Black & Decker SG100, SG200 User Manual

0 (0)
SG100/SG200 Series
*
?
http://www.applicaconsumerproductsinc.com
U.S.A./CANADA 1-800-231-9786
Printed in Italy
Pub No. 177149-00-RV00
*
Listed by Underwriters Laboratories, Inc.
is a trademark of The Black & Decker Corporation, Towson, Maryland, USA
Product may vary slightly from what is illustrated.
Applica Consumer Products, Inc.
*
3. After refilling, be sure the Safety Fill Cap is tightened closed. Fill Cap. steam until all the steam is used up before opening the Safety
2. To cut down on residual steam, CONTINUE ironing with full steam. Cap to refill as some pressure is being released from residual
1. It is normal to have a little hissing when you open the Safety Fill
HISSING FROM THE SAFETY FILL CAP
maintaining the proper temperature.
2. The light will cycle on and off as you iron indicating it is the temperature you’ve selected for your fabric.
1. This is normal. The light will go out once the iron has reached
TEMPERATURE LIGHT GOES OFF
proceeding. towel or a laundry basket to catch the droplets before in the Steam Hose. You may want to hold the iron over an old little water spotting when you begin again due to condensation
2. Did you stop using the iron for a few minutes? You may get a temperature. between blend and linen? If not, move the Dial to increase the
1. Is the Temperature Selector Dial set in the “Steam Band”
WATER DROPLETS COMING FROM STEAM VENTS?
SAVE THIS INSTRUCTION BOOK
IMPORTANT SAFEGUARDS
When using your Steam Generator, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
Use the Steam Generator only for its intended use. Remove any
labels from the iron body or Soleplate before first use.
To protect against a risk of electric shock, do not immerse any
part of the appliance in water or other liquid.
This appliance should always be turned Off before plugging into
or unplugging from an outlet. Push the On/Off Button and the light will go out. Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let iron cool
completely before putting away. Loop cord loosely around the iron when storing.
Always disconnect iron from electrical outlet when filling with
or emptying of water and when not in use. Be careful to avoid spilling water over Boiler Water Tank when filling.
Always use the provided Funnel and Water Pitcher to fill the
Boiler Water Tank.
Do not fill the Boiler Water Tank with vinegar or other anti-
limestone agents.
Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or is dropped or damaged in any manner. To avoid the risk of electric shock, do not disassemble the iron. Return the appliance to the nearest authorized service facility for examination, repair, or electrical or mechanical adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used. Or, call the appropriate toll-free number listed on the cover of this manual.
Close supervision is necessary for any appliance being used
near children. Do not leave iron unattended while connected or
Steam Generator Iron
on an ironing board. Always position iron carefully on the base to prevent it from falling if ironing board is accidentally moved or cord is pulled.
Water may leak from the iron’s Soleplate if the Surge of Steam
Button is pressed before the Boiler Water Tank has reached the optimal temperature (after about 10 minutes) or before the appliance is hot.
Note: Before unscrewing the Safety Fill Cap follow these
operations:
Press the Surge of Steam Button to release all the residual
steam. Turn the iron/boiler Off. Unplug from the wall socket; slowly unscrew the Safety Fill Cap and wait for the hissing noise to stop before unscrewing it completely.
The use of parts/attachments not recommended or sold by the
appliance manufacturer may cause fire, electric shock, or injury.
Burns can occur from touching hot metal parts, hot water, or
steam. Use caution when you turn a steam iron upside down or use the vertical surge of steam.
Do not operate in the presence of explosive and/or flammable
fumes.
Do not use iron outdoors.This appliance is intended for household use only, not for
commercial or industrial use. Use for anything other than intended will void the warranty.
SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate another high-
wattage appliance on the same circuit.
If an extension cord is necessary, a 10-ampere rated cord with
a polarized plug and UL approval should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled on or tripped over.
province. have other rights which vary from state to state or province to This warranty gives you specific legal rights and you may also
Assistance and Information toll free at: 1-800-231-9786. questions regarding warranty or service, call Consumer become defective within the warranty period, or you have repairs performed by unauthorized personnel. If the product should include damage to the product resulting from accident, misuse, or original date of consumer purchase. This warranty does not faulty material or workmanship for a two-year period after the Applica warrants this product against any defects that are due to
Troubleshooting
FULL TWO-YEAR WARRANTY
Boiler Water TankBaseStainless Steel SoleplateSafety Fill CapTemperature LightSteam Lock ButtonSurge of Steam/Unlock ButtonTemperature Selector Dial/Fabric GuideSteam Cord
ON/OFF Buttona. Low Water Indicator
a. (Certain Models Only)
b. Steam Ready Indicator
b. (Certain Models Only)
Adjustable Steam DialWater PitcherFunnel
you begin a new ironing session. button for 5-10 seconds. This is particularly important each time
3. If steaming doesn’t start, press and hold the Surge of Steam enough water in the Boiler Water Tank.
2. Is the Low Water Indicator light on? Check to see if there is minutes in order to produce steam.
1. Did you let the unit preheat long enough? It must heat up for 10
IRON WON’T START STEAMING?
plugged into the outlet turn on?
2. Press the ON/OFF button. If the light is not on, will a lamp
1. Is the unit plugged in? Is the Power Light on?
BOILER WATER TANK WON’T HEAT?
SAVE THESE INSTRUCTIONS
Loading...
+ 1 hidden pages