Amana™SS 5 Burner Grill w/ Rear Burner
USE AND CARE MANUAL
FOR OUTDOOR USE ONLY
ALWAYS KEEP YOUR GRILL COVERED WHEN NOT IN USE
BEFORE YOU BEGIN – We’ve included easy-to-follow, step-by-step instructions which have been carefully written to ensure quick assembly of your grill. Reading the instructions will be a time saver in the end.
TOOLS YOU WILL NEED – A Phillips screwdriver, adjustable wrench, 1/2” wrench or socket and a 1/4” nut driver or socket will be needed to assemble this grill. All other necessary hardware has been included.
Questions,Missing or Damaged part? DO NOT RETURN PRODUCT TO STORE
Were here to help. Just call 1-800-229-5647. For faster service, have model number and serial number on hand when calling.
IMPORTANT SAFETY INFORMATION
- Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury.
- Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.
- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come in contact with grate, burner or hot surfaces.
- Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death. - Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified
service technician should conduct all other service.
- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service technician.
- Locate the main gas supply valve so that you know how to shut the gas off to your grill.
- If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified technician.
- When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter that lights the burner you intend on using.
- Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn. - Extinguish all flames and do not smoke while engaging gas and igniting the grill.
- A minimum distance of at least 12" must be maintained from any combustible material on both sides and the back of the grill. Do not place the grill under any overhead unprotected combustible construction.
RECOGNIZE SAFETY SYMBOLS, WORDS AND LABELS
WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
NOTE indicates an important piece of information that needs to be observed to ensure the proper operation of your grill.
INSTALLER: Please retain these instructions with the owner so that they may maintain them for future reference.
2
Welcome & Congratulations
Congratulations on your purchase of a new grill! We are very proud of our product and we are completely committed to providing you with the best service possible. Your satisfaction is our #1 priority.
Please read this Use & Care Manual very carefully. It contains valuable informati on on how to properly maintain your new grill.
We know you’ll enjoy your new grill and thank you for choosing our product. We hope you consider us for future purchases.
PLEASE READ AND SAVE THESE INSTRUCTIONS
This Use & Care Manual provides specific operating instructions for your model. Use your grill only as instructed in this manual. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating and maintaining any appliance.
Please recordyourmodeland serialnumbers belowfor future reference. Thisinformation is found on the serial plate located on the inside of the grill door.
NOTE: Use only soap and water to clean serial plate.
Model Number: ______________________________
Serial Number: ______________________________
Purchase Date: ______________________________
Gas Type: __________________________________
1-800Questions?-229-5647
for written inquiries:
Sure Heat Manufacturing
3130 Moon Station Rd
Kennesaw, GA 30144
Register Your Product
The PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to Sure Heat Manufacturing.
Please attach sales receipt here for future reference.
Please complete and mail in the Product
Registration Card included with your grill.
Please retain this manual for future reference
Amana™is a registered trademark of the Maytag Corporation and is used under license to Sure Heat Manufacturing
© 2007 Sure Heat Manufacturing |
|
All rights reserved |
|
3 |
|
General Safety Instructions
Do not use the rotisserie in the rain.
Electrical Grounding Instructions
This appliance (rotisserie motor) is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
Keep any electrical supply cords and the fuel supply hose away from any heated surfaces.
The Spare L.P. Gas Tank Barrier must be installed to prevent storage of spare L.P. Gas Tanks. Failure to comply with these instructions could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
If you smell gas: FOR YOUR SAFETY 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open grill hood.
4. If odor continues, immediately
call your gas supplier and local Fire Dept.
CALIFORNIAPROPOSITION 65 - WARNING: The Burning of gas cooking fuels generates some
by products which are on the list of substances which are known by the State of California to cause cancer or reproductive harm. California law requires businesses to warn customers of potential exposure to such substances. To minimize exposure to these substances, always operate this unit according to the use and care manual, provide
good ventilation when cooking with gas.
This appliance is not intended to be installed in or on recreational vehicles or boats.
NOTE: Do Not operate the main burners and infrared back burner at the same time. This can cause warping of the roll top grill hood.
Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation.
Always have a qualified service technician perform difficult conversions or modifications.
Never attach an unregulated gas line to the appliance. Connection to an unregulated gas line can cause excessive
heat or fire.
TESTED IN ACCORDANCE WITH ANSI
Z21.58b-2002/CSA 1.6b-M02 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR OUTDOOR USE ONLY.
Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the
National Fuel Gas Code No. Z223.1-2002 and the National Electrical Code ANSI/NFPA No. 70-1990
FOR YOUR SAFETY
DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP cylinder not connected for use shall not be stored in
the vicinity of this or any other appliance.
DO NOT try ligh |
reading the |
“LIGHTING INSTRUCTIONS” |
section of this manual. |
FOR OUTDOOR USE ONLY
4
SS 5 Grill Features
1 |
8 |
|
|
2 |
9 |
|
|
3 |
10 |
4 |
11 |
5 |
12 |
|
|
6 |
13 |
7 |
14 |
|
1.Roll top grill hood
2.Rotisserie kit
3.Grilling/cooking surface
4.Side shelf
5.Towel bar/utensil hanger
6.Control knob: Rear infrared burner
7.Control knobs: main burners
8.Hood Handle
9.Warming shelf
10.Rear Infrared burner
11.Side burner
12.Control knob: side burner
13.Electronic igniter: main burners, side burner and rear infrared burner
14.Cart with doors
5
Getting Started
All hardware is shown actual size.
49600206 Caster Assembly Nuts x6
49600113 Self-Tapping Screws x13
49600101 "S" Hooks x3
Two People Required to Assemble Grill
Tools Needed:
Phillips screwdriver Adjustable wrench 1/2” wrench or socket
1/4” nut driver or socket
6
SS 5 Grill Out of Box
2a
12b
2c
5a
5b
|
|
|
2e |
|
|
|
1c |
12c |
|
1a |
|
|
6 |
1b |
|
3e |
|
11a |
|
||||
|
|
|
|
||||
|
|
7 |
|
|
|
||
|
|
11b |
12a |
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
4a
2a. |
Cart Side Left |
12b. |
Main Cooking Grate |
2c. |
Cart Side Right |
5a. |
Cart Door Left |
5b |
Cart Door Right |
2e. |
Cart Back |
1a. |
Cart Base |
12c. |
Bread Warmer Grate |
3e. |
Spare LP Gas Tank Barrier |
4a |
Grill Assembly |
11b |
Drip Pan |
7 |
Side Burner Shelf Assembly |
12a |
Flavor Grid |
11a Condiment Basket
6 Side Shelf Left Assembly
1b Caster Assembly Left (Swivel Wheels)
1c Caster Assembly Right (Swivel Wheesl with lock)
Not Shown: Plastic bag containing:
Igniter Wire
Screw Packages
Side Burner Igniter
Side Burner Knob
Side Burner Bezel
Tank Ring
Open Box Carefully – Lay Out All Parts
7
SS 5 Assembly
STEP ONE
a. Set the cart base on the floor and then lay the caster assembly left on the left side and the caster assembly right on the right side of the cart base. The large hole in the cart base will be towards the rear of the base.
b. Pick up the left side of the cart base and set the caster assembly left in place by inserting the attached bolts through the three (3) holes in the cart base.
c. Pick up the right side of the cart base and set the caster assembly right in place by inserting the attached bolts through the three (3) holes in the cart base.
1a
1b |
1c |
|
8
SS 5 Assembly
STEP TWO
a. Place the cart side left onto the two (2) outer fixed caster assembly bolts, make sure the large flange is toward the front of the cart base.
b. Secure the cart side left in place by hand tightening the caster assembly nuts onto the caster assembly bolts.
c. Place the cart side right onto the two (2) outer swivel caster assembly bolts, make sure the large flange is toward the front of the cart base.
d. Secure the cart side right in place by hand tightening nuts onto the caster assembly bolts.
e. Place the cart back onto the two (2) rear caster assembly bolts.
f. It will be necessary to push the top of the left and right cart sides outward slightly to get the cart back down completely on the cart base.
2f
2a |
2e |
|
2c
2b
2d
9
SS 5 Assembly
STEP THREE
a. Press the cart sides back together making sure that the cart back flange cover the cart side flanges.
b. Attach three (3) self tapping screws through the pre-drilled holes on the cart back into the cart side left. Repeat for cart side right.
c. Fasten two (2) caster assembly nuts onto the back caster assembly bolts.
d. Tighten all six (6) caster assembly nuts with a wrench.
e. Attach the Spare L.P. Gas Tank Barrier by inserting the tabs into the slots in the cart base and then attach the flat end of the
barrier to the pre-drilled hole in the cart back with a self-tapping screw.
The Spare L.P. Gas Tank Barrier must be installed to prevent storage of spare L.P. Gas
Tanks. Failure to comply with these instructions could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
3a |
3a |
|
3b
3b
3d |
|
3e |
3c |
|
|
|
10 |