Thank you for using the Mobile Cam.
To guarantee the Mobile Cam is always in best condition,
please read this manual carefully and keep for further use.
The pictures and contents in this manual are for your
reference only. They might not be completely identical to your
Mobile Cam.
MF68
5
MF68
1 Warning and precautions
1.1 Precautions
The Mobile Cam contains delicate electronic circuitry and battery systems. You should
treat it with care and pay particular attention to the following points:
u Do not allow the Mobile Cam, battery or accessories to come into contact with liquids
or moisture at any time. Do not immerse in any liquid.
u The Mobile Cam can’t do the video call over 3 hours continuously. If the time is over 3
hours, it will shut off automatically.
u Do not place the Mobile Cam alongside computer disks, credit cards, travel cards or
other magnetic media. The information contained on disks or cards may be affected
by the Mobile Cam.
u Do not leave the Mobile Cam in places where the temperature could exceed 60°C –
e.g. on a car’s dashboard or a windowsill or behind glass in direct sunlight.
u Do not dispose the Mobile Cam in a fire. This equipment is fitted with an internal
battery that can only be replaced by a qualified service engineer so used batteries
must be safely disposed at a recycling point.
u Do not attempt to dismantle the Mobile Cam or any of its accessories.
6
MF68
u The Mobile Cam may become warm during normal use. The Mobile Cam may also
become warm while the battery is being charged.
u Use a damp or anti-static cloth to clean the Mobile Cam. Do not use chemical or
abrasive cleaners as these could damage the case.
1.2Aircraft safety
u Onboard an aircraft, please turn off your Mobile Cam before take-off. In order to
protect aircraft communications systems from interference, do not use the Mobile
Cam while in flight. Using the Mobile Cam before take-off requires aircrew permission,
according to safety regulations.
u Do not use the Mobile Cam on the ground at an airport without permission from
ground staff.
1.3 Precautions for medical Mobile Cams and
facilities
u When using your Mobile Cam near pacemakers, please: Always keep the Mobile
Cam more than 8 inches (20 centimeters) from the pacemaker while the Mobile Cam
is switched on.
u If you use any other personal medical device, please consult the device manufacturer
to determine if it is adequately shielded from RF energy.
7
MF68
u If on premises with special demands, such as hospital or healthcare facilities, please
pay attention to the restriction of the use of the Mobile Cams. Switch off your Mobile
Cam if required.
1.4General safety
u Keep the Mobile Cam out of the reach of small children. The Mobile Cam may cause
injury if used as a toy.
u The operation of some medical electronic items, such as hearing aids and
pacemakers, may be affected if the Mobile Cam is used in close proximity. Observe
any related signs and manufacturer recommendations.
1.5Road safety
u Switch off your Mobile Cam at refueling points, such as petrol stations, even if you
are not refueling your own car.
u Do not store or carry flammable or explosive materials in the same compartment as a
radio transmitter.
u Electronic vehicle systems, such as anti-lock brakes, speed control and fuel injection
systems are not normally affected by radio transmissions. The manufacturer of such
equipment can advise if it is adequately shielded from radio transmissions. If you
suspect vehicle problems caused by radio transmissions, consult your dealer and do
8
MF68
not switch on the Mobile Cam until it has been checked by qualified and approved
installers.
1.6Vehicles equipped with an air bag
u An air bag inflates with great force. Do not place objects, including installed or
portable wireless equipment in the area above the air bag or in the air bag
deployment area. If in-vehicle wireless equipment is improperly installed and the air
bag inflates, serious injury could result.
1.7Third-party equipment
u The use of third-party equipment, cables or accessories, not provided or authorized
by ZTE, may invalidate the warranty of your Mobile Cam and also adversely affect
the Mobile Cam’s operation.
1.8Radio frequency energy
u Your Mobile Cam is a low-power radio transmitter and receiver. When it is switched
on, it intermittently receives and transmits radio frequency (RF) energy (radio waves).
The system that handles the call also controls the power level at which the Mobile
Cam transmits.
u The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20cm from all persons.
9
MF68
u This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1)This device may not cause harmful interference,
and(2)this device must accept any interference received, including interference that
may cause undesired operation.
u NOTE:The phone has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
The phone generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If the phone does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
—Reorient or relocate the receiving antenna.
10
MF68
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
u We,ZTE Corporation,declared that the product is installed with battery separately in
the box.The FCC ID label is placed on the mobile cam clearly visible to all persons at
the time of purchase.
2 Getting to know your Mobile Cam
2.1 Overview
Empowered by the latest 3G technology, Mobile Cam is capable of receiving video phone
calls automatically. Users can dial the Mobile Cam from any WCDMA handset supporting
video phone calls, and view the picture with sound captured by the Mobile Cam anytime,
anywhere. The Mobile Cam supports video call, but doesn’t support voice call.
Continuous standby time 120-200 hours
Recording time (in sunlight environment) 7-12 hours
Recording time (in infrared environment) 3-5 hours
Video communication time (in sunlight environment) 2-3 hours
Video communication time (in infrared environment) 1.6-2.6 hours
Charging time 5 hours
2.3Environment requirement
The Mobile Cam can be used indoors or half-outdoors – e.g. inside an automobile.
Environment parameter details are as follow:
Working temperature range: -10℃~45℃
12
Relative humidity: 5%~95%( without dew)
Power supply: 220V supply, integrated spare battery
This mobile camera is only used in WCDMA network.
2.4 Your Mobile Cam
Front view of your mobile cam
MF68
13
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.