Wall Mount Bracket Kit
1.Slide the two bracket
mounting tabs into
the receptacles on
the bottom of the
cradle as shown.
Ensure the screw
hole in the bracket
flange aligns with the
screw hole in the
cradle.
2.Screw the .5” Phillips
screw (supplied) into the
bracket flange and
tighten until the cradle is
securely attached to the
bracket.
3.Use four screws to mount
the bracket to a wall.
Ensure to use additional
wall mounting hardware,
as needed, for safe
mounting to the wall type.
Mounting tabs
Flange
Installation Guide
for the SAC5000-8000CR Cradle
Introduction
This guide provides instructions for mounting the KT-102376-01R bracket for use with
one SAC5000-8000CR (eight-slot ) battery charger.
NOTE Refer to the CA50 Client/UCA Server Developer Guide (p/n 72E-93914-xx)
for detailed product information.
Included Hardware
• One KT-102376-01R Mounting Bracket
• One black .5” Phillips round head, thread cutting screw.
Mounting Instructions
WARNING! Use the screw supplied in this kit to attach the cradle to the mounting
bracket only. This screw is not intended for mounting the bracket on a
wall.
For safety and stability, it is recommended th at you use the a ppropriat e
wall mounting hardware for installation. For saf e mounting, it is essential
to use wall anchors appropriate to the wall type (i.e. plaster, drywall,
concrete, etc.). Mount to wood studs whenever possible.
2 KT-102376-01R Wall Mount Kit
72-102669-02 Revision A — February 2015
© 2015 Symbol Technologies, Inc.
Zebra reserves the right to make changes to any product to improve reliability, function, or design.
Zebra does not assume any product liability arising out of, or in connection with, the application or
use of any product, circuit, or application described herein.
No license is granted, either expressly or by implication, estoppel, or otherwise under any patent right
or patent, covering or relating to any combination, system, apparatus, machine, material, method, or
process in which Zebra products might be used. An implied license exists only for equipment, circuits,
and subsystems contained in Zebra products.
Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The Symbol logo is a
registered trademark of Symbol Technologies, Inc., a Zebra Technologies company.
Warranty
For the complete Zebra hardware product warranty statement, go to: http://www.zebra.com/warranty.
Refer to the CA50 Client/UCA Server Developer Guide (p/n 72E-93914-xx) for detailed product
information. For the latest guide, visit: http://www.zebra.com/support.
Zebra Technologies Corpor ation
Lincolnshire, IL U.S.A.
http://www.zebra.com
Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The
Symbol logo is a registered trademark of Symbol Technologies, Inc., a Zebra
Technologies company.
© 2015 Symbol Technologies, Inc.
Loading...