Campbell Hausfeld RP4100, RP4000, IN239502AV User Manual

See Warranty on page 3 for important information about commercial use of this product.

Operating Instructions RP4000, RP4100

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.

120-Volt Inflators

Description

The 120-volt inflator comes with
inflation nozzles and needle. The
inflator can be used for inflating car
and bike tires, soccer balls, beach balls
and other sporting equipment.

Unpacking

When unpacking this product, carefully
inspect for any damage that may have
occurred during transit.

Safety Guidelines

This manual contains information
that is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.

Danger indicates an

imminently
hazardous situation which, if not
avoided, WILL result in death or serious
injury.

Warning indicates a

hazardous situation which, if not
avoided, COULD result in death or
serious injury.

Caution indicates a

hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.

Notice indicates

information, that if not followed, may
cause damage to equipment.

potentially

potentially

important

General Safety

Completely read the manual
included with this product
carefully. Be thoroughly
familiar with the proper use
of the unit.

MANUAL

Any misuse of unit could cause
property or equipment damage and/
or personal injury.

CALIFORNIA PROPOSITION 65

This product or

its power cord may
contain chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
Wash hands after handling.

Do not leave the

inflator
unattended while the unit is running.

Unit must be

securely and
adequately grounded. See grounding
instructions and extension cord
information in this manual.

Never exceed the
recommend-ed pressure for
any inflatable object. Do not
over inflate objects. Over inflation could
cause property damage and/or personal

injury.
The universal

adapter must
be locked to secure the inflation
accessories. Use extreme caution when
using inflation accessories.

Always use a

separate pressure
gauge to check the actual pressure in
tires and in low pressure inflatable
objects.

Inflator must cool

for 20 minutes after
20 minutes of continuous oper-ation.
The Inflator is not designed to operate
continuously for more than 20 minutes.

Do not use inflator

on high pressure
tires used on large trucks, trailers or
tractors. The inflator is not designed to
operate for the length of time necessary
to inflate these tires.

Make sure the

universal adapter

touches the core or tire valve stem.

Preparation

GROUNDING INSTRUCTIONS

1. This product must be grounded.
In the event of an electrical short
circuit, grounding reduces risk of
electrical shock by providing an
escape wire for electric current. This
product is equipped with a cord
having a grounding wire with an
appropriate grounding plug. Plug
must be plugged into an outlet that
is properly installed and grounded in
accordance with all local codes and
ordinances.

Grounding

Pin

Figure 1 - Grounding Method

Improper use of grounding
plug can result in a possible
risk of electrical shock!

TEST

NOTE: Do not use grounding adapter.

2. If repair or replacement of cord or
plug is necessary, do not connect
grounding wire to either flat blade
terminal. The grounding wire has
insulation and an outer surface that
is green with or without yellow
stripes.

3. Check with a qualified electrician
or serviceman to ensure product is
properly grounded. Do not modify
plug provided; if plug will not fit
outlet, have proper outlet installed
by a qualified electrician.

RESET

Grounded

Outlet

REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.

© 2009 Campbell Hausfeld/Scott Fetzer

For parts, product & service information

visit www.chpower.com

IN239502AV 1/10

Operating Instructions

Preparation (Continued)

Never connect green

(or green and yellow)

wire to a live terminal.

EXTENSION CORDS

1. Use only a 3-wire extension cord
that has a 3-blade grounding plug,
and a 3-slot receptacle that will
accept plug on product.

2. Make sure extension cord is in good
condition, and heavy enough to
carry the current the product will
draw. An undersized cord will cause
a drop in line voltage resulting in
loss of power and overheating.

3. The chart on page 2 shows correct
size to use depending on cord
length. If in doubt, use next heavier
gauge.

NOTE: The smaller the gauge number,
the heavier the cord.

Operation

TIRES

1 a. Remove valve stem cap.
b. Attach the universal adapter from

the inflator to the valve stem with
the lever in the up position .

c. Be sure to press universal adapter

down over valve stem threads
completely.

Recommended Extension Cords

Length of Cord (ft) 25 50 100 150

Gauge of Cord 18 18 16 14

d. When universal adapter is firmly in

place, press locking lever down to
lock onto valve stem (See Fig. 2).

(tire, football, raft, etc.) and turn on
the inflator.

3. When the object is firm, switch the
inflator off. Do not over inflate
objects.

FUSE REPLACEMENT

Universal
Adapter

Lock

When replacing the fuse, make sure
the inflator is turned off and nothing is
connected to the inflator.

1. Unscrew the top of fuse holder.

Valve Stem

2. Replace with a new 2-amp fuse.
Always replace a blown fuse with

Figure 2

2. Turn the inflator on.

3. When tire is at the desired pressure,
turn the inflator off.

4. Check the tire pressure using a
separate gauge.

INFLATABLES

1. To use the inflation accessories,
snap either piece into the universal

the same size fuse.

3. Screw the top of fuse holder back on
to the unit.

Maintenance

1. This product has no user serviceable
parts and does not require
lubrication.

2. Do not store outdoors. When not in
use, store in a cool dry place.

adapter and push the lever to lock
into place. The inflation accessory
will fit securely.

2. Insert the appropriate inflation
accessory into the inflatable object

Technical Service

For information regarding the
operation or repair of this product,
please call 1-800-543-6400.

www.chpower.com

2

Operating Instructions

Limited Warranty

1. DURATION: From the date of purchase by the original purchaser as follows: One Year.

2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030,
Telephone: [phone]

3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld
product.

4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: This Campbell Hausfeld inflator.

5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects in material and workmanship which occur within the duration of the
warranty period with the exceptions below.

6. WHAT IS NOT COVERED UNDER THIS WARRANTY:
A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF

ORIGINAL PURCHASE AS STATED IN THE DURATION. If this product is used for commercial, industrial or rental purposes, the warranty
will apply for ninety (90) days from the date of purchase. Some States do not allow limitation on how long an implied warranty lasts,
so the above limitations may not apply to you.

B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE,

OR MALFUNCTION OF THE CAMPBELL HAUSFELD PRODUCT. Some States do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.

C. Any failure that results from an accident, purchaser’s abuse, neglect or failure to operate products in accordance with instructions

provided in the owner’s manual(s) supplied with product. Accident, purchaser's abuse, neglect or failure to operate products in
accordance with instructions shall also include the removal or alteration of any safety devices. If such safety devices are removed or

altered, this warranty is void.
D. Normal adjustments which are explained in the owner’s manual(s) provided with the product.
E. Items or service that are normally required to maintain the product.

7. RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor’s option, products or components which are
defective, have malfunctioned and/or failed to conform within the duration of the specific warranty period.

8. RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY:
A. Provide dated proof of purchase and maintenance records.
B. Call Campbell Hausfeld [phone] to obtain your warranty service options. Freight costs must be borne by the purchaser.
C. Use reasonable care in the operation and maintenance of the products as described in the owner’s manual(s).

9. WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY: Repair or replacement will be scheduled and
serviced according to the normal work flow at the servicing location, and depending on the availability of replacement parts.

This Limited Warranty applies in the United States, Canada and Mexico only and gives you specific legal rights. You may also have other rights
which vary from state to state or country to country.

www.chpower.com

3