Actron Starter Switch User Manual
HEAVY DUTY STARTER SWITCH
(WITH HOT CIRCUIT INDICATOR LIGHT)
SAFETY GUIDELINES
Always wear eye protection.
Always operate vehicle in a ventilated area.
Always keep people, tools, and test equipment away from moving and hot engine parts.
Always make sure vehicle is in Park (automatic transmission) or Neutral (manual transmission) and parking brake is set.
Always block drive wheels on vehicle.
Always keep a fire extinguisher for gasoline/electrical/chemical fires near by.
Always turn ignition key OFF when connecting or disconnecting electrical components, unless otherwise instructed.
Always keep away from vehicle fans.
Always follow vehicle manufacturers warnings, cautions, and service procedures.
Never lay tools on vehicle battery.
Never smoke or have open flames near vehicle.
Never leave vehicle unattended while running tests.
USING STARTER SWITCH
The Heavy Duty Starter Switch With Hot Circuit Indicator Light is used to remotely operate starter on vehicles equipped
with a starter solenoid. The Starter Switch has an added feature of a red light that glows when the starter switch is
connected to a hot circuit and goes out when the button is pressed. This is a helpful indicator that tells when the Starter
Switch is ready to use.
1. Place vehicle in Park (automatic transmission) or Neutral (manual transmission), set parking brake and block drive
wheels.
!
CAUTION
2. Follow vehicle service manual to disable ignition system.
!
CAUTION
!
CAUTION
3. Connect Starter Switch as stated in vehicle service manual.
4. Turn vehicle ignition switch to the ON position.
WARNING
!
5. Press START button on Starter Switch to crank engine.
IMPORTANT
To avoid damage to ignition system circuits or other circuits related to or connected to ignition
wiring, follow all vehicle service manual instructions for disabling ignition system.
Use EXTREME CAUTION when connecting starter switch. Battery voltage is present at
solenoid or relay and damage or injury can occur from shorting the leads.
Follow all vehicle service manual instructions on how and where to connect Remote Starter
Switch. ONLY connect Starter Switch to starter relay or solenoid. If switch is connected
improperly, wires may become warm. If wires become warm, do not continue to push start
button, as damage to Starter Switch may occur.
MAKE SURE HANDS AND STARTER SWITCH WIRES ARE AWAY FROM ALL BELTS AND
FANS.
After disconnecting Starter Switch, reconnect all leads and connectors that were disconnected to disable
the ignition system.
FULL ONE (1) YEAR LIMITED WARRANTY
Actron Manufacturing Company (Actron), warrants to the original purchaser that this product will be free from defects in
materials and workmanship for a period of one (1) year from the date of original purchase. Any unit that fails within this period
will be replaced or repaired at Actrons discretion without charge. If you need to return product, please follow the instructions
below. This warranty does not apply to damages (intentional or accidental), alterations or improper or unreasonable use.
DISCLAIMER OF WARRANTY
ACTRON DISCLAIMS ALL EXPRESS WARRANTIES EXCEPT THOSE THAT APPEAR ABOVE. FURTHER, ACTRON
MANUFACTURING CO. DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OF THE GOODS OR FITNESS
OF THE GOODS FOR ANY PURPOSE. (TO THE EXTENT ALLOWED BY LAW, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR OF FITNESS APPLICABLE TO ANY PRODUCT IS SUBJECT TO ALL THE TERMS AND
CONDITIONS OF THIS LIMITED WARRANTY. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS, SO THIS LIMITATION MAY NOT APPLY TO A SPECIFIC BUYER.)
LIMITATION OF REMEDIES
IN NO CASE SHALL ACTRON MANUFACTURING CO. BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES BASED UPON ANY LEGAL THEORY INCLUDING, BUT NOT LIMITED TO, DAMAGES FOR LOST PROFITS
AND/OR INJURY TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, SO THIS LIMITATION OR EXCLUSION MAY NOT APPLY TO A SPECIFIC BUYER.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
TO USE YOUR WARRANTY
If you need to return the unit, please follow this procedure:
1. Call Actron Tech Support at (800) 228-7667. Our Technical Support Representatives are trained to assist you.
2. Proof of purchase is required for all warranty claims. For this reason we ask that you retain your sales receipt.
3. In the event that product needs to be returned, you will be given a Return Material Authorization (RMA) number.
4. If possible, return the product in its original package with cables and accessories.
5. Print the RMA number and your return address on the outside of the package and send to the address provided by
your Technical Support Representative.
6. You will be responsible for shipping charges in the event that your repair is not covered by warranty.
©2004 Actron Manufacturing Co. All Rights Reserved.
0002-000-2640
Loading...