Canon D320 User Manual

Thank you for purchasing the Canon imageCLASS D320. To get your machine ready for use, please follow the instructions in this Set-Up Sheet before referring to any other documentation.

Set-Up Sheet

Unpack the machine and its components.

Check that you have the following:

IMPORTANT

• Save your sales receipt for proof of purchase in case your machine requires warranty service.

NOTE

•A printer cable is not included.You need a USB cable (less than 16.4ft./5m) to connect your machine to a computer.

●

Machine

●

Canon S35 Cartridge

●

Cassette/Multi-purpose tray

●

Power Cord

●

Documentation

(Set-Up Sheet, Basic Guide, Registration Card, Limited Warranty Card)

●

CD-ROM

Removing Shipping Materials

1 Place the machine on a flat surface. 2 Remove the shipping tapes on the machine and cassette/multi-purpose tray.

NOTE

• DO NOT remove the transparent USB

label A at this stage.

3 Open the platen glass cover B to remove the inner protection sheet C.

Installing the Cassette

Raise the cassette slightly toward the machine, and align the hooks on both sides of the cassette with the guides in the machine, then insert the cassette into the machine as far as it will go 1.Then gently lower the cassette 2.

NOTE

• Install the cassette so that there is no space between the cassette and the feeding slot.

Tr ansparent USB label

Left side view

Loading Paper in the Cassette

1 Load the paper stack in the cassette.

• Insert the paper stack into the cassette

as far as it will go.

2 Slide the width guides A and the length

guide B to fit the size of the paper stack.

•Adjust the guides so that there is no space

between the guides and the paper.

NOTE

•Make sure the paper stack does not exceed the width and length guides’ claws.

3 Set the multi-purpose tray on top of the

cassette.

Connecting the Power Cord

When the power cord is plugged into the machine and into the wall outlet, the machine is turned on. There is no separate ON/OFF power switch. Once connected, the machine needs to warm up before you can use it.The LCD displays PLEASE WAIT, then INSTALL CARTRIDGE.The LCD returns to the standby display when you install the cartridge and load paper in the cassette or multi-purpose tray.

NOTE

• Insert the power cord straight into the power cord connector on the left side of the machine. Do not insert it at an angle. Otherwise, the machine may not be properly connected to the power source and may not turn on. If this happens, disconnect the power cord, and reconnect it correctly after a minute or more.

•When disconnecting or connecting the power cord, be sure to unplug or plug the power cord from the wall outlet, not from the power cord connector on the machine.

+ 5 hidden pages