancel. Next, remove the USB cable connected to your
computer. Then proceed from step 3 to install the printer
driver.
Insert the Setup Software & User's Guide CD-ROM.
The setup program should run automatically.
When the main menu screen appears, click EasyInstall and
follow the on-screen instructions.
NOTE:
·Select Easy Install in order to install application software,
on-screen manual, utility and printer drivers. Select Custom
Install in order to choose the options you would like to
install.
·To install PhotoRecord, click Custom Install and follow the
instruction on the screen.
When the Easy Install screen appears, clickInstall.
NOTE: Move the cursor over items to display explanations of
each application below.
Read the License Agreement, then clickYe s.
Installation of the printer driver, on-screen manuals, and
applications will begin. Follow the instructionsdisplayed on
the screen.
If the message asking for your confirmation to restartyour
computer appears, click OK.
The system is restarted automatically.
6
5
4
3
2
1
When the Printer Connection screen appears, connectthe USB
cable to the computer and the other end to the printer.
TURN THE PRINTER ON.
IMPORTANT: If you cannnot proceed to the next procedure after
two minutes, refer to "Troubleshooting" instructions
in the Quick Start Guide.
If the message asking for your confirmation to restartyour computer appears, click OK.
The system is restarted automatically.
Follow the on-screen instructions to installthe remaining software. When the Installation Results screen appears, clickNext.
Follow the on-screen instructions to register your product.
When the Installation completed successfully screen appears,
click Exit.
If Restart is displayed, ensure the Restart the system now (rec-
ommended) check boxis selected, then click Restart.
11
10
9
8
7
When the Easy Install screen appears, clickInstall.
NOTE: Move the cursor over items to display explanations of
each application bellow.
Read the License Agreement, then clickYe s. Installation of
the printer driver, on-screen manuals and applications will
begin.
Follow the instructions displayed on-screen.
Follow the on-screen instructions to register your product.
When the Installation completed successfully screen
appears, click
Restart.
After restarting the computer, select Applications from the
Go menu.
Double-click the Utilities folder, and then double-click the
Printer Setup Utility (Print Center when you use Mac OSX
v.10.2.x) icon. Check thatyour printer name is displayed on
the Printer List. If your printer name is notdisplayed on the
Printer List, click Add to add the printer.
For details, refer to the Printer Setup Utility Help or Mac
Help.
11
10
9
8
7
NOTE:
·Before installing the driver, disable all anti-virus programs and
automatically loading programs.
·Use Mac
®
OS X v.10.2.1 to 10.3.x.
·The screens below refer to Mac OS X v.10.3.x installation.
Screens may differ depending on the operating system you are
using.
·Do not remove or insert the USB cable during installation, as this
may result in the computer or printer not operating normally.
Connect the end of the USB cable to the computer, the other to
the printer.
Turn on your Mac OSX.
Insert the Setup Software & User's Guide CD-ROM.
NOTE:
·If the CD-ROM folder does not open automatically,
double-click the CD-ROM icon on the desktop.
·Log on as an Administrator before continuing.
Double-click the Setup icon.
When the Authenticate screen appears, enter your administrator name and password. ClickOK.
If you do not know your administrator name or password, click
, then follow the on-screen instructions.
When the main menu screen appears, click EasyInstall and follow on-screen instructions.
NOTE: Select Easy Install in order to install application software,
on-screen manual, utility and printer drivers. Select
Custom Install in order to choose the options you would
like to install.
6
5
4
3
2
1
Part no. QA7-3644-V02 ©2005 CANON INC. "Windows" is a trademark of Microsoft Corporation, registered in the United States and other countries. "Macintosh" and "Mac" are trademarks of Apple Computer, Inc., registered in the U.S. and other countries. Printed in Thailand.
Loading...