Yamaha DTX560K, DTX530K Assembly Manual
Digital Musical Instruments Division
©2011 Yamaha Cor poration
WZ78140 106YJ-A0
DTX560K/DTX530K
Assembly Manual
EN
The DTX560K and DTX530K feature the same Drum units as those of the DTX700K, with the following exceptions:
- Unlike the DTX700K, both the DTX560K and DTX530K have the Drum Trigger Module DTX500.
- Unlike the DTX700K, the DTX530K has the TP65, instead of the XP70.
Accordingly, you should refer to the DTX700K Assembly Manual for details on how to assemble the pads to the rack.
The following description covers assembly of the DTX500 Drum Trigger Module only.
Mounting the drum trigger module
Attach the module stand (provided) to the
1.
underside of the drum trigger module using the
module stand fastening screws.
Module stand
fastening screws
Front of
Module
Module stand
Drum trigger module
(back side)
Place the module stand inside the holder clamp
2.
and tighten the clamp bolt to secure in position.
Drum trigger
module
+
module stand
Insert
Holder Clamp
Clamp bolt
Connect the pads to the drum trigger module
Insert the 9-channel snake cable’s straight plugs into the drum trigger module’s trigger input jacks ([qSNARE] to
[oKICK/!0] and [HI-HAT CONTROL]).
NOTE
If you are using the standard setup, the stickers on each of the snake cable’s plugs will indicate the name of the
corresponding pad.
Drum trigger module’s rear panel
1 2 3 4
5 6 7 8 9
9-channel snake cable
Straight plugs
Straight plug names
(as shown on stickers)
SNARE
TOM1
TOM2
TOM3
RIDE
CRASH
HI-HAT
KICK
HH CON
DTX500 jack names
1: qSNARE
2: wTOM1/
3: eTOM2/
4: rTOM3/
5: tRIDE
6: yCRASH
7: uHI-HAT
8: iKICK/
9: HIHAT CONTROL
!0
!1
!2
o
L-shaped plugs
HH CON HI-HAT CRASH KICK SNARE TOM1 TOM2 TOM3 RIDE
Loading...