AEG EFC9540X, EFC6540X, EFC7540X User Manual
USER MANUAL
CH910
We were thinking of you when we made this product
electrolux 3
EN |
|
IMPORTANT SAFETY INFORMATION |
4 |
YOUR APPLIANCE |
5 |
OPERATING INSTRUCTIONS |
6 |
MAINTENANCE AND CLEANING |
8 |
SOMETHING NOT WORKING |
11 |
GUARANTEE/CUSTOMER SERVICE |
12 |
GUARANTEE CONDITIONS |
13 |
INSTALLATION INSTRUCTIONS |
15 |
ELECTRICAL CONNECTIONS |
16 |
INSTALLING THE COOKER HOOD |
17 |
EN
Welcome to the world of Electrolux
Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. We promise that it will provide a superior User Experience delivering Ease-of-Mind.
Good luck!
Guide to use the instruction book
The following Symbols will be found in the text to guide you through the instruction book
Safety instructions |
Step by step instructions |
|
|
|
4 electrolux IMPORTANT SAFETY INFORMATION |
|
IMPORTANT SAFETY INFORMATION |
|
These warnings are provided in the interests of your safety. Ensure that you |
|
understand them all before installing or using this appliance. Your safety is of |
|
paramount importance. If you are unsure about any of the meanings of these |
EN |
warnings contact the Customer Care Department. |
Installation
•Any installation work must be undertaken by a qualified electrician or a competent person.
•This hood must be installed in accordance with the installation instructions and all measurements must be adhered to.
•If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.
•The fan motor of this cooker hood incorporates a cut-out device which will operate if the cooker hood is installed below the minimum height recommended under section ‘Clearance Height’, or if the motor becomes overheated. If the cutout device is activated, switch off the fan motor and allow the cooker hood to cool. The cut-out device will reset itself when the fan motor has cooled significantly.
•It is dangerous to alter the specifications or modify this product in any way.
•When installed between adjoining wall cabinets the wall cabinets must not overhang the hob.
•If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type.
•If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.
•The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose.
•Do not install above a cooker with a high level grill.
Child Safety
•This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.
During Use
•This product is for domestic use only.
•Never leave frying pans unattended during use as over-heated fats and oils might catch fire.
•Never do flambé cooking under this cooker hood.
•Do not leave naked flames under the hood.
•This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
Maintenance and Service
•This appliance can be a hazard if the synthetic paper and charcoal filters are not replaced as recommended.
•Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare parts.
YOUR APPLIANCE AND OPERATING INSTRUCTIONS electrolux 5
YOUR APPLIANCE
EN
64
1200
740 |
870 |
60
|
|
|
|
598-698-898-1198 |
|
||||||||
|
|
|
|
|
|
300 |
|
|
|
|
|
||
|
|
|
|
|
|
|
150 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
108 |
|
|
|
|
|
|
|
|
|
260 |
|||
|
|
|
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|||||
490
42
650 min. |
6 electrolux YOUR APPLIANCE AND OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
The cooker hood is designed to extract
unpleasant odours from the kitchen, it will not extract steam.
EN The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button.
|
L |
T1 T2 T3 T4 T5 |
F |
|||
|
|
|
|
|
|
|
Touch |
Basic functions |
|
Indicator lights |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Dual Function |
|
|
|
|
|
|
|
|
|
|
|
|
L |
When briefly pressed it switches the lighting system on/off. |
Touch control unlit |
|
|
Lights off |
|
|
|
|
||||
|
|
|
|
|
||
|
|
|
|
|
|
|
|
When pressed for 2 seconds it starts the lighting system |
Touch control lit |
|
|
Lights on |
|
|
in “courtesy light" mode.The lamps are fed at a reduced |
|
|
|||
|
|
|
|
|
||
|
power of approximately 5W. Such function can be stopp- |
|
|
|
|
|
|
ed by pressing the touch control for 2 seconds or just by |
|
|
|
|
|
|
pressing it shortly in order to return to the normal lighting |
|
|
|
|
|
|
mode. In courtesy light mode the touch control is not lit. |
Touch control unlit |
|
|
Courtesy light on |
|
|
|
|
|
|
||
|
|
|
|
|
|
|
T1 |
When pressed the motor is stopped, regardless of the |
Touch control lit |
|
|
Motor on |
|
|
|
|
|
|
||
|
speed it is set to. |
|
Touch control unlit |
|
|
Motor off |
|
|
|
|
|
|
|
T2 |
When pressed the motor is set to the first speed |
|
Touch control lit |
|||
|
|
|||||
|
|
|
|
|
||
|
|
|
|
|
|
|
T3 |
By a brief pressing the motor is set to the second speed. |
Touch control lit |
|
|
Second speed on |
|
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
Flashing touch control |
|
|
Delay function on |
|
By pressing the touch control for approximately 2 seconds the |
|
|
|
|
|
|
Delay function is enabled, i.e delayed shutdown of the appliance |
|
|
|
|
|
|
ensuring a complete elimination of the residual odours. This |
|
|
|
|
|
|
function can be activated at OFFposition and at 1°, 2° and |
|
|
|
|
|
|
3°speeds. It can be stopped in advance by pressing any of the |
|
|
|
|
|
|
touch controls (T) with the exception of T3. The Delay function |
|
|
|
|
|
|
works according to the following scheme: |
|
|
|
|
|
|
1°speed / OFF = 20 minuets |
|
|
|
|
|
|
2°speed =15 minutes |
|
|
|
|
|
|
3°speed = 5 minutes |
|
|
|
|
|
|
|
|
|
|
|
|
T4 |
When pressed the motor is set to the third speed |
|
Touch control lit |
|||
|
|
|||||
|
|
|
|
|
|
|
T5 |
When pressed the motor is set to the intensive speed |
|
|
|
|
|
|
|
|
|
|
||
|
timed to 5 minutes. At the end of 5 minutes of intensive |
|
|
|
|
|
|
speed the hood starts again at the speed it was set to |
|
Touch control lit |
|||
|
previously. In case the hood is set to the intensive speed |
|
||||
|
|
|
|
|
||
|
directly from OFF-state it will then start from the first |
|
|
|
|
|
|
speed after 5 minutes of intensive speed. |
|
|
|
|
|
|
|
|
|
|
|
|
F |
When pressed for 4 seconds it resets the filter alarm s- |
Touch control lit |
|
|
Metal grease filters saturation |
|
|
|
|
||||
|
ignal indicated by flashing of the touch control T1.This |
|
|
|
alarm.Metal grease filters need to |
|
|
procedure can be carried out only when the motor is |
|
|
|
be washed.The alarm starts up after |
|
|
stopped. |
|
|
|
|
100 working hours. |
|
|
|
|
|
|
|
|
|
|
Flashing touch control |
|
|
Charcoal odour filter saturaion |
|
|
|
|
|
|
alarm.Charcoal filter has to be |
|
|
|
|
|
|
replaced and metal grease filters |
|
|
|
|
|
|
washed.The alarm starts up after |
|
|
|
|
|
|
200 working hours.(Activation; check |
|
|
|
|
|
|
the paragraph "Odour filter") |
|
|
|
|
|
|
|
To Operate
Select the required fan speed and light if required.
Recirculation
In the recirculation mode the contaminated air enters the cooker hood through the grease filters. The air is cleaned by passing through the charcoal filters before being passed back into the kitchen through the grilles in either side of the chimney stack.
Extraction
In the extraction mode the contaminated air enters the cooker hood passing through the grease filters and is passed out through the ducting into the atmosphere.
To obtain the best performance when cooking it is advisable to switch the cooker hood on for a few minutes before you start cooking and leave it running for about 15 minutes after finishing.
When used in the ducting mode the charcoal filters are not required.
Never do flambé cooking under this cooker hood.
Never leave frying pans unattended during use, as over-heated fats and oils can catch fire.
Do not leave naked flames under the cooker hood.
Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood simultaneously.
electrolux 7
EN
8 electrolux MAINTENANCE AND CLEANING
MAINTENANCE AND CLEANING
|
Before carrying out any maintenance |
|
or cleaning isolate the cooker hood |
EN |
from the mains supply. |
|
The cooker hood must be kept clean, |
|
as a build up of grease or fat can be a |
|
fire hazard. |
|
External Cleaning |
|
Wipe the cooker hood frequently with |
|
warm soapy water using a mild detergent. |
Never use scouring pads or abrasive cleaners.
Never use excessive amounts of water when cleaning particularly around the control panel.
Metal Grease Filters
The filters are washable and must be cleaned when the F-Touch control lights up or at least every 2 months of operation, or more frequently for particularly heavy usage.
Remove the metal grease filters one at a time by:
Releasing the catches on the filters, the filters can be removed.
The metal grease filters should be washed, by hand, in mild soapy water or in a dishwasher. Allow to dry completely before replacing.
Alarm signal reset
Stop the motor.
Press the F-Touch control for at least 4 seconds until the T1Touch control flashes.
Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal filters absorb smells and unwanted odours.
Enabling the alarm signal
• In Recirculation Version Hoods, the Filter saturation Alarm must be enabled at the time of installation or later.
•Switch off the lights and the motor.
•Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off.
•Restore the connection, pressing and holding T2.
•Release the touch control, touch controls L, T2 and F will light up normally.
•Within 3 seconds press the touch control F until the key itself flashes to confirm as follows:
•2 flashes – Charcoal odour Filter saturation Alarm ENABLED
•1 flash - Charcoal odour Filter saturation Alarm DISABLED
MAINTENANCE AND CLEANING electrolux 9 |
|
This filter cannot be washed or |
|
regenerated, and must be replaced when |
|
the F touch control starts to flash, or at |
|
least once every 4 months. The alarm is |
EN |
only triggered when the motor is on. |
To Remove/Replace the
Charcoal Filters
•Remove the metal grease filters
•Remove the saturated activated carbon filter by releasing the fixing hooks
•Fit the new filter by hooking it into its seating
•Replace the metal grease filters.
This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended.
Alarm signal reset
•Stop the motor.
•Press the touch control F for at least 4 seconds, until the touch control T1 flashes.
Loading...