AT&T 9210 User Manual

REVISED

10/17/00

900 MHz Cordless
Telephone 9210

Fold open this manual for information about this
telephone’s installation and operation. Please
also read Part 1 — Important Product Information.

AT&T and the globe symbol are registered trademarks of AT&TCorp.licensed to Advanced American Telephones.

© 2000 Advanced American Telephones. All rights reserved.

Printed in Mexico.

850004300 Issue 1AT&T 10/00

USER’S MANUAL

Par t 2

1

INSTALLATION

b) Plug battery

pack connector
into handset.

d) Replace cover

by sliding it up
into place.

a) Remove

battery
compartment
cover by
pressing on
the indentation
and sliding
downward.

c) Place battery

pack and wires
in compartment.

Standard

electrical

outlet

Modular
telephone
jack

1 Connect the

telephone
line cord.

2 Connect the

power cord.

Before You Install

1 Choose a location for the base near an electrical

outlet and a telephone jack.

2 Install the handset battery.

This phone requires a modular telephone jack and a
standard electrical outlet (110v AC) not controlled by a wall
switch.

Table/Desk Installation

3 Charge the handset battery.

Place the handset in the base. Charge the battery for at
least 24 hours the first time. After the first charge,the
battery is typically fully charged overnight.

4 Check for dial tone.

After the batteries are charged,pick up the handset and
press P; you should hear a dial tone.

5 Set the dial mode.

If you have touch tone service,the phone is ready to
use as soon as the batteries are charged.

If you have dial pulse (rotary) service,you’ll need to
change the dial mode. When the phone is of f,press
G,*,#,M to set the dial mode to dial
pulse. To return to touch tone dialing,press G,
*,*,M.

Use only the power
cord supplied with
this product. If you
need a replacement,
call 1 800 222-3111.

2

INSTALLATION

Wall Installation

1 Connect the

telephone
line cord.

2 Connect the

power cord.

Place power
cord as shown,
so it hangs
straight down
between base
and wall.

3 Mount the base

on the wall.

Align holes on base
with mounting
studs on wall jack.

Pull base down on
mounting studs
until it locks into
place.

Standard

electrical

outlet

Modular
telephone jack

Mounting
studs

Use only the power cord supplied with this product.
If you need a replacement,call 1 800 222-3111.

4 Follow Steps 3–5 in

“Table/Desk Installation.”