Alpine CRA-1656SP Installation Manual
demo for registered user.
Installing the Remote Display
Unit
Accessories/Accessoires/Accesorios
x 1
Flush Mount 1
Encastrement 1
Montura empotrable 1
Battery (CR2025) x 1/Pile (CR2025) x 1/Pila (CR2025) x 1
Remote Control Unit Holder x 1/Support de l'unité de télécommande x 1/Soporte de la unidad de control remoto x 1
VelcroTM Tape x 2 pcs./Bande VelcroTM x 2 pièces/Cinta VelcroTM x 2 piezas
Bracket Mount 2
Support de montage 2
Receptáculo de montaje 2
1
x 1
Self-tapping Screw (M2.9 x 20) 3
Vis autotaraudeuse (M2,9 x 20) 3
Tornillo autorroscante (M2,9 x 20) 3
Velcro Tape
Bande Velcro
Cinta Velcro
1
2
3
3
3
2
1
Dashboard
Tableau de bord
Tablero de instrumentos
Dashboard
Tableau de bord
Tablero de instrumentos
x 2
CAUTION:
Do not install the remote display unit near the air-bag of the front
passenger's seat.
• Check the installation location.
• Determine the installation location on the dashboard (in the center,
and flat position).
Installation using Velcro tape (See illust. 1 )
11
1
11
• In case of installing the remote display unit with the Velcro™ tape
attached, cut the tape into two pieces.
1. Without separating the two pieces of Velcro tape, peel off the pa-
per backing on one side and place on the back of the remote
display unit.
Note:
T ak e care not to cover the caution label on the remote displa y unit
with the tape.
2. Make sure the location selected is free from moisture or dirt. Peel
off the backing paper from the other side of the Velcro tape on the
Remote Display.
3. Press the remote display unit onto the installation location. Apply
pressure evenly to the unit to fix securely.
Installation using flush mount 1 (See illust. 2 )
22
2
22
1. After determining the installation location, install the flush mount
1 with screws (M2.9 x 20) 3 .
2. Insert the remote display unit into the flush mount 1 to lock se-
curely.
Note:
To remove the remote display from flush mount, please use thin
plate such as a plastic card to insert to either side of the remote
display carefully. Then the remote display will be released.
Installation using flush mount 1 and bracket mount 2 (See
33
3
33
illust. 3 )
1. Make a hole to match the external dimensions of bracket mount
2 on the installation location of the dashboard.
2. Insert the remote display unit into the flush mount 1 to lock se-
curely.
3. Insert the remote display unit and flush mount 1 combined into
the bracket mount 2 and fix them.
4. Insert the remote display unit, flush mount 1 and bracket mount
2 combined into the hole made at step 1 and fix them.
Installing the Black Box Installation de la boîte noire
< Black Box >
The Black Box can be mounted to any flat surface using the Velcro tape.
Connections Connexions
CAUTION:
Be extremely careful when connecting wires to the vehicle's electrical sys-
tem. Be sure you do not interface leads that are used for factory compo-
nents in the vehicle (like an on-board computer). When making connec-
tions at the fuse box, make sure there is an appropriate value fuse on the
circuit you plan to use. Failure to do so may result in damage to the unit
Loading...