Avery AVE08888, 07905, AVE07885, 8881, 8883 User Manual

SAFETY DATA SHEET

5-15-2015

Section 1: Identification

Product Name: Marks-A-Lot Permanent Markers Inks

Manufacturer Information

Avery Products Corporation
50 Pointe Drive
Brea, California 92821
Phone: [phone]

Emergency Phone Number: 1-800-222-1222 (Poison Control Center)

This product bears the AP (Approved Product -Non-Toxic) seal of The Art & Creative Materials Institute, Inc
(ACMI). These products are certified by a medical expert to contain no materials in sufficient quantities to be toxic
or injurious to humans or to cause acute or chronic health problems.

Section 2: Hazard(s) Identification

Classification in accordance with paragraph (d) of 29 CFR 1910.1200.

Serious Eye Damage – Category 1
Flammable Liquid 2

GHS Label Elements

Symbol(s)

Signal Word (s)

Danger

Hazard Statement(s)

Causes serious eye damage
Highly flammable liquid vapor

Precaution Statement(s)

Prevention
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Keep container
tightly closed. Keep cool. Ground and bond container and receiving equipment. Use explosion-proof equipment.

Page 1 of 5

SAFETY DATA SHEET

5-15-2015

Section 3: Composition/Information on Ingredients

Ingredient

CAS #

PEL/TLV

(MG/M#)

Max

% Weight

NTP

IARC

None

N-Propanol

71-23-8

N/A

87.00000

N

N

Section 4: First Aid Measures

Section 5: Fire-Fighting Measures

Section 6: Accidental Release Measures

Section 7: Handling and Storage

Section 8: Exposure Controls/Personal Protection

Use non-sparking tools. Take action to prevent static discharges. Wear protective glove/protective clothing/eye
protection/face protection. Store in well-ventilated place.

Response
Rinse skin with water [or shower]. Take off immediately all contaminated clothing. IF IN EYES. Rinse cautiously with
water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing

FIRST AID MEASURES: NONE REQUIRED. NO ACUTE HEALTH EFFECTS EXPECTED

FLASH POINT (METHOD): N/A AUTOIGNITION TEMPERATURE: N/A
EXPLOSION LIMITS IN AIR (% BY VOLUME): NOT EXPLOSIVE
EXTINGUISHING MEDIA: NO SPECIAL MEDIA REQUIRED
FIRE FIGHTING PROCEDURES: NO SPECIAL FIRE FIGHTING PROCEDURES REQUIRED
UNUSUAL FIRE & EXPLOSION HAZARDS: NOT COMBUSTIBLE

STEPS TO BE TAKEN IN CASE A MATERIAL IS SPILLED: Clean up in accordance with all applicable regulations. Absorb
spillage with non-combustible, absorbent material. For waste disposal, see Section 13.

PRECAUTION TO BE TAKEN DURING HANDLING AND STORAGE: Good industrial hygiene practices requires that
exposure be maintained below the TLV. This is preferably achieved through the provision of adequate ventilation.
When exposure cannot be adequately controlled in this way, personal respiratory protection should be employed.

RESPIRATORY PROTECTION AND SPECIAL VENTILATION REQUIREMENTS: NONE REQUIRED
OTHER PROTECTIVE EQUIPMENT (GLOVES, GOGGLES, ETC): NONE REQUIRED

Page 2 of 5